MJMichael J. Johnson

Michael J. Johnson

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Michael J. Johnson has a total of 20 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Flash Synthesis of High-Performance Sub-Micron Low-Disorder NCA Cathode Single Crystals

    by Thomas E Ashton, Shutao Wang, Michael J Johnson, Callum J Chisnall, Matthew G Tucker, Helen Playford, Alexander J E Rettie, Jiacheng Wang, Yang Xu, Jawwad A Darr

    A rapid solid-state Flash Heat and Quench (FHQ) synthesis approach has been used to facilitate the rapid formation of layered NCA Li-ion cathodes with low structural defects. NCA materials prepared by FHQ revealed impressive gravimetric capacity at C/10 and 10C discharge rates (195 and 150 mAh g−1, respectively) after a few minutes of heating a co-precipitate mixture with LiOH, effectively an >95% reduction in energy needed for heat-treatment versus conventional solid state synthesis routes. Combined X-Ray Diffraction, Neutron Total Scattering with Pair-Distribution-Function analysis, and X-ray Absorption Spectroscopy for a range of heat-treated samples were used to identify the point at which Ni2+−Li+ anti-site defects were minimised in these materials, which was critical to their electrochemical performance.

  • Open Access

    Enabling ionic transport in Li3AlP2 the roles of defects and disorder

    by Ji Hu, Alexander G. Squires, Jedrzej Kondek, Michael J. Johnson, Arthur B. Youd, Pooja Vadhva, Partha Paul, Philip J. Withers, Marco Di Michiel, Dean S. Keeble, et al.

    Lithium phosphides are an emerging class of Li+ ion conductors for solid state battery applications. Despite potentially favorable characteristics as a solid electrolyte, stoichiometric crystalline Li3AlP2 has been reported to be an ionic insulator. Using a combined computational and experimental approach, we investigate the underlying reasons for this and show that ion transport can be induced via defects and structural disorder in this material. Lithium vacancies are shown to promote diffusion, and a low barrier to Li+ hopping of 0.2-0.3 eV is revealed by both simulations and experiment. However, polycrystalline pellets exhibit low ionic conductivity (≈10−8 S cm−1) at room temperature, attributed to crystalline anisotropy and the presence of resistive grain boundaries. These aspects can be overcome in nanocrystalline Li3AlP2, where ionic conductivity values approaching 10−6 S cm−1 and low electronic conductivities are achieved. This approach, leveraging both defects and structural disorder, should have relevance to the discovery of new, or previously overlooked, ion conducting materials.