HHH. Hens

H. Hens

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


H. Hens has a total of 4 co-authors. Here are the top co-authors by number of shared publications:

  • A. Janssens

    University of Ghent, Section of Architecture and Town Planning Plateaustraat, 22 TW01, B-9000 Gent, Belgium

    1 shared publication
  • J. Carmeliet

    KU-Leuven, Department of Civil Engineering, Laboratory of Building Physics, Kasteelpark Arenberg, 40, B-3001 Leuven, Belgium, TU/e, Faculty of Building and Architecture, Postbus 513 NL-5600 MB Eindhoven, The Netherlands

    1 shared publication
  • J. Lecompte

    Department of Civil Engineering, Laboratory of Building Physics now at Bekaert NV, Zwevegem, Belgium

    1 shared publication
  • W. Depraetere

    Department of Civil Engineering, Laboratory of Building Physics

    1 shared publication

Latest Publications

  • Brick Cavity Walls: A Performance Analysis Based on Measurements and Simulations

    by H. Hens, A. Janssens, W. Depraetere, J. Carmeliet, J. Lecompte

    After world war two, cavity walls became a widespread external wall type in the cool but humid climate of North Western Europe. Moisture tolerance of the unfilled construction was excellent. Instead, calculation and testing underlined that the unfilled cavity walls of that era performed poorly from a thermal insulation point of view. After the energy crisis of 1973, cavity filling was therefore introduced as the main upgrade. Hence, extensive testing revealed upgrading was less simple than expected. Air in- and exfiltration through the wall, wind washing behind the fill, thermal stack induced air looping around the fill and thermal bridging all cooperated in lowering expected thermal quality of the filled walls. Anyhow, at the same time testing underlined that moisture tolerance remained outstanding in the cool, humid climate of North Western Europe also without cavity ventilation. That resulted in a set of recommendations how to construct high performing filled cavity walls.