Qifan Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Qifan Liu has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Song Yuan
Xidian University
5 shared publications - Xi Jiang
Xidian University
5 shared publications Xiaowu Gong
National Key Discipline Laboratory of Wide Band-gap Semiconductor, Faculty of Integrated Circuit, Xidian University, Xian, China
4 shared publications- Ying Wang
Key Laboratory of Ministry of Education for Wide Bandgap Semiconductor Materials and Devices, School of Microelectronics, Xidian University, Xian, China
3 shared publications - Zhaoheng Yan
Xidian University
3 shared publications Chuanyue Chen
Inhoinic Technology, Ltd., Zhuhai, China
2 shared publications
Latest Publications
- 1 October 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 41 (2) , 1743-1751
Wider Output Voltage Range Asymmetrical Half-Bridge Flyback Converter With Primary Side Synchronization Turn-Off Control
The asymmetrical half bridge flyback (AHB-Flyback) topology exhibits superior performance in scenarios involving higher output power and various output voltage conditions. However, the actual energy transfer time controlled by the power device in a single switching period varies with output voltage, complicating accurate control of the energy transfer process. Any deviation, whether too short or too long, reduces transfer efficiency. This article introduces a novel dynamic self-calibration technique for a wider output voltage AHB-Flyback converter, incorporating primary and secondary synchronous switching techniques. This control strategy effectively mitigates conduction losses caused by inaccurate energy transfer time control across the entire load range. A controller integrated circuit is fabricated with TSMC 0.5-$\mu$m BCD mixed-signal process. A 100 W/20 V prototype with a power density of 24.5-W/$\mathbf {inch^{3}}$ and a maximum efficiency of 94.57% is obtained.
- 1 October 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 41 (2) , 1743-1751
Wider Output Voltage Range Asymmetrical Half-Bridge Flyback Converter With Primary Side Synchronization Turn-Off Control
The asymmetrical half bridge flyback (AHB-Flyback) topology exhibits superior performance in scenarios involving higher output power and various output voltage conditions. However, the actual energy transfer time controlled by the power device in a single switching period varies with output voltage, complicating accurate control of the energy transfer process. Any deviation, whether too short or too long, reduces transfer efficiency. This article introduces a novel dynamic self-calibration technique for a wider output voltage AHB-Flyback converter, incorporating primary and secondary synchronous switching techniques. This control strategy effectively mitigates conduction losses caused by inaccurate energy transfer time control across the entire load range. A controller integrated circuit is fabricated with TSMC 0.5-$\mu$m BCD mixed-signal process. A 100 W/20 V prototype with a power density of 24.5-W/$\mathbf {inch^{3}}$ and a maximum efficiency of 94.57% is obtained.
- 10 February 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Emerging and Selected Topics in Power Electronics
- Vol. 13 (2) , 2150-2157
Adaptive Soft Switching Asymmetrical Half-Bridge Flyback Converter With Wider Voltage Range
The asymmetrical half bridge flyback (AHB-Flyback) topology employing soft switching techniques, has gained widespread use due to its ability to achieve high efficiency while accommodating a wide voltage range in rapidly evolving portable electronics. Zero-voltage switching (ZVS) is a key technique for implementing soft switching in AHB-Flyback converters. This approach addresses the impacts of parameter variations and fluctuations in the sampling value of input and output voltages, thereby increasing efficiency. A controller integrated circuit (IC) has been fabricated using the TSMC 0.5-μm BCD mixed-signal process and verified with a prototype experimental test board rated at 60W/20V, achieving a maximum efficiency of 94.09%.
- 10 February 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Emerging and Selected Topics in Power Electronics
- Vol. 13 (2) , 2150-2157
Adaptive Soft Switching Asymmetrical Half-Bridge Flyback Converter With Wider Voltage Range
The asymmetrical half bridge flyback (AHB-Flyback) topology employing soft switching techniques, has gained widespread use due to its ability to achieve high efficiency while accommodating a wide voltage range in rapidly evolving portable electronics. Zero-voltage switching (ZVS) is a key technique for implementing soft switching in AHB-Flyback converters. This approach addresses the impacts of parameter variations and fluctuations in the sampling value of input and output voltages, thereby increasing efficiency. A controller integrated circuit (IC) has been fabricated using the TSMC 0.5-μm BCD mixed-signal process and verified with a prototype experimental test board rated at 60W/20V, achieving a maximum efficiency of 94.09%.
- 28 January 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 25 (7) , 10613-10618
High-Performance GaN PCT-SBD Temperature Sensors by Decreasing the Density of Nitrogen Vacancies in the AlGaN Layer
In this study, a partial p-GaN cap layer and T-anode GaN SBD temperature sensor with TiN as Schottky contact (TiN-PCT-SBD) is demonstrated to mitigate the impact of nitrogen vacancies in the AlGaN layer on the temperature characteristics of GaN lateral integrated temperature sensor. The TiN anode significantly reduces the trap density associated with nitrogen vacancies in the AlGaN layer, DT=3.05~3.44×1012cm−2eV−1, and ET = 0.303~0.410 eV, thereby enhancing temperature characteristics and broadening the sub-threshold range. The TiN-PCT-SBD temperature sensor achieves an increased temperature sensitivity of 3.72 mV/K over a wide operational range from 298 K to 473 K, compared to 2.67 mV/K for Ti-PCT-SBD. Furthermore, TiN-PCT-SBD maintains high sensitivity while exhibiting excellent linearity with R2 = 0.9997, whereas Ti-PCT-SBD demonstrates a linearity of only 0.997.
- 28 January 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 25 (7) , 10613-10618
High-Performance GaN PCT-SBD Temperature Sensors by Decreasing the Density of Nitrogen Vacancies in the AlGaN Layer
In this study, a partial p-GaN cap layer and T-anode GaN SBD temperature sensor with TiN as Schottky contact (TiN-PCT-SBD) is demonstrated to mitigate the impact of nitrogen vacancies in the AlGaN layer on the temperature characteristics of GaN lateral integrated temperature sensor. The TiN anode significantly reduces the trap density associated with nitrogen vacancies in the AlGaN layer, DT=3.05~3.44×1012cm−2eV−1, and ET = 0.303~0.410 eV, thereby enhancing temperature characteristics and broadening the sub-threshold range. The TiN-PCT-SBD temperature sensor achieves an increased temperature sensitivity of 3.72 mV/K over a wide operational range from 298 K to 473 K, compared to 2.67 mV/K for Ti-PCT-SBD. Furthermore, TiN-PCT-SBD maintains high sensitivity while exhibiting excellent linearity with R2 = 0.9997, whereas Ti-PCT-SBD demonstrates a linearity of only 0.997.
- 31 October 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 40 (2) , 2691-2696
A Novel Control Scheme for Light Load Power Reduction of Flyback Converter
Lower power consumption is a primary concern in the design and development of the flyback converter. However, the power consumption of the flyback converter during light loads has not been extensively explored in existing literature. Given the rapid deployment of flyback converters, it is necessary to develop a new technique of reducing power consumption for the flyback converter under light load conditions. This letter introduces a novel power loss reduction approach for flyback converter with average power reduction strategy. A controller IC is fabricated with TSMC 0.5-μm bipolar-CMOS-DMOS (BCD) mixed-signal process. And verified by a prototype experimental test board of 15 W/15 V.
- 31 October 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 40 (2) , 2691-2696
A Novel Control Scheme for Light Load Power Reduction of Flyback Converter
Lower power consumption is a primary concern in the design and development of the flyback converter. However, the power consumption of the flyback converter during light loads has not been extensively explored in existing literature. Given the rapid deployment of flyback converters, it is necessary to develop a new technique of reducing power consumption for the flyback converter under light load conditions. This letter introduces a novel power loss reduction approach for flyback converter with average power reduction strategy. A controller IC is fabricated with TSMC 0.5-μm bipolar-CMOS-DMOS (BCD) mixed-signal process. And verified by a prototype experimental test board of 15 W/15 V.
- Open Access
- 5 June 2024
- Published by MDPI AG in Micromachines
- Vol. 15 (6) , 759
A Novel IGBT with SIPOS Pillars Achieving Ultralow Power Loss in TCAD Simulation Study
A novel insulated gate bipolar transistor with Semi-Insulated POly Silicon (SIPOS) is presented in this paper and analyzed through TCAD simulation. In the off state, the SIPOS-IGBT can obtain a uniform electric field distribution, which enables a thinner drift region under the same breakdown voltage. In the on state, an electron accumulation layer is formed along the SIPOS, which can increase the injection level of the “PiN region” in the device, and the carrier concentration in the drift region is also increased due to the charge balance effect. Moreover, the SIPOS-IGBT can achieve a quick and thorough depletion in the drift region during the turn-off transient, which can greatly reduce the turn-off loss of the SIPOS-IGBT. These advantages improve the tradeoff between the conduction and switching losses. According to the simulation results, the SIPOS-IGBT obtained a 58% lower turn loss than that of a field-stop (FS) IGBT and 30% lower than an HK-IGBT with the same on-state voltage.
- 5 June 2024
- Published by MDPI AG in Micromachines
- Vol. 15 (6) , 759
Open AccessA Novel IGBT with SIPOS Pillars Achieving Ultralow Power Loss in TCAD Simulation Study
A novel insulated gate bipolar transistor with Semi-Insulated POly Silicon (SIPOS) is presented in this paper and analyzed through TCAD simulation. In the off state, the SIPOS-IGBT can obtain a uniform electric field distribution, which enables a thinner drift region under the same breakdown voltage. In the on state, an electron accumulation layer is formed along the SIPOS, which can increase the injection level of the “PiN region” in the device, and the carrier concentration in the drift region is also increased due to the charge balance effect. Moreover, the SIPOS-IGBT can achieve a quick and thorough depletion in the drift region during the turn-off transient, which can greatly reduce the turn-off loss of the SIPOS-IGBT. These advantages improve the tradeoff between the conduction and switching losses. According to the simulation results, the SIPOS-IGBT obtained a 58% lower turn loss than that of a field-stop (FS) IGBT and 30% lower than an HK-IGBT with the same on-state voltage.