KBK. Kamala Bharathi

K. Kamala Bharathi

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


K. Kamala Bharathi has a total of 20 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Local degradation pathways in lithium-rich manganese–nickel–cobalt oxide epitaxial thin films

    by Aaron C. Johnston-Peck, Saya Takeuchi, K. Kamala Bharathi, Andrew. A. Herzing, Leonid A. Bendersky

    The electrochemical performance and microstructure of positive electrodes are intimately linked. As such, developing batteries resistance to capacity and voltage fade requires understanding these underlying structure–property relationships and their evolution with operation. Epitaxial films of a Li-rich manganese–nickel–cobalt oxide cathode material were deposited on (100)- and (111)-oriented SrRuO3/SrTiO3 substrates. Cyclic voltammetry and impedance spectroscopy tracked the response of these positive electrode materials, while the microstructure of the pristine and cycled films was characterized using transmission electron microscopy. Energy-dispersive X-ray spectroscopy identifies compositional fluctuations in as-deposited films. Phase transformations and dissolution were observed after electrochemical testing. There is a correlation between both local composition and substrate orientation (i.e., surface faceting) and what degradation pathways are active. Regions with comparatively higher concentrations of Ni and Co were more resistant to dissolution and unfavorable phase transformations than those with relatively more Mn. As such, a global composition metric may not be an accurate predictor of degradation and performance. Rather possessing the synthetic ability to engineer the chemical profile as well as characterizing it, pose a challenge and opportunity.


  • Temperature-dependent magnetization, anisotropy and conductivity of CoFe2−xSnxO4(x = 0.025, 0.05, 0.075): appearance of grain boundary conductivity at high temperatures

    by K Ugendar, V Vaithyanathan, L N Patro, S S R Inbanathan, K K Bharathi

    The temperature dependence of magnetization, anisotropy, ac and dc conductivity of CoFe 2− x Sn x O 4 ( x = 0.025, 0.05, 0.075) were investigated and the results are reported. All the compounds were prepared by a solid-state reaction, and the formation of the compounds in the cubic inverse spinel phase was confirmed from their Rietveld refined x-ray diffraction (XRD) patterns and Raman spectra. Increments in the lattice constant were observed upon the partial substitution of Fe 3+ by Sn 4+ . The presence of all elements and their ionic states were confirmed from x-ray photoelectron spectroscopic studies. Magnetic hysteresis loops were measured for each compound at temperature 20 K and 50–300 K (in steps of 50 K) using a superconducting quantum interference device vibrating sample magnetometer. Both magnetization and magnetic anisotropy showed a decrease in values with increasing Sn substitution. Room temperature (RT) magnetization is seen to decrease from 80–65.91 emu g −1 with increasing Sn concentration from x = 0 (CoFe 2 O 4 ) to 0.075 (CoFe 1.925 Sn 0.075 O 4 ). The high field regimes of the hysteresis loops were modeled using the law of approach to the saturation magnetization equation. The temperature variation of magnetization and magnetic anisotropy are explained on the basis of a one-ion model. Complex impedance spectroscopy studies at RT show that the conductivity in these materials is predominantly due to the intrinsic bulk grains. With increasing the temperature, evolution of the grain boundary conduction is clearly seen through the appearance of a second semi-circle in the complex impedance plots. The RT total dc conductivity value of CoFe 2− x Sn x O 4 ( x = 0, 0.025, 0.05, 0.075) is found to be 5.78 × 10 −8 , 8.56 × 10 −8 , 1.44 × 10 −7 and 1.11 × 10 −7 S cm −1 respectively. The observation of well-distinguishable grain and grain boundary conductions and the low conductivity values in the CoFe 2− x Sn x O 4 ( x = 0, 0.025) materials indicates that these materials are promising candidates for high-frequency applications.


  • Open Access

    Effect of oxygen pressure on structure and ionic conductivity of epitaxial Li0.33La0.55TiO3 solid electrolyte thin films produced by pulsed laser deposition

    by K. Kamala Bharathi, H. Tan, S. Takeuchi, L. Meshi, H. Shen, J. Shin, I. Takeuchi, L. A. Bendersky

    We report on the ionic conductivity of Li0.33La0.55TiO3 (LLTO) epitaxial films grown on the (100) and (111) surfaces of single crystal SrTiO3 (STO) substrates at different oxygen partial pressures (from 1.33 to 26.66 Pa).


  • Evolution of grain boundary conduction with increasing temperature in pure and Ti doped Co ferrite materials

    by V. Vaithyanathan, L. N. Patro, Ugendar Kodam, H. Tan, S. S. R. Inbanathan, K. Kamala Bharathi

    We report on the structural, temperature, and frequency dependent impedance studies of Ti doped cobalt ferrite material (CoFe1.95Ti0.05O4) in comparison with the pure CoFe2O4. XRD and Raman spectroscopy studies confirm the inverse spinel crystallization of the materials with space group of Fd-3 m. Scanning electron microscope images shows the microcrystalline nature of the particles. Homogeneity, stoichiometry, and ionic states of the ions in the composition were confirmed by energy dispersive X-ray analysis and X-ray photoelectron spectroscopic studies. Temperature and frequency dependent real (Z′) and imaginary (Z″) part of the impedance shows the existence of relaxation processes and their distribution in CoFe2O4 and CoFe1.95Ti0.05O4 materials. Complex impedance spectroscopy studies at low temperatures shows that the conductivity in these materials is predominantly due to the intrinsic bulk grains. With increasing the temperature, evolution of grain boundary conduction is clearly seen through the appearance of a second semi-circle in the complex impedance plots. Room temperature total dc conductivity of both CoFe2O4 and CoFe1.95Ti0.05O4 materials is found to be 5.78 × 10−8 and 1.61 × 10−7 S/cm, respectively. Temperature variation of dc electrical conductivity follows the Arrhenius relationship and the activation energies for CoFe2O4 corresponding to grain (0.55 eV for CoFe2O4), grain boundary (0.52 eV), and total conduction (0.54 eV) are discussed. Observation of well distinguishable grain and grain boundary conductions and the low conductivity values in CoFe2O4 and CoFe1.95Ti0.05O4 materials indicates that these materials are promising candidates for the high frequency applications.