HSHengxiang Shen

Hengxiang Shen

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Hengxiang Shen has a total of 18 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Dynamic mechanical behavior and constitutive relationship of rubber fiber concrete after high temperature

    by Hengxiang Shen, Hongguang Ji, Xiang Peng, Zhuhua Tian, Guangning Su

    To investigate the effect of temperature on the dynamic mechanical properties of rubber–polypropylene fiber concrete (RPFC), dynamic mechanical parameters and energy parameters of RPFC at different temperatures were obtained using the Split Hopkinson Pressure Bar (SHPB) test. Subsequently, the particle size distribution and fractal dimension of RPFC were calculated through a standard square-hole sieving test, and the relationship between the energy dissipation per unit volume and the fractal dimension was analyzed. Finally, by introducing a temperature damage factor and a strain damage factor, a dynamic damage constitutive model of RPFC considering both temperature and strain damage was established. The results show that under the same impact pressure, the dynamic peak strength of RPFC first decreases and then increases with rising treatment temperature, with a maximum increase of 24.3% and a maximum decrease of 16.5%. The dynamic elastic modulus shows a decreasing trend, with a maximum reduction of up to 14.8%. Due to the anchoring effect of polypropylene fibers within the concrete matrix, the failure energy per unit volume first increases and then decreases. As the unit failure energy increases, the increment of the fractal dimension at 100 °C is greater than that at 25 °C. At 300 °C, the high-temperature melting of polypropylene fibers generates steam, which helps relieve internal pore pressure caused by high temperatures, thereby reducing internal damage in RPFC. The increase in fractal dimension under this condition is gradual and approximately linear. The fitting of the experimental stress–strain curves indicates that the dynamic constitutive model incorporating thermal and strain damage is applicable to rubber and polypropylene fiber-reinforced concrete.


  • Open Access

    Analysis of Temporal and Spatial Characteristics and Influencing Factors of Construction Deformation of Super-Large Deep Foundation Pit in Thick Sand Stratum

    by Heng-Xiang Shen, Ying-Hui Yang, Peng Xiang, Hong-Guang Ji, Wei-Dong Liu, Hong-Jun Guo

    To the aim of this paper is to study the structural and environmental deformation characteristics caused by the excavation of a very large deep foundation pit in the sandy soil area of Beijing. This paper is based on numerical simulation and field monitoring results and these results are compared with the deformation data of a soft soil foundation pit in the Shanghai area. The results show that the influence of the environment surrounding the super-large deep foundation pit project studied in this paper is obviously too great. With the progress of construction, the deformation rate and deformation amount of the column at the side of the foundation pit are obviously higher than that of the column in the middle area. Due to the “hysteresis” of stress transfer in the sand, the settlement of the roof of the north wall is delayed and the deformation range is smaller than that of the south wall. Compared with the conventional foundation pit, the influence area of the surrounding surface is larger, reaching 4 He (He is the depth of the foundation pit). Δvmax (the maximum surface settlement) is between 0.2~2.3% He, and the relationship between δvmax = 1.43% Vwm. Through orthogonal experiments and numerical simulation, it is concluded that the deformation of foundation pit structure and its surrounding environment is more sensitive to excavation unloading, precipitation amplitude, and column spacing. It is also concluded that the strong, medium, and weak influence areas of the bottom uplift after foundation pit construction are (0~0.07) × L, (0.07~0.14) × L, and (0.14~0.5) × L, respectively (L is the width of foundation pit). When the embedment ratio is between 1.8~2.4, the displacement mode of the parapet structure is T mode; when the embedment ratio is between 2.4~3.4, the displacement mode of the parapet structure is RB mode.


  • Open Access

    Research on the Distribution Law of Surrounding Rock Temperature Field in High Geothermal Metal Mines and Construction of Cloud Monitoring System

    by Tianyu Li, Peng Xiang, Hongguang Ji, Hengxiang Shen, Zhen Fu, Qixing Feng

    With the increasing demand for mineral resources, mining operations are gradually moving into deeper levels, leading to a rise in the severity of the high-temperature thermal hazard caused by geothermal heat in mines. To understand the distribution and characteristics of the temperature field in the surrounding rock of metal mines, this study derived a non-steady-state heat conduction differential equation suitable for the surrounding rock of underground metal mines based on the thermal property changes of rocks at high temperatures, thereby obtaining the distribution characteristics of the thermal insulation ring in the surrounding rock. However, the monitoring technology of the underground rock temperature field is constrained by factors such as long-term power supply of equipment and complex data collection. Therefore, based on high-precision temperature acquisition devices, this study developed and constructed a cloud monitoring system for the temperature field of the surrounding rock, realizing long-term online temperature field monitoring of the 930 m and 945 m horizontal underground roadway in the West Mountain mining area of Sanshandao. The monitoring data indicate that the system has stable data transmission and smooth operation, achieving remote long-term data collection and transmission. This has improved the efficiency of monitoring the temperature field of surrounding rocks in mines, providing a basis for the risk assessment of thermal environmental conditions in deep high-temperature areas of metal mines and the control of the thermal hazard in deep underground engineering.


  • Open Access

    Stability and Distribution of Rock Slope under Asymmetric Excavation

    by Ming Li, Peng Xiang, Hengxiang Shen, Hongguang Ji, Daolu Quan, Wensheng Wang

    The asymmetric excavation unloading activity of a rock slope with a fault has an important influence on the stability of the slope and the division of the surrounding surface influence area. Based on the engineering background of the West Open-Pit Mine in Fushun City, orthogonal testing, K-means clustering, range analysis, and variance analysis were used to study the linkage mechanism of the asymmetric excavation unloading action and the weak structure in the rock slope, as well as their effects on slope stability and the influence area. This analysis showed that the significant factors affecting the stability zones of the north and south slopes were the excavation inclination angles of the opposite slopes. When the excavation inclination of the north slope increased by 10 degrees, the safety factors decreased by 25.9% and 16.6%. When the excavation inclination of the south slope increased by 10 degrees, the safety factors decreased by 13.7% and 1.9%. A second significant factor was the excavation depth. The occurrence of faults in the slope was the main factor affecting the range of slope instability. In order to ensure production safety, the excavation inclination angle of a slope with a fault should be limited to no more than 40°, and the excavation depth of an unstable area with two slopes should be designed to be no more than 450 m. The influence of asymmetric excavation unloading on the stability of a rock slope with a fault structure is expounded. This also provides a theoretical basis for controlling slope stability and influence areas in large-scale open-pit mining projects.