Rihan Hai
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Rihan Hai has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Keqilao Meng
School of Energy and Power Engineering, Inner Mongolia University of Technology, Hohhot 010051, China
2 shared publications - Fengshuo Bian
Rui Dian Technology Co., Ltd., Beijing 100085, China
1 shared publication - Jianlong Ma
School of Energy and Power Engineering, Inner Mongolia University of Technology, Hohhot 010051, China
1 shared publication Qing Liu
College of Energy and Power Engineering, Inner Mongolia University of Technology 1 , Hohhot, Inner Mongolia 010050, China
1 shared publication- Rigele Na
College of Energy and Power Engineering, Inner Mongolia University of Technology 1 , Hohhot, Inner Mongolia 010050, China
1 shared publication - Yan Jia
School of Energy and power Engineering Inner Mongolia University of Technology, Hohhot 010051, China
1 shared publication
Latest Publications
- Open Access
- 1 April 2024
- Published by AIP Publishing in AIP Advances
- Vol. 14 (4)
Research on dynamic characteristics and control strategy of energy release process of liquid air energy storage system
The liquid air energy storage (LAES) technology has received widespread attention for its advantages of high energy storage density, a wide range of applications, safety, environmental protection and hygiene, flexible device regulation, and large energy storage scale and is developing toward high-parameter and large-capacity energy storage. However, due to the late start of research in China, large-scale LAES has not been put into commercial operation so far, and the lack of in-depth understanding of the dynamic characteristics of LAES has seriously impeded the development of the system design and regulation technology, which limits the development and popularization of LAES. In this study, a dynamic mathematical model of the liquid air energy storage system is established based on the SIMULINK platform of MATLAB software. The dynamic characteristics of the system in the energy release stage are analyzed, a control model of the grid-connected speed control system is established, and an optimized control strategy is obtained by using a linear active disturbance rejection controller and by analyzing the response under typical disturbances. The model and the results of this study provide a reference for the understanding of the dynamic characteristics of LAES and the control of the speed control system, and the control strategy can effectively reduce the problem of high overshooting of the rotor of the expander and reach a stable state in a shorter time, which is of practical significance for promoting the application and popularization of LAES.
- 1 April 2024
- Published by AIP Publishing in AIP Advances
- Vol. 14 (4)
Open AccessResearch on dynamic characteristics and control strategy of energy release process of liquid air energy storage system
The liquid air energy storage (LAES) technology has received widespread attention for its advantages of high energy storage density, a wide range of applications, safety, environmental protection and hygiene, flexible device regulation, and large energy storage scale and is developing toward high-parameter and large-capacity energy storage. However, due to the late start of research in China, large-scale LAES has not been put into commercial operation so far, and the lack of in-depth understanding of the dynamic characteristics of LAES has seriously impeded the development of the system design and regulation technology, which limits the development and popularization of LAES. In this study, a dynamic mathematical model of the liquid air energy storage system is established based on the SIMULINK platform of MATLAB software. The dynamic characteristics of the system in the energy release stage are analyzed, a control model of the grid-connected speed control system is established, and an optimized control strategy is obtained by using a linear active disturbance rejection controller and by analyzing the response under typical disturbances. The model and the results of this study provide a reference for the understanding of the dynamic characteristics of LAES and the control of the speed control system, and the control strategy can effectively reduce the problem of high overshooting of the rotor of the expander and reach a stable state in a shorter time, which is of practical significance for promoting the application and popularization of LAES.
- Open Access
- 4 May 2022
- Published by Hindawi Limited in Mathematical Problems in Engineering
- Vol. 2022, 1-11
Application of Effective Wind Speed Estimation and New Sliding Mode Observer in Wind Energy Conversion System
The wind speed information measured by the wind speed sensor in the wind turbine generator may differ from sufficient wind speed. Therefore, this paper proposes a new effective wind speed calculation method and applies it to the optimal maximum power point tracking (MPPT) of wind energy. After estimating the turbine torque and its rotor speed, the process reverses the turbines aerodynamic model. The extended state observer (ESO) based on sliding mode control is used to estimate the aerodynamic torque, which solves complex and challenging tuning of the traditional ESO parameters, and replaces the conventional PI controller, thereby improving the anti-interference and robustness of the system. The sliding mode observer (SMO) is used to estimate the rotor speed. While satisfying the conditions of Lyapunovs inequality, the design of the SMO is discussed in detail. The wind speed estimation method proposed for evaluating permanent magnet semidirect drive wind turbine and its application performance in maximum power tracking. The simulation was carried out in MATLAB/Simulink; the simulation confirmed that the estimated wind speed under different wind conditions is accurate. Compared with the traditional PI control, the utilization rate of wind energy is increased by 2, which can be used for the MPPT control of the wind energy conversion system.
- 4 May 2022
- Published by Hindawi Limited in Mathematical Problems in Engineering
- Vol. 2022, 1-11
Open AccessApplication of Effective Wind Speed Estimation and New Sliding Mode Observer in Wind Energy Conversion System
The wind speed information measured by the wind speed sensor in the wind turbine generator may differ from sufficient wind speed. Therefore, this paper proposes a new effective wind speed calculation method and applies it to the optimal maximum power point tracking (MPPT) of wind energy. After estimating the turbine torque and its rotor speed, the process reverses the turbines aerodynamic model. The extended state observer (ESO) based on sliding mode control is used to estimate the aerodynamic torque, which solves complex and challenging tuning of the traditional ESO parameters, and replaces the conventional PI controller, thereby improving the anti-interference and robustness of the system. The sliding mode observer (SMO) is used to estimate the rotor speed. While satisfying the conditions of Lyapunovs inequality, the design of the SMO is discussed in detail. The wind speed estimation method proposed for evaluating permanent magnet semidirect drive wind turbine and its application performance in maximum power tracking. The simulation was carried out in MATLAB/Simulink; the simulation confirmed that the estimated wind speed under different wind conditions is accurate. Compared with the traditional PI control, the utilization rate of wind energy is increased by 2, which can be used for the MPPT control of the wind energy conversion system.