Longxiang Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Longxiang Liu has a total of 35 co-authors. Here are the top co-authors by number of shared publications:
Fei Guo
University College London 20 Gordon St
2 shared publications- Liqun Kang
Max Planck Institute for Chemical Energy Conversion, Stiftstrasse 34-36, 45470 Mülheim an der Ruhr, Germany
2 shared publications - Alexander Schnegg
Max-Planck-Institute for Chemical Energy Conversion
1 shared publication Christopher S. Allen
Diamond Light Source Ltd
1 shared publication- Elizabeth Jones
University of Oxford
1 shared publication - Guoliang Chai
State Key Laboratory of Structural Chemistry, Fujian Institute of Research on the Structure of Matter
1 shared publication
Latest Publications
- Open Access
- 29 July 2026
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 148 (31) , 33089-33103
Local Coordination Motif Compatibility Induces the Formation of Shortened Fe3+–O–Ni3+δ Moieties as Active Sites for Highly Efficient Oxygen Evolution Reaction
NiFe-based compounds are among the most promising catalysts for the oxygen evolution reaction (OER). However, the structural reconstruction of NiFe catalysts during OER is not fully understood. Most existing studies implicitly assume the formation of a homogeneous NiFe (oxy)hydroxide lattice; however, the actual reconstruction process is more likely to generate structurally heterogeneous (oxy)hydroxide phases with local distortions due to the intrinsic mismatch between Fe3+–O and Ni3+–O bond lengths in the bulk NiFe compounds. By constructing atomically dispersed Ni and Fe active sites as precatalysts and combining them with operando spectroelectrochemical studies, we observed an unusual reconstruction pathway in which isolated Ni2+ and Fe atoms can adaptively evolve into a short-range mixed NiFe (oxy)hydroxide local structure through the formation of interconnected M-O-M′ (M/M′ = Ni3+δ, Fe3+) motifs during the OER. At 1.6 V vs RHE, the reconstructed γ-Fe3+OOH clusters are induced to integrate into the high-valent γ-Ni3+δOOH lattice, resulting in a short-range mixed NixFe1–xOOH structure. This new structure is characterized by an unusually short Fe3+–Ni3+δ distance of ∼2.86 Å, which is significantly shorter than the typical Fe3+-Fe3+ distance in Fe3+ (oxy)hydroxides (2.95–3.25 Å). Interestingly, this “induction effect” is absent in Co3+–Fe3+ catalysts, as atomically dispersed Co3+ sites directly transition into γ-Co3+OOH, which lacks structural compatibility with γ-Fe3+OOH. DFT calculations reveal that the unusually short Fe3+-O bond leads to a moderate *O adsorption strength at the Fe site in the catalyst, thereby creating the most favorable conditions for the oxygen evolution reaction (OER).
- 29 July 2026
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 148 (31) , 33089-33103
Open AccessLocal Coordination Motif Compatibility Induces the Formation of Shortened Fe3+–O–Ni3+δ Moieties as Active Sites for Highly Efficient Oxygen Evolution Reaction
NiFe-based compounds are among the most promising catalysts for the oxygen evolution reaction (OER). However, the structural reconstruction of NiFe catalysts during OER is not fully understood. Most existing studies implicitly assume the formation of a homogeneous NiFe (oxy)hydroxide lattice; however, the actual reconstruction process is more likely to generate structurally heterogeneous (oxy)hydroxide phases with local distortions due to the intrinsic mismatch between Fe3+–O and Ni3+–O bond lengths in the bulk NiFe compounds. By constructing atomically dispersed Ni and Fe active sites as precatalysts and combining them with operando spectroelectrochemical studies, we observed an unusual reconstruction pathway in which isolated Ni2+ and Fe atoms can adaptively evolve into a short-range mixed NiFe (oxy)hydroxide local structure through the formation of interconnected M-O-M′ (M/M′ = Ni3+δ, Fe3+) motifs during the OER. At 1.6 V vs RHE, the reconstructed γ-Fe3+OOH clusters are induced to integrate into the high-valent γ-Ni3+δOOH lattice, resulting in a short-range mixed NixFe1–xOOH structure. This new structure is characterized by an unusually short Fe3+–Ni3+δ distance of ∼2.86 Å, which is significantly shorter than the typical Fe3+-Fe3+ distance in Fe3+ (oxy)hydroxides (2.95–3.25 Å). Interestingly, this “induction effect” is absent in Co3+–Fe3+ catalysts, as atomically dispersed Co3+ sites directly transition into γ-Co3+OOH, which lacks structural compatibility with γ-Fe3+OOH. DFT calculations reveal that the unusually short Fe3+-O bond leads to a moderate *O adsorption strength at the Fe site in the catalyst, thereby creating the most favorable conditions for the oxygen evolution reaction (OER).
- Open Access
- 22 June 2026
- Published by Wiley in Advanced Science
- p. e76132
Study on the Reaction Mechanism of RuO x and Its Enhanced Hydrogen Evolution Reaction Activity
Ruthenium oxide is a well‐known electrocatalyst for water splitting. Despite many advantages, the reaction mechanism and the structure changes of ruthenium oxide are unclear during catalysis, and the catalytic efficiency of ruthenium oxides remains a concern. In this paper, a needle‐shaped copper substrate was synthesized, and the performance of RuO x was optimized. Reversible in situ Raman signals were found during the reaction process, which confirmed from the reversible surface reconstruction of RuO x . Density Functional Theory calculations found that the actual catalytic species is Ru(II)O. A detailed reaction mechanism of the Volmer step on the surface of ruthenium oxide was proposed based on the findings. The results indicate that the needles can lower the overpotentials of RuO x . At a current density of 10 , the overpotential of RuO x @ndl. was 68% lower than that of RuO x @b. f., which is much lower than the overpotential of commercial Pt(20wt.%)/C. This research provides a fundamental understanding of ruthenium oxide's reaction mechanism and gives insight into the design of the hydrogen evolution reaction catalysts.
- 22 June 2026
- Published by Wiley in Advanced Science
- p. e76132
Open AccessStudy on the Reaction Mechanism of RuO x and Its Enhanced Hydrogen Evolution Reaction Activity
Ruthenium oxide is a well‐known electrocatalyst for water splitting. Despite many advantages, the reaction mechanism and the structure changes of ruthenium oxide are unclear during catalysis, and the catalytic efficiency of ruthenium oxides remains a concern. In this paper, a needle‐shaped copper substrate was synthesized, and the performance of RuO x was optimized. Reversible in situ Raman signals were found during the reaction process, which confirmed from the reversible surface reconstruction of RuO x . Density Functional Theory calculations found that the actual catalytic species is Ru(II)O. A detailed reaction mechanism of the Volmer step on the surface of ruthenium oxide was proposed based on the findings. The results indicate that the needles can lower the overpotentials of RuO x . At a current density of 10 , the overpotential of RuO x @ndl. was 68% lower than that of RuO x @b. f., which is much lower than the overpotential of commercial Pt(20wt.%)/C. This research provides a fundamental understanding of ruthenium oxide's reaction mechanism and gives insight into the design of the hydrogen evolution reaction catalysts.
- Open Access
- 12 June 2025
- Published by American Chemical Society (ACS) in ChemRxiv
A Pressure Gap in Fischer-Tropsch Synthesis Revealed with Multi-bar Soft X-ray Spectroscopies
Catalytic surfaces can dramatically restructure with reaction conditions, influencing activity and selectivity, as well as making it challenging to identify the active phase. Using graphene windows decorated with mass-selected Co nanoparticles (4 or 8 nm), we probe the chemical state and adsorbate coverage during Fisher-Tropsch synthesis at multi-bar pressures. Operando electron yield X-ray absorption spectroscopy and photoelectron spectroscopy reveal the formation of a Co carbonyl-like species at 4 bar, which is not detected for similar nanoparticles at 1 bar. By comparing with smaller nanoparticle sizes at 1 bar, this species is found to be associated with low coordination sites where CO preferentially binds. A clear pressure gap is identified through the emergence of the carbonyl-like species at the elevated pressures of industrial Fisher-Tropsch synthesis, suggesting an important role for pressure-induced restructuring in increasing activity during reaction.
- 12 June 2025
- Published by American Chemical Society (ACS) in ChemRxiv
Open AccessA Pressure Gap in Fischer-Tropsch Synthesis Revealed with Multi-bar Soft X-ray Spectroscopies
Catalytic surfaces can dramatically restructure with reaction conditions, influencing activity and selectivity, as well as making it challenging to identify the active phase. Using graphene windows decorated with mass-selected Co nanoparticles (4 or 8 nm), we probe the chemical state and adsorbate coverage during Fisher-Tropsch synthesis at multi-bar pressures. Operando electron yield X-ray absorption spectroscopy and photoelectron spectroscopy reveal the formation of a Co carbonyl-like species at 4 bar, which is not detected for similar nanoparticles at 1 bar. By comparing with smaller nanoparticle sizes at 1 bar, this species is found to be associated with low coordination sites where CO preferentially binds. A clear pressure gap is identified through the emergence of the carbonyl-like species at the elevated pressures of industrial Fisher-Tropsch synthesis, suggesting an important role for pressure-induced restructuring in increasing activity during reaction.
- Open Access
- 4 June 2024
- Published by Springer Nature in Nature Communications
- Vol. 15 (1) , 1-12
Highly reversible transition metal migration in superstructure-free Li-rich oxide boosting voltage stability and redox symmetry
The further practical applications of Li-rich layered oxides are impeded by voltage decay and redox asymmetry, which are closely related to the structural degradation involving irreversible transition metal migration. It has been demonstrated that the superstructure ordering in O2-type materials can effectively suppress voltage decay and redox asymmetry. Herein, we elucidate that the absence of this superstructure ordering arrangement in a Ru-based O2-type oxide can still facilitate the highly reversible transition metal migration. We certify that Ru in superstructure-free O2-type structure can unlock a quite different migration path from Mn in mostly studied cases. The highly reversible migration of Ru helps the cathode maintain the structural robustness, thus realizing terrific capacity retention with neglectable voltage decay and inhibited oxygen redox asymmetry. We untie the knot that the absence of superstructure ordering fails to enable a high-performance Li-rich layered oxide cathode material with suppressed voltage decay and redox asymmetry.
- 4 June 2024
- Published by Springer Nature in Nature Communications
- Vol. 15 (1) , 1-12
Open AccessHighly reversible transition metal migration in superstructure-free Li-rich oxide boosting voltage stability and redox symmetry
The further practical applications of Li-rich layered oxides are impeded by voltage decay and redox asymmetry, which are closely related to the structural degradation involving irreversible transition metal migration. It has been demonstrated that the superstructure ordering in O2-type materials can effectively suppress voltage decay and redox asymmetry. Herein, we elucidate that the absence of this superstructure ordering arrangement in a Ru-based O2-type oxide can still facilitate the highly reversible transition metal migration. We certify that Ru in superstructure-free O2-type structure can unlock a quite different migration path from Mn in mostly studied cases. The highly reversible migration of Ru helps the cathode maintain the structural robustness, thus realizing terrific capacity retention with neglectable voltage decay and inhibited oxygen redox asymmetry. We untie the knot that the absence of superstructure ordering fails to enable a high-performance Li-rich layered oxide cathode material with suppressed voltage decay and redox asymmetry.
- 1 March 2018
- Published by Elsevier in Composites Science and Technology
- Vol. 157, 185-194
In-situ synthesized CNTs/Bi2Se3 nanocomposites by a facile wet chemical method and its application for enhancing fire safety of epoxy resin
- 1 March 2018
- Published by Elsevier in Composites Science and Technology
- Vol. 157, 185-194
In-situ synthesized CNTs/Bi2Se3 nanocomposites by a facile wet chemical method and its application for enhancing fire safety of epoxy resin