Yves Bréchet
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Yves Bréchet has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Alexis Deschamps
SIMaP, University of Grenoble Alpes, CNRS, Grenoble INP, Grenoble, France
2 shared publications - Christopher R. Hutchinson
Department of Materials Science and Engineering, Monash University, Clayton, Australia
2 shared publications - Baptiste Gault
CNRS
1 shared publication - Bernard Yrieix
EDF R&D
1 shared publication - Frédéric Livet
LTPCM-ENSEEG, UMR-CNRS 5614, INPG/UJF, BP 75, 38402 St Martin d'Hères, France
1 shared publication G. Fribourg
Institute National Polytechnique de Grenoble
1 shared publication
Latest Publications
- Open Access
- 21 May 2024
- Published by Elsevier in Scripta Materialia
- Vol. 250
On the origin of carbon supersaturation in bainitic ferrite
- 21 May 2024
- Published by Elsevier in Scripta Materialia
- Vol. 250
Open AccessOn the origin of carbon supersaturation in bainitic ferrite
- Open Access
- 29 December 2023
- Published by Elsevier in Acta Materialia
- Vol. 265, 119643
The effect of shearable clusters and precipitates on dynamic recovery of Al alloys
- 29 December 2023
- Published by Elsevier in Acta Materialia
- Vol. 265, 119643
Open AccessThe effect of shearable clusters and precipitates on dynamic recovery of Al alloys
- Open Access
- 1 June 2014
- Published by MathDoc/Centre Mersenne in Comptes Rendus. Physique
- Vol. 15 (6) , 481-508
Contrôler et limiter la dispersion des produits radioactifs des centrales électronucléaires en cas d'accident
Nous examinons le rôle des différences physiques, chimiques et physicochimiques entre les conséquences des accidents de centrales électronucléaires – désignées EN dans la suite – et les accidents majeurs des grands équipements technologiques à hauts risques (extraction, raffinerie et transport du pétrole, grande chimie, lancer de navette spatiale, aviation, mines, chemin de fer à grande vitesse, etc.) afin de pouvoir borner dans l'espace et dans le temps, leurs graves conséquences sur les sociétés humaines, voisines ou non. Nous identifions les substances contenant des noyaux radioactifs dangereux lors de ces accidents nucléaires majeurs des centrales EN et cherchons à diminuer et contrôler les causes de leur diffusion dans l'atmosphère, les sols, les eaux continentales et maritimes. Nous proposons des voies de recherche scientifique conduisant à des solutions pour ce faire, et en particulier : A. diminuer, autant que faire se peut, les durées d'irradiation des combustibles nucléaires, et après leur sortie du cœur du réacteur, en extraire les noyaux radioactifs litigieux ; B. concevoir des réacteurs de puissance dont les combustibles nucléaires seraient des liquides qui se verraient fréquemment (et même continuellement) soutirés du cœur du réacteur. Les corps radioactifs litigieux seraient alors extraits par voie chimique et le fluide combustible purifié renvoyé dans le cœur ; C. séparer, plus radicalement, le circuit du fluide combustible et le circuit du fluide caloporteur, ce dernier pouvant alors ne plus être radioactif, ce qui simplifie considérablement sa conception, son fonctionnement et son démantèlement ; D. utiliser un combustible de numéro atomique plus petit que celui de l'uranium ou du plutonium, comme le thorium. Les cycles de combustibles des actinides à numéros atomiques Z (nombre de protons) et A (nombre de nucléons) élevés conduisent, par captures successives de neutrons, à des noyaux pair–pair sujets aux fissions spontanées, donc à des émissions de neutrons lors de ces fissions, même quand la réaction nucléaire en chaîne est arrêtée. Les émissions de neutrons sont un des dangers majeurs et exigent des installations de radioprotection difficiles à réaliser. Une voie de perfectionnement des concepts A, B, C est de partir d'un combustible de numéro atomique plus petit que celui de l'uranium ou du plutonium, comme le thorium. Cela constitue le concept D étudié ici. Il se trouve qu'une partie substantielle de ces quatre voies de recherche a été étudiée dans d'autres contextes, depuis un demi-siècle. Ce qui peut en être utilisé ici est précisé, avec les prolongements de recherche nécessaires.
- 1 June 2014
- Published by MathDoc/Centre Mersenne in Comptes Rendus. Physique
- Vol. 15 (6) , 481-508
Open AccessContrôler et limiter la dispersion des produits radioactifs des centrales électronucléaires en cas d'accident
Nous examinons le rôle des différences physiques, chimiques et physicochimiques entre les conséquences des accidents de centrales électronucléaires – désignées EN dans la suite – et les accidents majeurs des grands équipements technologiques à hauts risques (extraction, raffinerie et transport du pétrole, grande chimie, lancer de navette spatiale, aviation, mines, chemin de fer à grande vitesse, etc.) afin de pouvoir borner dans l'espace et dans le temps, leurs graves conséquences sur les sociétés humaines, voisines ou non. Nous identifions les substances contenant des noyaux radioactifs dangereux lors de ces accidents nucléaires majeurs des centrales EN et cherchons à diminuer et contrôler les causes de leur diffusion dans l'atmosphère, les sols, les eaux continentales et maritimes. Nous proposons des voies de recherche scientifique conduisant à des solutions pour ce faire, et en particulier : A. diminuer, autant que faire se peut, les durées d'irradiation des combustibles nucléaires, et après leur sortie du cœur du réacteur, en extraire les noyaux radioactifs litigieux ; B. concevoir des réacteurs de puissance dont les combustibles nucléaires seraient des liquides qui se verraient fréquemment (et même continuellement) soutirés du cœur du réacteur. Les corps radioactifs litigieux seraient alors extraits par voie chimique et le fluide combustible purifié renvoyé dans le cœur ; C. séparer, plus radicalement, le circuit du fluide combustible et le circuit du fluide caloporteur, ce dernier pouvant alors ne plus être radioactif, ce qui simplifie considérablement sa conception, son fonctionnement et son démantèlement ; D. utiliser un combustible de numéro atomique plus petit que celui de l'uranium ou du plutonium, comme le thorium. Les cycles de combustibles des actinides à numéros atomiques Z (nombre de protons) et A (nombre de nucléons) élevés conduisent, par captures successives de neutrons, à des noyaux pair–pair sujets aux fissions spontanées, donc à des émissions de neutrons lors de ces fissions, même quand la réaction nucléaire en chaîne est arrêtée. Les émissions de neutrons sont un des dangers majeurs et exigent des installations de radioprotection difficiles à réaliser. Une voie de perfectionnement des concepts A, B, C est de partir d'un combustible de numéro atomique plus petit que celui de l'uranium ou du plutonium, comme le thorium. Cela constitue le concept D étudié ici. Il se trouve qu'une partie substantielle de ces quatre voies de recherche a été étudiée dans d'autres contextes, depuis un demi-siècle. Ce qui peut en être utilisé ici est précisé, avec les prolongements de recherche nécessaires.
- 2 November 2009
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 115 (5) , 3110-3119
Influence of structural feature of aluminum coatings on mechanical and water barrier properties of metallized PET films
This article focuses on description and evaluation of multilayer films, which are used for vacuum insulation panels (VIP). The materials investigated include a neat polyethylene terephthalate (PET) and PET films coated by chemical vapor deposition with different aluminum thicknesses. The aim of these investigations was to evaluate the influence of structural features on the physical properties of Al/PET systems. The morphological analyzes associated to water vapor permeability measurements showed that the metallized surface exhibited defects through which a small amount of water vapor can permeate. It is shown that the permeance varies linearly with the surface fraction occupied by pinholes which in turn changes linearly with the aluminum thickness. © 2009 Wiley Periodicals, Inc. J Appl Polym Sci, 2010
- 2 November 2009
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 115 (5) , 3110-3119
Influence of structural feature of aluminum coatings on mechanical and water barrier properties of metallized PET films
This article focuses on description and evaluation of multilayer films, which are used for vacuum insulation panels (VIP). The materials investigated include a neat polyethylene terephthalate (PET) and PET films coated by chemical vapor deposition with different aluminum thicknesses. The aim of these investigations was to evaluate the influence of structural features on the physical properties of Al/PET systems. The morphological analyzes associated to water vapor permeability measurements showed that the metallized surface exhibited defects through which a small amount of water vapor can permeate. It is shown that the permeance varies linearly with the surface fraction occupied by pinholes which in turn changes linearly with the aluminum thickness. © 2009 Wiley Periodicals, Inc. J Appl Polym Sci, 2010
- 1 January 2009
- Published by Springer Nature in MRS Proceedings
- Vol. 1188
Mechanical Properties of Sintered and Non Sintered Stainless Steel Wools: Experimental Investigation and Modelling
- 1 January 2009
- Published by Springer Nature in MRS Proceedings
- Vol. 1188
Mechanical Properties of Sintered and Non Sintered Stainless Steel Wools: Experimental Investigation and Modelling
- 15 July 2006
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 519-521, 991-996
Precipitation Strengthening in AA7449 Aluminium Alloy: Understanding the Relationship between Microstructure, Yield Strength and Strain Hardening
This paper presents a detailed study of the microstructure and mechanical properties of AA7449 alloy during the two step heat treatment leading to the industrial T7651 temper. It is first shown that reproducing the heat treatment without a deformation step as used in the T7651 industrial temper leads to 2-fold decrease of the precipitation kinetics due to the absence of dislocations, while the resulting mechanical properties (if this change in kinetics is accounted for) are very similar. The work hardening rate is shown to strongly evolve during the heat treatment, and this evolution has been correlated to the evolution of microstructure using a Kocks-Mecking-Estrin analysis. Finally, an analysis in terms of activation volume of the strain rate sensitivity allows for the determination of the dislocation / precipitate interaction in the overaged temper.
- 15 July 2006
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 519-521, 991-996
Precipitation Strengthening in AA7449 Aluminium Alloy: Understanding the Relationship between Microstructure, Yield Strength and Strain Hardening
This paper presents a detailed study of the microstructure and mechanical properties of AA7449 alloy during the two step heat treatment leading to the industrial T7651 temper. It is first shown that reproducing the heat treatment without a deformation step as used in the T7651 industrial temper leads to 2-fold decrease of the precipitation kinetics due to the absence of dislocations, while the resulting mechanical properties (if this change in kinetics is accounted for) are very similar. The work hardening rate is shown to strongly evolve during the heat treatment, and this evolution has been correlated to the evolution of microstructure using a Kocks-Mecking-Estrin analysis. Finally, an analysis in terms of activation volume of the strain rate sensitivity allows for the determination of the dislocation / precipitate interaction in the overaged temper.
- 2 May 1996
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 217-222, 1281-1286
Effect of Process Parameters on the Ageing of an Al-6% Zn-2.3% Mg Alloy
- 2 May 1996
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 217-222, 1281-1286
Effect of Process Parameters on the Ageing of an Al-6% Zn-2.3% Mg Alloy
- Open Access
- 1 May 1996
- Published by American Physical Society (APS) in Physical Review E
- Vol. 53 (5) , 5006-5010
Pinning of a solid-liquid-vapor interface by stripes of obstacles
We use a macroscopic Hamiltonian approach to study the pinning of a solid-liquid-vapor contact line on an array of equidistant stripes of obstacles perpendicular to the liquid. We propose an estimate of the density of pinning stripes for which collective pinning of the contact line happens. This estimate is shown to be in good agreement with Langevin equation simulation of the macroscopic Hamiltonian. Finally we introduce a two-dimensional mean field theory that for small strength of the pinning stripes and for small capillary length gives an excellent description of the averaged height of the contact line. © 1996 The American Physical Society.
- 1 May 1996
- Published by American Physical Society (APS) in Physical Review E
- Vol. 53 (5) , 5006-5010
Open AccessPinning of a solid-liquid-vapor interface by stripes of obstacles
We use a macroscopic Hamiltonian approach to study the pinning of a solid-liquid-vapor contact line on an array of equidistant stripes of obstacles perpendicular to the liquid. We propose an estimate of the density of pinning stripes for which collective pinning of the contact line happens. This estimate is shown to be in good agreement with Langevin equation simulation of the macroscopic Hamiltonian. Finally we introduce a two-dimensional mean field theory that for small strength of the pinning stripes and for small capillary length gives an excellent description of the averaged height of the contact line. © 1996 The American Physical Society.
- 1 May 1995
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 103, 21-50
Plastic Instabilities in Materials Science and in Physics
- 1 May 1995
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 103, 21-50
Plastic Instabilities in Materials Science and in Physics
- 1 September 1990
- Published by Elsevier in Scripta Metallurgica et Materialia
- Vol. 24 (9) , 1831-1835
Elastic energy and the solute drag effect
- 1 September 1990
- Published by Elsevier in Scripta Metallurgica et Materialia
- Vol. 24 (9) , 1831-1835
Elastic energy and the solute drag effect