Yi Xiao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Yi Xiao has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Dongfeng Yan
Flight Technology College, Civil Aviation Flight University of China
1 shared publication - Ganchao Zhao
Flight Technology College, Civil Aviation Flight University of China, Guanghan 618307, China
1 shared publication - Liang Wang
Flight Technology College, Civil Aviation Flight University of China, Guanghan, People’s Republic of China
1 shared publication - Lu Ye
Flight Technology College, Civil Aviation Flight University of China, Guanghan 618307, China
1 shared publication Meiyin Zheng
School of Flight Technology, Civil Aviation Flight University of China, Guanghan, China
1 shared publication- Quanyao Ren
National Key Laboratory of Nuclear Reactor Technology, Nuclear Power Institute of China, Chengdu, China
1 shared publication
Latest Publications
- Open Access
- 19 April 2023
- Published by Wiley in International Journal of Aerospace Engineering
- Vol. 2023, 1-17
Study on the Effect of Oxidative Jet and Vortex Structure in Fluidic Throat Combined with Thrust Vector Control
To examine the impact of oxidative jets on the thrust vector angle, secondary combustion efficiency, and combustion chamber pressure, inert gas (nitrogen) and pure oxygen are injected into the primary flow, which includes combustible components, at various locations in the divergence section and throat using different injection techniques. The simulations utilize Reynolds-averaged Navier-Stokes equations coupled with the SST - turbulence model in two-dimensional numerical simulations and large-eddy simulation in three-dimensional studies. The numerical method is validated through schlieren experiments, and the vortex is identified using the Liutex-Omega method. The vortex structures and flow characteristics are analyzed. The results indicate that, at the same flow rate, the vector control effect of pure oxygen is superior to nitrogen only in the divergence section, but inferior to nitrogen in both the divergence section and throat. However, with improved vector control, the peak of the vector angle is achieved at a lower flow rate in the case of pure oxygen. When the secondary flow is introduced only in the divergence section, the flow ratio corresponding to the peak point in the pure oxygen case is approximately 14.3% earlier than that in the nitrogen case. The introduction of the pure oxygen jet enhances the secondary combustion efficiency of the primary flow, but to a limited extent. Additionally, when the jet is introduced at the throat, the effect of the pure oxygen case on adjusting the combustion chamber pressure is inferior to that of the nitrogen case. Concerning flow details, the trailing lower vortex replaces the trailing major vortex to become the highest magnitude vortex when the momentum flux ratio is small.
- 19 April 2023
- Published by Wiley in International Journal of Aerospace Engineering
- Vol. 2023, 1-17
Open AccessStudy on the Effect of Oxidative Jet and Vortex Structure in Fluidic Throat Combined with Thrust Vector Control
To examine the impact of oxidative jets on the thrust vector angle, secondary combustion efficiency, and combustion chamber pressure, inert gas (nitrogen) and pure oxygen are injected into the primary flow, which includes combustible components, at various locations in the divergence section and throat using different injection techniques. The simulations utilize Reynolds-averaged Navier-Stokes equations coupled with the SST - turbulence model in two-dimensional numerical simulations and large-eddy simulation in three-dimensional studies. The numerical method is validated through schlieren experiments, and the vortex is identified using the Liutex-Omega method. The vortex structures and flow characteristics are analyzed. The results indicate that, at the same flow rate, the vector control effect of pure oxygen is superior to nitrogen only in the divergence section, but inferior to nitrogen in both the divergence section and throat. However, with improved vector control, the peak of the vector angle is achieved at a lower flow rate in the case of pure oxygen. When the secondary flow is introduced only in the divergence section, the flow ratio corresponding to the peak point in the pure oxygen case is approximately 14.3% earlier than that in the nitrogen case. The introduction of the pure oxygen jet enhances the secondary combustion efficiency of the primary flow, but to a limited extent. Additionally, when the jet is introduced at the throat, the effect of the pure oxygen case on adjusting the combustion chamber pressure is inferior to that of the nitrogen case. Concerning flow details, the trailing lower vortex replaces the trailing major vortex to become the highest magnitude vortex when the momentum flux ratio is small.
- Open Access
- 12 May 2022
- Published by Frontiers Media SA in Frontiers in Energy Research
- Vol. 10
Modeling and Simulation Analysis on Mixing Characteristics of Two-Phase Flow Around Spacer Grid
The spacer grid has a significant impact on the thermal-hydraulic characteristics of the rod bundle channel, which directly determines the possibility of a boiling crisis. The multi-phase flow model coupling boiling model is proposed to acquire the secondary flow and void fraction for subcooled flow boiling in the fuel assembly. Compared with the experimental data, the RNG k–ε turbulence model is selected in the current research. In addition, the thermal-hydraulic parameters of subcooled boiling flow in the 5 × 5 rod bundle with a spacer grid are studied focusing on the influence of different arrangements of mixing vanes. It is found that the distribution of the vapor phase is greatly influenced by the intensity and flow direction of secondary flow. In addition, the thermal–hydraulic characteristics in the sub-channels and around the fuel rods are investigated, which demonstrates that uniform crossflow makes vapor harder to accumulate around the fuel rods. Furthermore, the mixing characteristics of different types of spacer grids are also discussed in detail.
- 12 May 2022
- Published by Frontiers Media SA in Frontiers in Energy Research
- Vol. 10
Open AccessModeling and Simulation Analysis on Mixing Characteristics of Two-Phase Flow Around Spacer Grid
The spacer grid has a significant impact on the thermal-hydraulic characteristics of the rod bundle channel, which directly determines the possibility of a boiling crisis. The multi-phase flow model coupling boiling model is proposed to acquire the secondary flow and void fraction for subcooled flow boiling in the fuel assembly. Compared with the experimental data, the RNG k–ε turbulence model is selected in the current research. In addition, the thermal-hydraulic parameters of subcooled boiling flow in the 5 × 5 rod bundle with a spacer grid are studied focusing on the influence of different arrangements of mixing vanes. It is found that the distribution of the vapor phase is greatly influenced by the intensity and flow direction of secondary flow. In addition, the thermal–hydraulic characteristics in the sub-channels and around the fuel rods are investigated, which demonstrates that uniform crossflow makes vapor harder to accumulate around the fuel rods. Furthermore, the mixing characteristics of different types of spacer grids are also discussed in detail.