Ming Luo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Ming Luo has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
Zhuoxuan Li
College of Marine Geosciences, Ocean University of China, Qingdao, China
2 shared publications- Chenxu Dong
College of Marine Geosciences, Ocean University of China, Qingdao, China
1 shared publication Gongyi Sun
College of Marine Geosciences, Ocean University of China, Qingdao, China
1 shared publicationJialin Chen
College of Engineering, Ocean University of China, Qingdao, China
1 shared publication- Jialin Chen
College of Engineering, Ocean University of China, Qingdao, China
1 shared publication - Jianxin Pei
Ocean University of China College of Marine Geosciences
1 shared publication
Latest Publications
- 28 July 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. 63 (01962892) , 1-14
Time Series Modeling and Tracking Method of Vessel Shaft-Rate Electromagnetic Field
This article presents a novel time series simulation and tracking method of shaft-rate electromagnetic (EM) field for moving vessels. Two approaches, superimposed from the frequency and time domain, respectively, are proposed to synthesize shaft-rate EM time series without a Fourier transform. The modeling method can simulate the shaft-rate EM time series of vessels with arbitrary frequency, horizontal position, draft, electric moment, and initial phase. To obtain shaft-rate EM field amplitude and phase for vessel tracking, the amplitude spectrum analysis is used to identify the shaft-rate fundamental frequency. The short-time Fourier transform and linear least-squares method are combined to estimate the Fourier coefficients of the shaft-rate time series. The response characteristic analysis of multivessel shows that the initial phase does not affect the received EM field amplitudes, but it could cause an unfixed overall shift in the phase of the recorded EM components. Since the vessels being tracked are noncooperative targets, whose parameters, including the initial phase, are unknown, the tracking method of multiple vessels using a multiplicative cost function is applied to estimate the moving vessel’s trajectory, electric moment, and initial phase. We design synthetic experiments of both single vessel and two vessels to validate the proposed tracking method. Inversion results of synthetic examples show that the proposed method can obtain accurate trajectories for both single-vessel and multivessel cases. The proposed method has also been applied to an experiment with real-world noise, and the tracking result shows that the trajectory of the vessel can be estimated reliably.
- 28 July 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. 63 (01962892) , 1-14
Time Series Modeling and Tracking Method of Vessel Shaft-Rate Electromagnetic Field
This article presents a novel time series simulation and tracking method of shaft-rate electromagnetic (EM) field for moving vessels. Two approaches, superimposed from the frequency and time domain, respectively, are proposed to synthesize shaft-rate EM time series without a Fourier transform. The modeling method can simulate the shaft-rate EM time series of vessels with arbitrary frequency, horizontal position, draft, electric moment, and initial phase. To obtain shaft-rate EM field amplitude and phase for vessel tracking, the amplitude spectrum analysis is used to identify the shaft-rate fundamental frequency. The short-time Fourier transform and linear least-squares method are combined to estimate the Fourier coefficients of the shaft-rate time series. The response characteristic analysis of multivessel shows that the initial phase does not affect the received EM field amplitudes, but it could cause an unfixed overall shift in the phase of the recorded EM components. Since the vessels being tracked are noncooperative targets, whose parameters, including the initial phase, are unknown, the tracking method of multiple vessels using a multiplicative cost function is applied to estimate the moving vessel’s trajectory, electric moment, and initial phase. We design synthetic experiments of both single vessel and two vessels to validate the proposed tracking method. Inversion results of synthetic examples show that the proposed method can obtain accurate trajectories for both single-vessel and multivessel cases. The proposed method has also been applied to an experiment with real-world noise, and the tracking result shows that the trajectory of the vessel can be estimated reliably.
- 3 February 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. 63 (01962892) , 1-14
Alternating Magnetic Dipole Tracking From Search Coil Data Using a Multiplicative Cost Function Approach
This article presents a novel inversion method for tracking a moving alternating magnetic dipole in terms of search coil data. We derive the analytical formula of the search coil response for an arbitrary initial phase alternating magnetic dipole. To extract characteristic data from the time series of the search coil for target tracking, the transform of trigonometrical functions, low-pass filter processing, and coherent demodulation are used to extract the target phase, motion characteristic response, and direct current (dc) characteristic response of the alternating magnetic field. The joint inversion method of multiple characteristic data using a multiplicative cost function is used to estimate the moving target’s trajectory, velocity, and magnetic moment. We design three synthetic examples, with and without random noise, to validate the proposed method. Numerical simulations show that the proposed method can locate the magnetic dipole accurately for noisy data. The proposed method has also been applied to a field test and the result shows that the location of the magnetic source can be estimated well.
- 3 February 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. 63 (01962892) , 1-14
Alternating Magnetic Dipole Tracking From Search Coil Data Using a Multiplicative Cost Function Approach
This article presents a novel inversion method for tracking a moving alternating magnetic dipole in terms of search coil data. We derive the analytical formula of the search coil response for an arbitrary initial phase alternating magnetic dipole. To extract characteristic data from the time series of the search coil for target tracking, the transform of trigonometrical functions, low-pass filter processing, and coherent demodulation are used to extract the target phase, motion characteristic response, and direct current (dc) characteristic response of the alternating magnetic field. The joint inversion method of multiple characteristic data using a multiplicative cost function is used to estimate the moving target’s trajectory, velocity, and magnetic moment. We design three synthetic examples, with and without random noise, to validate the proposed method. Numerical simulations show that the proposed method can locate the magnetic dipole accurately for noisy data. The proposed method has also been applied to a field test and the result shows that the location of the magnetic source can be estimated well.
- 24 January 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 25 (6) , 9522-9530
A Triaxial Magnetometer Calibration Method With Improved Beluga Whale Optimization Algorithm
The triaxial magnetometer is a vector magnetic field sensor widely used in various fields. Due to limitations in manufacturing and installation processes, a non-orthogonal error, a scale factor error and a zero-bias error can occur. These sensor errors significantly affect the accuracy of magnetic field measurements, so calibration is essential to ensure reliable data. This paper proposes a novel error calibration method for triaxial magnetometers based on an improved Beluga Whale Optimization algorithm. In addition, three synthetic simulations, with and without noise, and with different initial search spaces and population sizes are designed to validate the proposed method. Ideally, the minimum absolute error between the calibrated and theoretical results is 10–13nT. Furthermore, when the calibration method is applied to the field experiment data, the total geomagnetic field fluctuation is reduced from 600nT to 9nT, which is about 66 times smaller. Both simulation and experimental results further confirm the effectiveness and practicality of the proposed algorithm.
- 24 January 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 25 (6) , 9522-9530
A Triaxial Magnetometer Calibration Method With Improved Beluga Whale Optimization Algorithm
The triaxial magnetometer is a vector magnetic field sensor widely used in various fields. Due to limitations in manufacturing and installation processes, a non-orthogonal error, a scale factor error and a zero-bias error can occur. These sensor errors significantly affect the accuracy of magnetic field measurements, so calibration is essential to ensure reliable data. This paper proposes a novel error calibration method for triaxial magnetometers based on an improved Beluga Whale Optimization algorithm. In addition, three synthetic simulations, with and without noise, and with different initial search spaces and population sizes are designed to validate the proposed method. Ideally, the minimum absolute error between the calibrated and theoretical results is 10–13nT. Furthermore, when the calibration method is applied to the field experiment data, the total geomagnetic field fluctuation is reduced from 600nT to 9nT, which is about 66 times smaller. Both simulation and experimental results further confirm the effectiveness and practicality of the proposed algorithm.
- 9 July 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. 62 (01962892) , 1-12
A Tracking Approach of a Moving Ferromagnetic Object Using Triaxial Search Coil Data
In this article, we propose a novel method for tracking a moving ferromagnetic object in terms of search coil data. The magnitude of the search coil data is proportional to the velocity of the moving target. By analyzing the characteristics of the search coil data, we found the movement of the ferromagnetic object converts the static magnetic field into signals with non-zero frequencies. The search coil data can provide a higher sensitivity to the model parameters than the magnetic gradient tensor data in detecting a moving magnetic object. Localization and estimation of the velocity and magnetic moment are implemented in steps due to the coupling among the object parameters. We use a least square method to estimate the trajectory of the moving object. The magnetic moment and velocity are estimated on the inferred object coordinates. A fourth-order polynomial is applied to fit the velocity curve to suppress errors from the inferred coordinates. We design three synthetic examples, with and without random noise, to validate the proposed method. The locations, velocities and magnetic moments of the moving ferromagnetic target can be well determined. The proposed method has also been applied to a field test, the strong overlap between the acquired target signal and the estimated target signal indicates that the proposed method can estimate the target moving trajectory, velocity and magnetic moment accurately.
- 9 July 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. 62 (01962892) , 1-12
A Tracking Approach of a Moving Ferromagnetic Object Using Triaxial Search Coil Data
In this article, we propose a novel method for tracking a moving ferromagnetic object in terms of search coil data. The magnitude of the search coil data is proportional to the velocity of the moving target. By analyzing the characteristics of the search coil data, we found the movement of the ferromagnetic object converts the static magnetic field into signals with non-zero frequencies. The search coil data can provide a higher sensitivity to the model parameters than the magnetic gradient tensor data in detecting a moving magnetic object. Localization and estimation of the velocity and magnetic moment are implemented in steps due to the coupling among the object parameters. We use a least square method to estimate the trajectory of the moving object. The magnetic moment and velocity are estimated on the inferred object coordinates. A fourth-order polynomial is applied to fit the velocity curve to suppress errors from the inferred coordinates. We design three synthetic examples, with and without random noise, to validate the proposed method. The locations, velocities and magnetic moments of the moving ferromagnetic target can be well determined. The proposed method has also been applied to a field test, the strong overlap between the acquired target signal and the estimated target signal indicates that the proposed method can estimate the target moving trajectory, velocity and magnetic moment accurately.
- 17 January 2023
- Published by Springer Nature in Journal of Ocean University of China
- Vol. 22 (1) , 99-106
A Method for Reducing Ocean Wave-Induced Magnetic Noises in Shallow-Water MT Data Using a Complex Adaptive Filter
- 17 January 2023
- Published by Springer Nature in Journal of Ocean University of China
- Vol. 22 (1) , 99-106
A Method for Reducing Ocean Wave-Induced Magnetic Noises in Shallow-Water MT Data Using a Complex Adaptive Filter