Wassim E. Tabet
Wassim E. Tabet has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Amy B. Cerato
School of Civil Engineering and Environmental Science, University of Oklahoma, Norman, OK 73019, USA
3 shared publications - Rolf E. Jentoft
Lecturer, Chemical Engineering Dept., Univ. of Massachusetts, 159 Goessmann Laboratory, 686 North Pleasant St., Amherst, MA 01003
2 shared publications - Megan Erica Elwood Madden
School of Geosciences, University of Oklahoma Norman OK USA
1 shared publication - Michelle R. Basham
Geosyntec Consultants, 1255 Roberts Blvd. NW, Suite 200, Kennesaw, GA 30144, USA
1 shared publication
Latest Publications
- 1 October 2018
- Published by American Society of Civil Engineers (ASCE) in Journal of Materials in Civil Engineering
- Vol. 30 (10)
Characterization of Hydration Products’ Formation and Strength Development in Cement-Stabilized Kaolinite Using TG and XRD
This study investigates the use of thermogravimetry (TG) and X-ray diffraction (XRD) to characterize and quantify the hydration products, particularly calcium silicate hydrate (CSH) and calcium hydroxide [ ], in stabilized soils and to establish correlations between these products and strength gain over time. A pure kaolinite is the soil for this study and portland cement is the selected stabilizer. Untreated and cement-stabilized samples are compacted at their optimum conditions and cured for different periods of up to 90 days. The unconfined compression test, which is a relatively simple and commonly used test, is performed to measure the unconfined compressive strength (UCS) for all the samples and record the macroscopic behavior. A portion of soil from each set of samples is recovered and subsequently subjected to the TG test coupled with mass spectrometry (MS) and XRD. Using TG, the amounts of CSH (mass loss between 105 and 440°C) and calcium hydroxide (mass loss between 440 and 580°C) are measured and monitored with time to establish their correlation with strength gain. Quantitative XRD using whole-pattern fitting (Rietveld analysis) and the reference intensity ratio (RIR) indicated that the amount of kaolinite decreases logarithmically with curing time and a strong linear correlation is observed between the amount of kaolinite and the unconfined compression strength.- 1 October 2018
- Published by American Society of Civil Engineers (ASCE) in Journal of Materials in Civil Engineering
- Vol. 30 (10)
Characterization of Hydration Products’ Formation and Strength Development in Cement-Stabilized Kaolinite Using TG and XRD
This study investigates the use of thermogravimetry (TG) and X-ray diffraction (XRD) to characterize and quantify the hydration products, particularly calcium silicate hydrate (CSH) and calcium hydroxide [ ], in stabilized soils and to establish correlations between these products and strength gain over time. A pure kaolinite is the soil for this study and portland cement is the selected stabilizer. Untreated and cement-stabilized samples are compacted at their optimum conditions and cured for different periods of up to 90 days. The unconfined compression test, which is a relatively simple and commonly used test, is performed to measure the unconfined compressive strength (UCS) for all the samples and record the macroscopic behavior. A portion of soil from each set of samples is recovered and subsequently subjected to the TG test coupled with mass spectrometry (MS) and XRD. Using TG, the amounts of CSH (mass loss between 105 and 440°C) and calcium hydroxide (mass loss between 440 and 580°C) are measured and monitored with time to establish their correlation with strength gain. Quantitative XRD using whole-pattern fitting (Rietveld analysis) and the reference intensity ratio (RIR) indicated that the amount of kaolinite decreases logarithmically with curing time and a strong linear correlation is observed between the amount of kaolinite and the unconfined compression strength.- 30 March 2017
- Published by American Society of Civil Engineers (ASCE)
- p. 92-102
The Use of Thermogravimetry in Quantifying the Hydration Products in Cement-Stabilized Kaolinite
The study presented in this paper was aimed at investigating the use of thermogravimetry (TG) to quantify the amounts of various hydration products, particularly calcium silicate hydrate (CSH) and calcium hydroxide (CH), in stabilized soils and establish correlations between them and strength gain over time. For that purpose, a pure kaolinite was chosen as the soil for this study and Portland cement was the selected stabilizer. Kaolinite samples and cement-stabilized samples were compacted at their optimum conditions and cured for different periods of time up to 90 days. The unconfined compression test, which is a relatively simple and commonly used test, was performed to measure the unconfined compressive strength (UCS) for all the samples and record the macroscopic behavior. Then, a portion of soil from each set of samples was recovered and subsequently subjected to the TG test which was performed at a constant heating rate of 10 K/min until 1000 oC, while being connected to a mass spectrometer (MS) for simultaneous evolved gas analysis. The thermal decomposition was divided into four major regions i) desorption of adsorbed water below 105 oC, ii) dehydration of CSH phases between 105 and 440 oC, iii) dehydroxylation of kaolinite and CH between 440 and 580 oC, and iv) decarbonation of calcium carbonate at temperature between 580 and 1000 oC. The quantitative analysis revealed that strong linear correlations exist between the amounts of CSH and CH, and strength gain.
- 30 March 2017
- Published by American Society of Civil Engineers (ASCE)
- p. 92-102
The Use of Thermogravimetry in Quantifying the Hydration Products in Cement-Stabilized Kaolinite
The study presented in this paper was aimed at investigating the use of thermogravimetry (TG) to quantify the amounts of various hydration products, particularly calcium silicate hydrate (CSH) and calcium hydroxide (CH), in stabilized soils and establish correlations between them and strength gain over time. For that purpose, a pure kaolinite was chosen as the soil for this study and Portland cement was the selected stabilizer. Kaolinite samples and cement-stabilized samples were compacted at their optimum conditions and cured for different periods of time up to 90 days. The unconfined compression test, which is a relatively simple and commonly used test, was performed to measure the unconfined compressive strength (UCS) for all the samples and record the macroscopic behavior. Then, a portion of soil from each set of samples was recovered and subsequently subjected to the TG test which was performed at a constant heating rate of 10 K/min until 1000 oC, while being connected to a mass spectrometer (MS) for simultaneous evolved gas analysis. The thermal decomposition was divided into four major regions i) desorption of adsorbed water below 105 oC, ii) dehydration of CSH phases between 105 and 440 oC, iii) dehydroxylation of kaolinite and CH between 440 and 580 oC, and iv) decarbonation of calcium carbonate at temperature between 580 and 1000 oC. The quantitative analysis revealed that strong linear correlations exist between the amounts of CSH and CH, and strength gain.