Samira Mohammadi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Samira Mohammadi has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Seyed Morteza Mousavi-Khoshdel
Industrial Electrochemical Research Laboratory, Department of Chemistry, Iran University of Science and Technology, Tehran 16846-13114, Iran
3 shared publications - Amir Mahdi Homayounfard
School of Metallurgy and Materials Engineering, Iran University of Science and Technology, Tehran 16846-13114, Iran
2 shared publications Ahmad Shokrieh
CAS Key Laboratory of Nanosystem and Hierarchical Fabrication, Beijing 100190, P. R. China
1 shared publication- Ali Ghaffarinejad
Research Laboratory of Real Samples Analysis, Faculty of Chemistry, Iran University of Science and Technology, Tehran, Iran
1 shared publication Fatemeh Hedayati
Nanotechnology Department, School of Advanced Technologies
1 shared publication- Hajar Ghanbari
School of Metallurgy & Materials Engineering, Iran University of Science and Technology (IUST), Narmak, Tehran 16846, Iran
1 shared publication
Latest Publications
- 5 December 2025
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 199
Benzocaine grafted Al-Mg-Cu layered triple hydroxide for high-performance supercapacitor
- 5 December 2025
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 199
Benzocaine grafted Al-Mg-Cu layered triple hydroxide for high-performance supercapacitor
- Open Access
- 3 November 2025
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 10 (45) , 54200-54216
Sulfur-Modified Co 3 O 4 –Graphene Nanocomposites for High-Performance Supercapacitor Applications
The development of high-performance electrode materials is crucial for advancing supercapacitor technology. This work presents a sulfur-doped cobalt oxide-reduced graphene oxide (S-doped Co3O4-rGO) nanocomposite directly synthesized on nickel foam via a facile hydrothermal method and subsequent annealing. Comprehensive characterization (XRD, Raman, FTIR, XPS, FE-SEM, and TEM) confirmed successful synthesis and uniform dispersion of components. Electrochemical evaluation revealed exceptional performance: the S-Co3O4-rGO electrode achieved a specific capacitance of 856.8 F/g at 2 A/g, significantly surpassing that of pure Co3O4 (198.8 F/g) and undoped Co3O4-rGO (580 F/g). Furthermore, it demonstrated outstanding long-term stability, retaining 97.5% of its initial capacitance after 5000 charge-discharge cycles at 5 A/g. The synergistic effect between the sulfur-doped graphene network and cobalt oxide nanoparticles is identified as the primary factor enabling this superior capacitance and durability, positioning this nanocomposite as a highly promising candidate for next-generation energy storage devices.
- 3 November 2025
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 10 (45) , 54200-54216
Open AccessSulfur-Modified Co 3 O 4 –Graphene Nanocomposites for High-Performance Supercapacitor Applications
The development of high-performance electrode materials is crucial for advancing supercapacitor technology. This work presents a sulfur-doped cobalt oxide-reduced graphene oxide (S-doped Co3O4-rGO) nanocomposite directly synthesized on nickel foam via a facile hydrothermal method and subsequent annealing. Comprehensive characterization (XRD, Raman, FTIR, XPS, FE-SEM, and TEM) confirmed successful synthesis and uniform dispersion of components. Electrochemical evaluation revealed exceptional performance: the S-Co3O4-rGO electrode achieved a specific capacitance of 856.8 F/g at 2 A/g, significantly surpassing that of pure Co3O4 (198.8 F/g) and undoped Co3O4-rGO (580 F/g). Furthermore, it demonstrated outstanding long-term stability, retaining 97.5% of its initial capacitance after 5000 charge-discharge cycles at 5 A/g. The synergistic effect between the sulfur-doped graphene network and cobalt oxide nanoparticles is identified as the primary factor enabling this superior capacitance and durability, positioning this nanocomposite as a highly promising candidate for next-generation energy storage devices.
- 31 July 2024
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 7 (15) , 6142-6154
High-Performance Ni(II)@Amine-Functionalized Graphene Oxide Composite as Supercapacitor Electrode: Theoretical and Experimental Study
- 31 July 2024
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 7 (15) , 6142-6154
High-Performance Ni(II)@Amine-Functionalized Graphene Oxide Composite as Supercapacitor Electrode: Theoretical and Experimental Study
- 25 July 2024
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 12 (33) , 22045-22060
Wasted rose-derived porous carbons with unique hierarchical heteroatom-enriched structures as a high-performance supercapacitor electrode
High-quality and low-cost activated carbons (ACs) are highly considered as high-performance electrode materials for next-generation supercapacitors. Herein, self-heteroatom-doped nanoporous activated carbon (AC) powders were prepared from wasted rose flowers via two different activation approaches, namely, a typical acidic approach with H3PO4 (AC-T) and a green self-activation approach (AC-S). Based on morphological characterizations, the typical activation method resulted in ACs with a surface area of 1124 m2 g−1, while the ACs prepared by the AC-S method retained the initial hierarchical porous rose structure with a higher surface area of 1556 m2 g−1. High-resolution transmission electron microscopy (HRTEM) images revealed extensive graphitized regions in the porous microstructure of the AC-S powders. Electrochemical analysis results demonstrated an outstanding gravimetric capacitance of 539 F g−1 at 1 A g−1 for AC-S in a three-electrode system. In addition, the prepared electrode with AC-S exhibited excellent stability with 95.4% capacitance retention after 6000 cycles. The symmetric supercapacitor device based on this sample also exhibited a high gravimetric capacitance up to 365 F g−1 and an ultra-high energy density of 50.7 W h kg−1 at a power density of 500 W kg−1.
- 25 July 2024
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 12 (33) , 22045-22060
Wasted rose-derived porous carbons with unique hierarchical heteroatom-enriched structures as a high-performance supercapacitor electrode
High-quality and low-cost activated carbons (ACs) are highly considered as high-performance electrode materials for next-generation supercapacitors. Herein, self-heteroatom-doped nanoporous activated carbon (AC) powders were prepared from wasted rose flowers via two different activation approaches, namely, a typical acidic approach with H3PO4 (AC-T) and a green self-activation approach (AC-S). Based on morphological characterizations, the typical activation method resulted in ACs with a surface area of 1124 m2 g−1, while the ACs prepared by the AC-S method retained the initial hierarchical porous rose structure with a higher surface area of 1556 m2 g−1. High-resolution transmission electron microscopy (HRTEM) images revealed extensive graphitized regions in the porous microstructure of the AC-S powders. Electrochemical analysis results demonstrated an outstanding gravimetric capacitance of 539 F g−1 at 1 A g−1 for AC-S in a three-electrode system. In addition, the prepared electrode with AC-S exhibited excellent stability with 95.4% capacitance retention after 6000 cycles. The symmetric supercapacitor device based on this sample also exhibited a high gravimetric capacitance up to 365 F g−1 and an ultra-high energy density of 50.7 W h kg−1 at a power density of 500 W kg−1.
- 12 June 2024
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 6 (6) , 4108-4119
Preparation of a Cu-Doped Graphene Oxide–Glutamine Nanocomposite for Supercapacitor Electrode Applications: An Experimental and Theoretical Study
- 12 June 2024
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 6 (6) , 4108-4119
Preparation of a Cu-Doped Graphene Oxide–Glutamine Nanocomposite for Supercapacitor Electrode Applications: An Experimental and Theoretical Study