Matthias Reggentin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Matthias Reggentin has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
Andrea Knigge
Ferdinand‐Braun‐Institut (FBH) Berlin Germany
3 shared publications- Jan-Philipp Koester
Ferdinand-Braun-Institut (FBH)
3 shared publications Christoph Stölmacker
Ferdinand‐Braun‐Institut (FBH) Berlin Germany
2 shared publicationsHans Wenzel
Ferdinand-Braun-Institut (FBH)
2 shared publications- Hans Wenzel
Ferdinand-Braun-Institut (FBH)
2 shared publications - Olaf Brox
Ferdinand‐Braun‐Institut (FBH) Berlin Germany
2 shared publications
Latest Publications
- Open Access
- 1 October 2024
- Published by AIP Publishing in APL Photonics
- Vol. 9 (10)
GaAs-based photonic integrated circuit platform enabling monolithic ring-resonator-coupled lasers
This paper reports on a monolithically integrated gallium arsenide (GaAs)-based photonic integrated circuit platform for wavelengths around 1064 nm. Enabled by spatially selective quantum well removal and two-step epitaxial growth, it supports on-chip gain as well as passive waveguides. In addition, shallow- and deep-etched waveguides are realized. The former result in waveguide losses of less than 2 dB/cm, while the latter enable compact integrated waveguide components. To demonstrate the performance of the platform, racetrack ring resonators based on deep-etched Euler bends and shallow-etched directional couplers are realized, achieving high intrinsic quality factors of 2.6 × 105 and 3.2 × 105 for the fundamental TE and TM mode, respectively. To demonstrate the use of these resonators, ring-resonator-coupled lasers are fabricated, resulting in one-sided output powers of up to 14 mW and single-mode operation with 40 dB side-mode suppression. The successful integration of ring resonators on a GaAs-based active/passive photonic integrated circuit platform paves the way for the realization of fully monolithic, widely tunable, and narrow linewidth ring-resonator-coupled laser sources.
- 1 October 2024
- Published by AIP Publishing in APL Photonics
- Vol. 9 (10)
Open AccessGaAs-based photonic integrated circuit platform enabling monolithic ring-resonator-coupled lasers
This paper reports on a monolithically integrated gallium arsenide (GaAs)-based photonic integrated circuit platform for wavelengths around 1064 nm. Enabled by spatially selective quantum well removal and two-step epitaxial growth, it supports on-chip gain as well as passive waveguides. In addition, shallow- and deep-etched waveguides are realized. The former result in waveguide losses of less than 2 dB/cm, while the latter enable compact integrated waveguide components. To demonstrate the performance of the platform, racetrack ring resonators based on deep-etched Euler bends and shallow-etched directional couplers are realized, achieving high intrinsic quality factors of 2.6 × 105 and 3.2 × 105 for the fundamental TE and TM mode, respectively. To demonstrate the use of these resonators, ring-resonator-coupled lasers are fabricated, resulting in one-sided output powers of up to 14 mW and single-mode operation with 40 dB side-mode suppression. The successful integration of ring resonators on a GaAs-based active/passive photonic integrated circuit platform paves the way for the realization of fully monolithic, widely tunable, and narrow linewidth ring-resonator-coupled laser sources.
- Open Access
- 8 July 2024
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 60 (13)
High‐power mode‐hop‐free tunable DFB laser at 780 nm
A distributed feedback laser with integrated quarter‐wave phase shift and more than 100 mW optical output power at an emission wavelength of 780 nm is presented. The laser provides mode‐hop‐free tuning over a wide range of injections currents and operating temperatures by design and can serve as an enabling component for more complex systems such as chips with additional monolithically integrated amplifiers, chip arrays and sources for hybrid integrated photonic circuits.
- 8 July 2024
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 60 (13)
Open AccessHigh‐power mode‐hop‐free tunable DFB laser at 780 nm
A distributed feedback laser with integrated quarter‐wave phase shift and more than 100 mW optical output power at an emission wavelength of 780 nm is presented. The laser provides mode‐hop‐free tuning over a wide range of injections currents and operating temperatures by design and can serve as an enabling component for more complex systems such as chips with additional monolithically integrated amplifiers, chip arrays and sources for hybrid integrated photonic circuits.
- 1 July 2024
- Published by Optica Publishing Group in Optics Letters
- Vol. 49 (13) , 3802-3805
Mode-hop-free tunable high-power distributed feedback laser with adaptable rear facet phase shift section emitting at 780 nm
We present a high-power ridge waveguide distributed feedback (DFB) laser with a high-reflective coating and a phase shift section at the rear facet. The phase shift section is realized by means of a micro heater that is placed parallel to the ridge waveguide and the uniform grating. This type of heater section is easy to integrate into existing laser designs and allows adjusting and controlling the spectral behavior of the distributed feedback laser by shifting the rear facet phase condition, which makes it possible to overcome the challenges of mode-hop-free tuning of regular DFB lasers with highly reflective cleaved rear facet. Accordingly, we use the device to quantify rear facet phase conditions where mode hops occur, which are compared to theory with good agreement.
- 1 July 2024
- Published by Optica Publishing Group in Optics Letters
- Vol. 49 (13) , 3802-3805
Mode-hop-free tunable high-power distributed feedback laser with adaptable rear facet phase shift section emitting at 780 nm
We present a high-power ridge waveguide distributed feedback (DFB) laser with a high-reflective coating and a phase shift section at the rear facet. The phase shift section is realized by means of a micro heater that is placed parallel to the ridge waveguide and the uniform grating. This type of heater section is easy to integrate into existing laser designs and allows adjusting and controlling the spectral behavior of the distributed feedback laser by shifting the rear facet phase condition, which makes it possible to overcome the challenges of mode-hop-free tuning of regular DFB lasers with highly reflective cleaved rear facet. Accordingly, we use the device to quantify rear facet phase conditions where mode hops occur, which are compared to theory with good agreement.
- Open Access
- 3 April 2023
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 55 (5) , 1-10
Spectral behavior of high-power distributed feedback lasers
The mode hopping behavior of high-power distributed feedback lasers emitting near $$780\,\hbox {nm}$$ is studied. The lasers have highly reflective rear and anti-reflection coated front facets. The influence of the phase of the grating at the rear facet is investigated by means of numerical simulations in the time domain taking into account spatial hole burning and self-heating effects. The simulation results are in agreement with experimental findings.- 3 April 2023
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 55 (5) , 1-10
Open AccessSpectral behavior of high-power distributed feedback lasers
The mode hopping behavior of high-power distributed feedback lasers emitting near $$780\,\hbox {nm}$$ is studied. The lasers have highly reflective rear and anti-reflection coated front facets. The influence of the phase of the grating at the rear facet is investigated by means of numerical simulations in the time domain taking into account spatial hole burning and self-heating effects. The simulation results are in agreement with experimental findings.