Anushanth Karalasingam
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Anushanth Karalasingam has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Andrea Ciavatti
Department of Physics and Astronomy, University of Bologna, Bologna, Italy
1 shared publication - Andrew J. Parnell
School of Mathematical and Physical Sciences, University of Sheffield, Sheffield, UK
1 shared publication - Andrew Nisbet
Department of Medical Physics and Biomedical Engineering, University College London, London, United Kingdom
1 shared publication - Arvydas Ruseckas
Organic Semiconductor Centre, SUPA, School of Physics and Astronomy, University of St. Andrews, St. Andrews, KY16 9SS, UK
1 shared publication - Beatrice Fraboni
University of Bologna Viale Berti Pichat 6/2
1 shared publication - Gehan A. J. Amaratunga
Electrical Engineering Division, Department of Engineering, University of Cambridge, Cambridge, UK
1 shared publication
Latest Publications
- 6 August 2024
- Published by IOP Publishing in Physica Scripta
- Vol. 99 (9) , 095915
Influence of graphene nanoplatelets on the thermal conductivity of heat transfer oils based on the developed hotwire method
The thermal conductivity measurements of graphene nanoplatelets (GNP) loaded mineral oil suspensions are obtained using an unconventional custom-made Transient Hot-Wire setup using tungsten. The presence of a few layers of graphene in the prepared GNP using a single-step ultrasonication of graphite microparticles without the use of a surfactant is verified by AFM, TEM, Raman Spectroscopy, XRD, and XPS techniques. We measured the thermal conductivity and the specific heat capacity ( C p ) of GNP-loaded mineral oil suspensions. The experimental result shows a maximum of 45.5% increment in the thermal conductivity of the mineral oil with 1 mg ml−1 (11.481 × 10 − 4 weight fraction) loading of GNP at 30 °C. Despite thermal conductivity enhancements, the results indicate that the C p is not compromised, since a low concentration of nanoplatelets was used. The experimental results agree with the Maxwell-Garnett effective medium approach (MGEMA) model for the thermal conductivity of nanofluids which we found to be suitable for lower loading of nanoparticles. We propose GNP incorporated mineral oil suspensions are effective when it comes to heat transfer fluids even with the lower volume and mass fractions.
- 6 August 2024
- Published by IOP Publishing in Physica Scripta
- Vol. 99 (9) , 095915
Influence of graphene nanoplatelets on the thermal conductivity of heat transfer oils based on the developed hotwire method
The thermal conductivity measurements of graphene nanoplatelets (GNP) loaded mineral oil suspensions are obtained using an unconventional custom-made Transient Hot-Wire setup using tungsten. The presence of a few layers of graphene in the prepared GNP using a single-step ultrasonication of graphite microparticles without the use of a surfactant is verified by AFM, TEM, Raman Spectroscopy, XRD, and XPS techniques. We measured the thermal conductivity and the specific heat capacity ( C p ) of GNP-loaded mineral oil suspensions. The experimental result shows a maximum of 45.5% increment in the thermal conductivity of the mineral oil with 1 mg ml−1 (11.481 × 10 − 4 weight fraction) loading of GNP at 30 °C. Despite thermal conductivity enhancements, the results indicate that the C p is not compromised, since a low concentration of nanoplatelets was used. The experimental results agree with the Maxwell-Garnett effective medium approach (MGEMA) model for the thermal conductivity of nanofluids which we found to be suitable for lower loading of nanoparticles. We propose GNP incorporated mineral oil suspensions are effective when it comes to heat transfer fluids even with the lower volume and mass fractions.
- Open Access
- 2 November 2023
- Published by Wiley in Advanced Science
- Vol. 10 (35) , e2304261
Tissue Equivalent Curved Organic X‐ray Detectors Utilizing High Atomic Number Polythiophene Analogues
Organic semiconductors are a promising material candidate for X‐ray detection. However, the low atomic number (Z) of organic semiconductors leads to poor X‐ray absorption thus restricting their performance. Herein, the authors propose a new strategy for achieving high‐sensitivity performance for X‐ray detectors based on organic semiconductors modified with high –Z heteroatoms. X‐ray detectors are fabricated with p‐type organic semiconductors containing selenium heteroatoms (poly(3‐hexyl)selenophene (P3HSe)) in blends with an n‐type fullerene derivative ([6,6]‐Phenyl C71 butyric acid methyl ester (PC70BM). When characterized under 70, 100, 150, and 220 kVp X‐ray radiation, these heteroatom‐containing detectors displayed a superior performance in terms of sensitivity up to 600 ± 11 nC Gy−1 cm−2 with respect to the bismuth oxide (Bi2O3) nanoparticle (NP) sensitized organic detectors. Despite the lower Z of selenium compared to the NPs typically used, the authors identify a more efficient generation of electron‐hole pairs, better charge transfer, and charge transport characteristics in heteroatom‐incorporated detectors that result in this breakthrough detector performance. The authors also demonstrate flexible X‐ray detectors that can be curved to a radius as low as 2 mm with low deviation in X‐ray response under 100 repeated bending cycles while maintaining an industry‐standard ultra‐low dark current of 0.03 ± 0.01 pA mm−2.
- 2 November 2023
- Published by Wiley in Advanced Science
- Vol. 10 (35) , e2304261
Open AccessTissue Equivalent Curved Organic X‐ray Detectors Utilizing High Atomic Number Polythiophene Analogues
Organic semiconductors are a promising material candidate for X‐ray detection. However, the low atomic number (Z) of organic semiconductors leads to poor X‐ray absorption thus restricting their performance. Herein, the authors propose a new strategy for achieving high‐sensitivity performance for X‐ray detectors based on organic semiconductors modified with high –Z heteroatoms. X‐ray detectors are fabricated with p‐type organic semiconductors containing selenium heteroatoms (poly(3‐hexyl)selenophene (P3HSe)) in blends with an n‐type fullerene derivative ([6,6]‐Phenyl C71 butyric acid methyl ester (PC70BM). When characterized under 70, 100, 150, and 220 kVp X‐ray radiation, these heteroatom‐containing detectors displayed a superior performance in terms of sensitivity up to 600 ± 11 nC Gy−1 cm−2 with respect to the bismuth oxide (Bi2O3) nanoparticle (NP) sensitized organic detectors. Despite the lower Z of selenium compared to the NPs typically used, the authors identify a more efficient generation of electron‐hole pairs, better charge transfer, and charge transport characteristics in heteroatom‐incorporated detectors that result in this breakthrough detector performance. The authors also demonstrate flexible X‐ray detectors that can be curved to a radius as low as 2 mm with low deviation in X‐ray response under 100 repeated bending cycles while maintaining an industry‐standard ultra‐low dark current of 0.03 ± 0.01 pA mm−2.