Hongbo Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Hongbo Li has a total of 52 co-authors. Here are the top co-authors by number of shared publications:
- Mo-Yuen Chow
Global College, Shanghai Jiao Tong University, Shanghai 200240, China
5 shared publications - Fuchun Sun
Department of Computer Science and Technology, Tsinghua University, Beijing 100084, China
4 shared publications - Huaping Liu
Tsinghua University
3 shared publications Zengqi Sun
Department of Computer Science and Technology, State Key Laboratory of Intelligent Technology and Systems, Tsinghua University, Beijing 100084, China
3 shared publicationsBaDong Chen
Department of Computer Science and Technology, Tsinghua University, Beijing, P. R. China
2 shared publicationsBadong Chen
2 shared publications
Latest Publications
- 4 November 2022
- Published by Springer Nature in Automotive Innovation
- Vol. 5 (4) , 415-426
Approximate Optimal Filter Design for Vehicle System through Actor-Critic Reinforcement Learning
- 4 November 2022
- Published by Springer Nature in Automotive Innovation
- Vol. 5 (4) , 415-426
Approximate Optimal Filter Design for Vehicle System through Actor-Critic Reinforcement Learning
- 14 June 2019
- Published by Springer Nature
- p. 599-605
Design of a Wideband Receiving Antenna for High-Frequency Ground Wave Radar
- 14 June 2019
- Published by Springer Nature
- p. 599-605
Design of a Wideband Receiving Antenna for High-Frequency Ground Wave Radar
- 16 October 2018
- Published by Springer Nature in The International Journal of Advanced Manufacturing Technology
- Vol. 100 (9-12) , 2387-2399
Analysis of flatness control capability based on the effect function and roll contour optimization for 6-h CVC cold rolling mill
- 16 October 2018
- Published by Springer Nature in The International Journal of Advanced Manufacturing Technology
- Vol. 100 (9-12) , 2387-2399
Analysis of flatness control capability based on the effect function and roll contour optimization for 6-h CVC cold rolling mill
- 7 June 2018
- Published by Springer Nature in Cognitive Computation
- Vol. 10 (5) , 718-736
End-to-End ConvNet for Tactile Recognition Using Residual Orthogonal Tiling and Pyramid Convolution Ensemble
- 7 June 2018
- Published by Springer Nature in Cognitive Computation
- Vol. 10 (5) , 718-736
End-to-End ConvNet for Tactile Recognition Using Residual Orthogonal Tiling and Pyramid Convolution Ensemble
- Open Access
- 14 January 2016
- Published by SAGE Publications in Adaptive Behavior
- Vol. 24 (1) , 52-65
3D Moth-inspired chemical plume tracking and adaptive step control strategy
This paper presents an adaptive-step-control (ASC) strategy for autonomous chemical plume tracking (CPT) in both 2D and 3D spaces. The aim of CPT is tracking a target chemical flow back to its source and declaring its location. While the majority of related works are based on wheeled robots in 2D, the rapid development of rotorcrafts makes 3D plume tracking possible. Hence, in this paper, we first discuss the generalized form of moth-inspired CPT work flow, then extend the orthodox moth-inspired CPT from 2D to 3D. More importantly, we also propose an ASC strategy to deal with the “passing-by” problem and to gain better control performance. Simulation results are given to demonstrate that ASC can solve the inflexibility caused by “hard” step length in diffusive airflow, because it can autonomously adjust the step lengths of the robot according to the status of the environment, enabling our robot to stride confidently in the low chemical concentration areas and focus on highly suspicious areas.
- 14 January 2016
- Published by SAGE Publications in Adaptive Behavior
- Vol. 24 (1) , 52-65
Open Access3D Moth-inspired chemical plume tracking and adaptive step control strategy
This paper presents an adaptive-step-control (ASC) strategy for autonomous chemical plume tracking (CPT) in both 2D and 3D spaces. The aim of CPT is tracking a target chemical flow back to its source and declaring its location. While the majority of related works are based on wheeled robots in 2D, the rapid development of rotorcrafts makes 3D plume tracking possible. Hence, in this paper, we first discuss the generalized form of moth-inspired CPT work flow, then extend the orthodox moth-inspired CPT from 2D to 3D. More importantly, we also propose an ASC strategy to deal with the “passing-by” problem and to gain better control performance. Simulation results are given to demonstrate that ASC can solve the inflexibility caused by “hard” step length in diffusive airflow, because it can autonomously adjust the step lengths of the robot according to the status of the environment, enabling our robot to stride confidently in the low chemical concentration areas and focus on highly suspicious areas.
- Open Access
- 26 May 2015
- Published by Wiley in Mathematical Problems in Engineering
- Vol. 2015, 1-12
Extreme Learning Machine Assisted Adaptive Control of a Quadrotor Helicopter
Control of quadrotor helicopters is difficult because the problem is naturally nonlinear. The problem becomes more challenging for common model based controllers when unpredictable uncertainties and disturbances in physical control system are taken into account. This paper proposes a novel intelligent controller design based on a fast online learning method called extreme learning machine (ELM). Our neural controller does not require precise system modeling or prior knowledge of disturbances and well approximates the dynamics of the quadrotor at a fast speed. The proposed method also incorporates a sliding mode controller for further elimination of external disturbances. Simulation results demonstrate that the proposed controller can reliably stabilize a quadrotor helicopter in both agitated attitude and position control tasks.
- 26 May 2015
- Published by Wiley in Mathematical Problems in Engineering
- Vol. 2015, 1-12
Open AccessExtreme Learning Machine Assisted Adaptive Control of a Quadrotor Helicopter
Control of quadrotor helicopters is difficult because the problem is naturally nonlinear. The problem becomes more challenging for common model based controllers when unpredictable uncertainties and disturbances in physical control system are taken into account. This paper proposes a novel intelligent controller design based on a fast online learning method called extreme learning machine (ELM). Our neural controller does not require precise system modeling or prior knowledge of disturbances and well approximates the dynamics of the quadrotor at a fast speed. The proposed method also incorporates a sliding mode controller for further elimination of external disturbances. Simulation results demonstrate that the proposed controller can reliably stabilize a quadrotor helicopter in both agitated attitude and position control tasks.
- 13 March 2015
- Published by Springer Nature in International Journal of Wireless Information Networks
- Vol. 22 (2) , 73-84
Low-Load Survivable Routing Protocol for LEO Satellite Networks
- 13 March 2015
- Published by Springer Nature in International Journal of Wireless Information Networks
- Vol. 22 (2) , 73-84
Low-Load Survivable Routing Protocol for LEO Satellite Networks
- 1 January 2015
- Published by Springer Nature
- p. 125-134
Adaptive Neural Control of a Quadrotor Helicopter with Extreme Learning Machine
- 1 January 2015
- Published by Springer Nature
- p. 125-134
Adaptive Neural Control of a Quadrotor Helicopter with Extreme Learning Machine
- 18 December 2014
- Published by Springer Nature in International Journal of Control, Automation, and Systems
- Vol. 13 (1) , 33-38
Research on gain scheduling controller of the networked control system with long delay
- 18 December 2014
- Published by Springer Nature in International Journal of Control, Automation, and Systems
- Vol. 13 (1) , 33-38
Research on gain scheduling controller of the networked control system with long delay
- 4 September 2014
- Published by Cambridge University Press (CUP) in Mathematical Structures in Computer Science
- Vol. 24 (5)
Robust attitude tracking control scheme for a multi-body spacecraft using a radial basis function network and terminal sliding mode
We present a novel robust control scheme that deals with multi-body spacecraft attitude tracking problems. The control scheme consists of a radial basis function network (RBFN) and a robust controller. By using the finite time convergence property of the terminal sliding mode (TSM), we derive a new online learning algorithm for updating all the parameters of the RBFN that ensures the RBFN has fast approximation for the parameter uncertainties and external disturbances. We design a robust controller to compensate RBFN approximation errors and realise the anticipative stability and performance properties. We can also achieve closed-loop system stability using Lyapunov stability theory.No detailed knowledge of the non-linear dynamics of the spacecraft is required at any point in the entire design process, and the proposed robust scheme is simple and effective and can be applied to more complex systems. Simulation results demonstrate the good tracking characteristics of the proposed control scheme in the presence of inertial uncertainties and external disturbances.
- 4 September 2014
- Published by Cambridge University Press (CUP) in Mathematical Structures in Computer Science
- Vol. 24 (5)
Robust attitude tracking control scheme for a multi-body spacecraft using a radial basis function network and terminal sliding mode
We present a novel robust control scheme that deals with multi-body spacecraft attitude tracking problems. The control scheme consists of a radial basis function network (RBFN) and a robust controller. By using the finite time convergence property of the terminal sliding mode (TSM), we derive a new online learning algorithm for updating all the parameters of the RBFN that ensures the RBFN has fast approximation for the parameter uncertainties and external disturbances. We design a robust controller to compensate RBFN approximation errors and realise the anticipative stability and performance properties. We can also achieve closed-loop system stability using Lyapunov stability theory.No detailed knowledge of the non-linear dynamics of the spacecraft is required at any point in the entire design process, and the proposed robust scheme is simple and effective and can be applied to more complex systems. Simulation results demonstrate the good tracking characteristics of the proposed control scheme in the presence of inertial uncertainties and external disturbances.