KGKaiyuan Guo

Kaiyuan Guo

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Kaiyuan Guo has a total of 5 co-authors. Here are the top co-authors by number of shared publications:

  • Beibei Gao

    Institute of Technology for Carbon Neutralization, Yangzhou University, Yangzhou 225009, China

    1 shared publication
  • Jianning Ding

    School of Materials Science and Engineering, Jiangsu Collaborative Innovation Center of Photovoltaic Science and Engineering, National Experimental Demonstration Center for Materials Science and Engineering, Changzhou University, Changzhou 213164, China

    1 shared publication
  • Qinqin Wang

    Institute of Technology for Carbon Neutralization Yangzhou University Yangzhou China

    1 shared publication
  • Wangping Wu

    Electrochemistry and Corrosion Laboratory, School of Mechanical Engineering and Rail Transit, Changzhou University, Changzhou, China

    1 shared publication
  • Wei Huang

    Institute of Technology for Carbon Neutralization, Yangzhou University, Yangzhou 225009, China

    1 shared publication

Latest Publications

  • Open Access

    Effects on Metallization of n+-Poly-Si Layer for N-Type Tunnel Oxide Passivated Contact Solar Cells

    by Qinqin Wang, Beibei Gao, Wangping Wu, Kaiyuan Guo, Wei Huang, Jianning Ding

    Thin polysilicon (poly-Si)-based passivating contacts can reduce parasitic absorption and the cost of n-TOPCon solar cells. Herein, n+-poly-Si layers with thicknesses of 30~100 nm were fabricated by low-pressure chemical vapor deposition (LPCVD) to create passivating contacts. We investigated the effect of n+-poly-Si layer thickness on the microstructure of the metallization contact formation, passivation, and electronic performance of n-TOPCon solar cells. The thickness of the poly-Si layer significantly affected the passivation of metallization-induced recombination under the metal contact (J0,metal) and the contact resistivity (ρc) of the cells. However, it had a minimal impact on the short-circuit current density (Jsc), which was primarily associated with corroded silver (Ag) at depths of the n+-poly-Si layer exceeding 40 nm. We introduced a thin n+-poly-Si layer with a thickness of 70 nm and a surface concentration of 5 × 1020 atoms/cm3. This layer can meet the requirements for low J0,metal and ρc values, leading to an increase in conversion efficiency of 25.65%. This optimized process of depositing a phosphorus-doped poly-Si layer can be commercially applied in photovoltaics to reduce processing times and lower costs.