Lu Chen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Lu Chen has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
Chuan Shen
National Key Laboratory of Infrared Detection Technologies, Shanghai Institute of Technical Physics, Chinese Academy of Science 1 , No. 500 Yu Tian Road, Shanghai 200083, China
2 shared publicationsLiao Yang
National Key Laboratory of Infrared Detection Technologies, Shanghai Institute of Technical Physics, Chinese Academy of Science 1 , No. 500 Yu Tian Road, Shanghai 200083, China
2 shared publications- Baile Chen
ShanghaiTech University
1 shared publication - Chun Lin
National Key Laboratory of Infrared Detection Technologies, Shanghai Institute of Technical Physics, Chinese Academy of Sciences, Shanghai 200083, China
1 shared publication Dan Yang
Key Laboratory of Infrared Imaging Materials and Detectors, Shanghai Institute of Technical Physics, Chinese Academy of Sciences, Shanghai, China
1 shared publication- Hao Xie
National Key Laboratory of Infrared Detection Technologies, Shanghai Institute of Technical Physics, Chinese Academy of Science 1 , No. 500 Yu Tian Road, Shanghai 200083, China
1 shared publication
Latest Publications
- Open Access
- 27 May 2024
- Published by AIP Publishing in Applied Physics Letters
- Vol. 124 (22)
Study on dark current suppression of HgCdTe avalanche photodiodes for low flux photon detection
Mid-wavelength infrared HgCdTe electron-initiated avalanche photodiodes (e-APDs) have presented excellent performances on resolving and counting photons. Aiming at low flux, the readout integrated circuit noise can be significantly reduced by certain device gain, and very low excess noise of HgCdTe e-APDs gives the opportunity for noise equivalent photon (NEPh) to be 1. Therefore, the main issue for signal-to-noise ratio of HgCdTe APD is gain normalized dark current density (GNDCD) at high reverse bias. In this work, the electric field distribution is optimized by designing the mesa device structure to suppress the tunneling current at high operating voltage. Furthermore, etching technology combining dry etching and wet etching and passivation technology based on plasma enhanced atomic layer deposition were used to reduce surface leakage current. Finally, 20 μm pitch 128 × 128 array HgCdTe APDs for cutoff wavelength 4.32 μm at 80 K corresponding to compositions xCd = 0.326 were fabricated, the measured GNDCD of the test unit is about 1.5–10 × 10−9 A/cm2 at 0–13 V, and very low excess noise guaranteed the NEPh to be 2.0 at gain = 93 and 1.6 at gain = 193.
- 27 May 2024
- Published by AIP Publishing in Applied Physics Letters
- Vol. 124 (22)
Open AccessStudy on dark current suppression of HgCdTe avalanche photodiodes for low flux photon detection
Mid-wavelength infrared HgCdTe electron-initiated avalanche photodiodes (e-APDs) have presented excellent performances on resolving and counting photons. Aiming at low flux, the readout integrated circuit noise can be significantly reduced by certain device gain, and very low excess noise of HgCdTe e-APDs gives the opportunity for noise equivalent photon (NEPh) to be 1. Therefore, the main issue for signal-to-noise ratio of HgCdTe APD is gain normalized dark current density (GNDCD) at high reverse bias. In this work, the electric field distribution is optimized by designing the mesa device structure to suppress the tunneling current at high operating voltage. Furthermore, etching technology combining dry etching and wet etching and passivation technology based on plasma enhanced atomic layer deposition were used to reduce surface leakage current. Finally, 20 μm pitch 128 × 128 array HgCdTe APDs for cutoff wavelength 4.32 μm at 80 K corresponding to compositions xCd = 0.326 were fabricated, the measured GNDCD of the test unit is about 1.5–10 × 10−9 A/cm2 at 0–13 V, and very low excess noise guaranteed the NEPh to be 2.0 at gain = 93 and 1.6 at gain = 193.
- 19 October 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Selected Topics in Quantum Electronics
- Vol. 28 (2: Optical) , 1-9
Temperature-Dependent Characteristics of HgCdTe Mid-Wave Infrared E-Avalanche Photodiode
This paper presents the characteristics of HgCdTe mid-wavelength infrared (MWIR) electron-initiated avalanche photodiodes (e-APDs) as a function of temperature under different biases. The devices show a low dark current density of the order of ${10^{ - 7}} \text{A/cm}^2$ at 80 K when the reverse bias voltage is below 4 V, with an exponential gain above 100 at − 8 V. Low excess noise factor of around 1.2 is also demonstrated for the devices at 80 K. The dark current and gain characteristics at different temperatures are analyzed, along with the device simulation results. A varied-temperature impact ionization model for MWIR e-APD devices is adopted based on the experimental results. In addition, a significant increase of the dark current in the APD device is observed at high temperature under large reverse bias, which can be associated with the local electric field redistribution due to the accumulation of holes in the depletion region at high temperatures. The analysis presented in this work paves the way to achieve a high operating temperature (HOT) of the HgCdTe APD with further optimization.
- 19 October 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Selected Topics in Quantum Electronics
- Vol. 28 (2: Optical) , 1-9
Temperature-Dependent Characteristics of HgCdTe Mid-Wave Infrared E-Avalanche Photodiode
This paper presents the characteristics of HgCdTe mid-wavelength infrared (MWIR) electron-initiated avalanche photodiodes (e-APDs) as a function of temperature under different biases. The devices show a low dark current density of the order of ${10^{ - 7}} \text{A/cm}^2$ at 80 K when the reverse bias voltage is below 4 V, with an exponential gain above 100 at − 8 V. Low excess noise factor of around 1.2 is also demonstrated for the devices at 80 K. The dark current and gain characteristics at different temperatures are analyzed, along with the device simulation results. A varied-temperature impact ionization model for MWIR e-APD devices is adopted based on the experimental results. In addition, a significant increase of the dark current in the APD device is observed at high temperature under large reverse bias, which can be associated with the local electric field redistribution due to the accumulation of holes in the depletion region at high temperatures. The analysis presented in this work paves the way to achieve a high operating temperature (HOT) of the HgCdTe APD with further optimization.