BDBruce Rolstad Denby

Bruce Rolstad Denby

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Bruce Rolstad Denby has a total of 57 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    High-resolution agricultural NH 3 emissions in Norway: the 250 m GRAIN framework and evaluation with atmospheric observations

    by Susana Lopez-Aparicio, Henrik Grythe, Miha Markelj, Erik A. Mousing, Bruce R. Denby

    Agricultural ammonia (NH3) emissions are highly heterogeneous because livestock housing, manure storage, grazing and fertilizer applications occur at different locations and times. Regional emission inventories may not resolve this variability, particularly in areas with spatially concentrated agricultural activity. We present GRAIN, a framework for spatially allocating nationally agricultural emissions across Norway at 250 m resolution using detailed information on farm locations, livestock production, agricultural land use and manure availability. Emissions are allocated at the level of individual subsectors using activity specific spatial proxies for livestock housing, manure storage, grazing, and fertilization. Comparison with CAMS-REG-AP and EMEP emissions showed substantial spatial differences despite same national totals. Spatial correspondence was higher for agricultural soil (R2 = 0.72 and 0.89 for CAMS and EMEP, respectively) than for manure management (R2 = 0.30 and 0.27), with normalized mean errors of 35–55 % and 127–64 %, respectively. GRAIN emissions were used with the EMEP/uEMEP modelling system to simulate atmospheric NH3 and evaluated against a passive sampler campaign. Observations showed pronounced spatial variability, including concentration gradients over distances below 1 km. Agreement with observations improved from R2 = 0.47 for EMEP to R2 = 0.67 for uEMEP, while the regression slope increased from 0.22 to 0.70, and normalized mean bias improved from -65.1 % for EMEP to +1.6 % for uEMEP. These results show that process specific, high-resolution emissions allocation, combined with local scale atmospheric modelling, substantially improves the representation of observed spatial variability and NH3 concentration magnitude.

  • Open Access

    Estimating the contribution of traction sanding to observed PM 10 concentrations using mass balance arguments

    by Bruce Rolstad Denby, Elin Ristorp Aas, Michael Norman

    PM 10 concentrations in many countries in Europe are above or close to the limit values set out by the European commission for 2030. This includes both the daily mean and annual mean limit values of 45 µg/m 3 and 20 µg/m 3 respectively. In the European Ambient Air Quality Directives (AAQD) from 2008 and the new AAQD for 2030 the possibility exists to discount an exceedance of a daily mean PM 10 concentration if this is caused by the contribution from traction sanding or road salting. To implement this article in the AAQD, some methodology must be applied to determine the contribution of traction sanding to the PM 10 concentrations. The current recommended method is very simple and does not account for the amount of sand applied, the studded tyre share or the traffic volume. This paper outlines the use of mass balance modelling, in combination with observed PM 10 and PM 2.5 concentrations, to determine the contribution of traction sanding to PM 10 non-exhaust emissions. A two-tiered approach is provided. The first tier assumes that all wear sources are deposited onto the road surface, allowing both traction sand and wear particles to undergo the same removal processes, conserving their relative contributions to the emitted PM. The second tier improves this method by including additional information concerning direct emissions and the surface wetness. The two methods are shown to closely follow the more complex NORTRIP road dust emission model and the methods may be applied to deduce traction sanding contributions to PM 10 concentrations with simple spreadsheet calculations. This will enable the eventual negation of exceedances caused by the traction sanding contribution.

  • Open Access

    Future scenarios for air quality in Europe, the Western Balkans and EECCA countries: An assessment for the Gothenburg protocol review

    by Bruce R. Denby, Zbigniew Klimont, Agnes Nyiri, Gregor Kiesewetter, Chris Heyes, Hilde Fagerli


  • Open Access

    Sub-grid Variability and its Impact on Exposure in Regional Scale Air Quality and Integrated Assessment Models: Application of the uEMEP Downscaling Model

    by Bruce R. Denby, Gregor Kiesewetter, Agnes Nyiri, Zbigniew Klimont, Hilde Fagerli, Eivind G. Wærsted, Peter Wind


  • Open Access

    Downscaling of air pollutants in Europe using uEMEP_v6

    by Qing Mu, Bruce Rolstad Denby, Eivind Grøtting Wærsted, Hilde Fagerli

    The air quality downscaling model uEMEP and its combination with the EMEP MSC-W chemical transport model are used here to achieve high-resolution air quality modelling at street level in Europe. By using publicly available proxy data, this uEMEP–EMEP modelling system is applied to calculate annual mean NO2, PM2.5, PM10, and O3 concentrations for all of Europe down to 100 m resolution and is validated against all available AIRBASE monitoring stations in Europe at 25 m resolution. Downscaling is carried out on annual mean concentrations, requiring special attention to non-linear processes, such as NO2 chemistry for which frequency distributions are applied to better represent the non-linear NO2 chemistry. The downscaling shows significant improvement in NO2 concentrations for which the spatial correlation has been doubled for most countries and bias reduced from −46 % to −18 % for all stations in Europe. The downscaling of PM2.5 and PM10 does not show improvement in spatial correlation but does reduce the overall bias in the European calculations from −21 % to −11 % and from −39 % to −30 % for PM2.5 and PM10, respectively. There is improved spatial correlation in most countries after downscaling of O3 and a reduced positive bias of O3 concentrations from +16 % to +11 %. Sensitivity tests in Norway show that improvements in the emission and emission proxy data used for the downscaling can significantly improve both the NO2 and PM results. The downscaling development opens the way for improved exposure estimates, improved assessment of emissions, and detailed calculations of source contributions to exceedances in a consistent way for all of Europe at high resolution.


  • Forecasting PM2.5 Concentrations with uEMEP and EMEP4PL for Poland

    by Maciej Kryza, Malgorzata Werner, Bruce Rolstad Denby, Qing Mu, Tymoteusz Sawiński, Arkadiusz Remut


  • Open Access

    Comment on gmd-2021-198

    by Qing Mu, Bruce Rolstad Denby, Eivind Grøtting Wærsted, Hilde Fagerli

    The air quality downscaling model uEMEP and its combination with the EMEP MSC-W chemical transport model are used here to achieve high-resolution air quality modeling at street level in Europe. By using publicly available proxy data, this uEMEP/EMEP modelling system is applied to calculate annual mean NO2, PM2.5, PM10 and O3 concentrations for all of Europe down to 100 m resolution and is validated against all available Airbase monitoring stations in Europe at 25 m resolution. Downscaling is carried out on annual mean concentrations, requiring special attention to non-linear processes, such as NO2 chemistry, where frequency distributions are applied to better represent the non-linear NO2 chemistry. The downscaling shows significant improvement in NO2 concentrations where spatial correlation has been doubled for most countries and bias reduced from −46 % to −18 % for all stations in Europe. The downscaling of PM2.5 and PM10 does not show improvement in spatial correlation but does reduce the overall bias in the European calculations from −21 % to −11 % and from −39 % to −30 % for PM2.5 and PM10 respectively. There is improved spatial correlation in most countries after downscaling of O3, and a reduced positive bias of O3 concentrations from +16 % to +11 %. Sensitivity tests in Norway show that improvements in the emission and emission proxy data used for the downscaling can significantly improve both the NO2 and PM results. The downscaling development opens the way for improved exposure estimates, improved assessment of emissions as well as detailed calculations of source contributions to exceedances in a consistent way for all of Europe at high resolution.

  • Open Access

    Description of the uEMEP_v5 downscaling approach for the EMEP MSC-W chemistry transport model

    by Bruce Rolstad Denby, Michael Gauss, Peter Wind, Qing Mu, Eivind Grøtting Wærsted, Hilde Fagerli, Alvaro Valdebenito, Heiko Klein

    A description of the new air quality downscaling model – the urban EMEP (uEMEP) and its combination with the EMEP MSC-W model (European Monitoring and Evaluation Programme Meteorological Synthesising Centre West) – is presented. uEMEP is based on well-known Gaussian modelling principles. The uniqueness of the system is in its combination with the EMEP MSC-W model and the “local fraction” calculation contained within it. This allows the uEMEP model to be imbedded in the EMEP MSC-W model and downscaling can be carried out anywhere within the EMEP model domain, without any double counting of emissions, if appropriate proxy data are available that describe the spatial distribution of the emissions. This makes the model suitable for high-resolution calculations, down to 50 m, over entire countries. An example application, the Norwegian air quality forecasting and assessment system, is described where the entire country is modelled at a resolution of between 250 and 50 m. The model is validated against all available monitoring data, including traffic sites, in Norway. The results of the validation show good results for NO2, which has the best known emissions, and moderately good for PM10 and PM2.5. In Norway, the largest contributor to PM, even in cities, is long-range transport followed by road dust and domestic heating emissions. These contributors to PM are more difficult to quantify than NOx exhaust emission from traffic, which is the major contributor to NO2 concentrations. In addition to the validation results, a number of verification and sensitivity results are summarised. One verification showed that single annual mean calculations with a rotationally symmetric dispersion kernel give very similar results to the average of an entire year of hourly calculations, reducing the runtime for annual means by 4 orders of magnitude. The uEMEP model, in combination with EMEP MSC-W model, provides a new tool for assessing local-scale concentrations and exposure over large regions in a consistent and homogenous way and is suitable for large-scale policy applications.