Vikram Rathee
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Vikram Rathee has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Daniel L. Blair
Department of Physics Georgetown University 37 th and O Streets NW 20057 Washington DC U.S.A
3 shared publications - Jeffrey S. Urbach
Department of Physics, Georgetown University, 3700 O St, NW Washington, DC 20057, USA
3 shared publications - Ajay Kumar Sood
Indian Institute of Science, Bangalore
1 shared publication Daniel L. Blair
Department of Physics and Institute for Soft Matter Synthesis and Metrology, Georgetown University, Washington, D.C. 20057, USA
1 shared publicationJeffrey S. Urbach
Department of Physics and Institute for Soft Matter Synthesis and Metrology, Georgetown University, Washington, D.C. 20057, USA
1 shared publication- Rajesh Ganapathy
Chemistry and Physics of Materials Unit, Jawaharlal Nehru Centre for Advanced Scientific Research, Bengaluru, India;
1 shared publication
Latest Publications
- 6 April 2020
- Published by American Physical Society (APS) in Physical Review E
- Vol. 101 (4) , 040601
Role of particle orientational order during shear thickening in suspensions of colloidal rods
Rheology of dense anisotropic colloidal suspensions often exhibits unsteady flow at constant imposed shear stress and/or shear rate. Using simultaneous high-resolution confocal microscopy and rheology, we find that the temporal behavior arises due to a strong coupling between shear flow and particle orientation. At smaller applied stresses, the orientation of rods fluctuates around the flow direction. A transition to an intermittent disordered state is observed at higher stresses when the angle between the flow and the rod orientation reaches a critical value. This disordered state is associated with transient drop in shear rate and an increase in viscosity. Simultaneous visualization of boundary stresses and orientation shows that the disordered regions lead to heterogeneous stresses and positive normal forces at the boundary, indicating the formation of systems spanning disordered particle contact networks.
- 6 April 2020
- Published by American Physical Society (APS) in Physical Review E
- Vol. 101 (4) , 040601
Role of particle orientational order during shear thickening in suspensions of colloidal rods
Rheology of dense anisotropic colloidal suspensions often exhibits unsteady flow at constant imposed shear stress and/or shear rate. Using simultaneous high-resolution confocal microscopy and rheology, we find that the temporal behavior arises due to a strong coupling between shear flow and particle orientation. At smaller applied stresses, the orientation of rods fluctuates around the flow direction. A transition to an intermittent disordered state is observed at higher stresses when the angle between the flow and the rod orientation reaches a critical value. This disordered state is associated with transient drop in shear rate and an increase in viscosity. Simultaneous visualization of boundary stresses and orientation shows that the disordered regions lead to heterogeneous stresses and positive normal forces at the boundary, indicating the formation of systems spanning disordered particle contact networks.
- Open Access
- 1 March 2020
- Published by Society of Rheology in Journal of Rheology
- Vol. 64 (2) , 299-308
Localized transient jamming in discontinuous shear thickening
We report direct measurements of spatially resolved surface stresses over the entire surface of a dense suspension during discontinuous shear thickening (DST) using boundary stress microscopy (BSM) in a parallel-plate rheometer. We find that large fluctuations in the bulk rheological response at the onset of DST are the result of localized transitions to a state with very high stress, consistent with a fully jammed solid that makes direct contact with the shearing boundaries. This jammed solidlike phase (SLP) is rapidly fractured, producing two separate SLPs that propagate in opposite directions. By comparing the speed of propagation of the SLPs with the motion of the confining plates, we deduce that one remains in contact with the bottom boundary and the other remains in contact with the top. These regions grow, bifurcate, and eventually interact and decay in a complex manner that depends on the measurement conditions (constant shear rate vs constant stress). In a constant applied stress mode, BSM directly reveals dramatic stress fluctuations that are completely missed in the standard bulk rheology.
- 1 March 2020
- Published by Society of Rheology in Journal of Rheology
- Vol. 64 (2) , 299-308
Open AccessLocalized transient jamming in discontinuous shear thickening
We report direct measurements of spatially resolved surface stresses over the entire surface of a dense suspension during discontinuous shear thickening (DST) using boundary stress microscopy (BSM) in a parallel-plate rheometer. We find that large fluctuations in the bulk rheological response at the onset of DST are the result of localized transitions to a state with very high stress, consistent with a fully jammed solid that makes direct contact with the shearing boundaries. This jammed solidlike phase (SLP) is rapidly fractured, producing two separate SLPs that propagate in opposite directions. By comparing the speed of propagation of the SLPs with the motion of the confining plates, we deduce that one remains in contact with the bottom boundary and the other remains in contact with the top. These regions grow, bifurcate, and eventually interact and decay in a complex manner that depends on the measurement conditions (constant shear rate vs constant stress). In a constant applied stress mode, BSM directly reveals dramatic stress fluctuations that are completely missed in the standard bulk rheology.
- Open Access
Localized Transient Jamming in Discontinuous Shear Thickening
We report direct measurements of spatially resolved surface stresses over the entire surface of a dense suspension during discontinuous shear thickening (DST) using Boundary Stress Microscopy (BSM) in a parallel-plate rheometer. We find that large fluctuations in the bulk rheological response at the onset of DST are the result of localized transitions to a state with very high stress, consistent with a fully jammed solid that makes direct contact with the shearing boundaries. That jammed solid like phase (SLP) is rapidly fractured, producing two separate SLPs that propagate in opposite directions. By comparing the speed of propagation of the SLPs with the motion of the confining plates, we deduce that one remains in contact with the bottom boundary, and another remains in contact with the top. These regions grow, bifurcate, and eventually interact and decay in a complex manner that depends on the measurement conditions (constant shear rate vs constant stress). In constant applied stress mode, BSM directly reveals dramatic stress fluctuations that are completely missed in standard bulk rheology.
Open AccessLocalized Transient Jamming in Discontinuous Shear Thickening
We report direct measurements of spatially resolved surface stresses over the entire surface of a dense suspension during discontinuous shear thickening (DST) using Boundary Stress Microscopy (BSM) in a parallel-plate rheometer. We find that large fluctuations in the bulk rheological response at the onset of DST are the result of localized transitions to a state with very high stress, consistent with a fully jammed solid that makes direct contact with the shearing boundaries. That jammed solid like phase (SLP) is rapidly fractured, producing two separate SLPs that propagate in opposite directions. By comparing the speed of propagation of the SLPs with the motion of the confining plates, we deduce that one remains in contact with the bottom boundary, and another remains in contact with the top. These regions grow, bifurcate, and eventually interact and decay in a complex manner that depends on the measurement conditions (constant shear rate vs constant stress). In constant applied stress mode, BSM directly reveals dramatic stress fluctuations that are completely missed in standard bulk rheology.
- Open Access
Localized Stress Fluctuations Drive Shear Thickening in Dense Suspensions
The mechanical response of solid particles dispersed in a Newtonian fluid exhibits a wide range of nonlinear phenomena including a dramatic increase in the viscosity \cite{1-3} with increasing stress. If the volume fraction of the solid phase is moderately high, the suspension will undergo continuous shear thickening (CST), where the suspension viscosity increases smoothly with applied shear stress; at still higher volume fractions the suspension can display discontinuous shear thickening (DST), where the viscosity changes abruptly over several orders of magnitude upon increasing applied stress. Proposed models to explain this phenomenon are based in two distinct types of particle interactions, hydrodynamic\cite{2,4,5} and frictional\cite{6-10}. In both cases, the increase in the bulk viscosity is attributed to some form of localized clustering\cite{11,12}. However, the physical properties and dynamical behavior of these heterogeneities remains unclear. Here we show that continuous shear thickening originates from dynamic localized well defined regions of particles with a high viscosity that increases rapidly with concentration. Furthermore, we find that the spatial extent of these regions is largely determined by the distance between the shearing surfaces. Our results demonstrate that continuous shear thickening arises from increasingly frequent localized discontinuous transitions between coexisting low and high viscosity Newtonian fluid phases. Our results provide a critical physical link between the microscopic dynamical processes that determine particle interactions and bulk rheological response of shear thickened fluids.
Open AccessLocalized Stress Fluctuations Drive Shear Thickening in Dense Suspensions
The mechanical response of solid particles dispersed in a Newtonian fluid exhibits a wide range of nonlinear phenomena including a dramatic increase in the viscosity \cite{1-3} with increasing stress. If the volume fraction of the solid phase is moderately high, the suspension will undergo continuous shear thickening (CST), where the suspension viscosity increases smoothly with applied shear stress; at still higher volume fractions the suspension can display discontinuous shear thickening (DST), where the viscosity changes abruptly over several orders of magnitude upon increasing applied stress. Proposed models to explain this phenomenon are based in two distinct types of particle interactions, hydrodynamic\cite{2,4,5} and frictional\cite{6-10}. In both cases, the increase in the bulk viscosity is attributed to some form of localized clustering\cite{11,12}. However, the physical properties and dynamical behavior of these heterogeneities remains unclear. Here we show that continuous shear thickening originates from dynamic localized well defined regions of particles with a high viscosity that increases rapidly with concentration. Furthermore, we find that the spatial extent of these regions is largely determined by the distance between the shearing surfaces. Our results demonstrate that continuous shear thickening arises from increasingly frequent localized discontinuous transitions between coexisting low and high viscosity Newtonian fluid phases. Our results provide a critical physical link between the microscopic dynamical processes that determine particle interactions and bulk rheological response of shear thickened fluids.