FMFariza Murtazina

Fariza Murtazina

*This is an algorithmically generated author record based on publicly available information.

Fariza Murtazina has a total of 10 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • ТЕХНОЛОГИЯ ПОВЫШЕНИЯ КАЧЕСТВА УГЛЯ ШУБАРКОЛЬСКОГО МЕСТОРОЖДЕНИЯ

    by Ж.м. Асанова, Ф. Муртазина, Н.н. Немова, Р.а. Мусин

    В статье рассматриваются результаты исследований по управлению качеством угля месторождения Шубарколь. Объект работы – пласты 2V и 1V, характеризующиеся низкой зольностью и высокой теплотворной способностью. Основное внимание уделено применению циклично-поточной технологии, селективной выемки и пневмосепарации. Установлено, что внедрение данных технологий позволяет снизить вариацию зольности, обеспечить более равномерное усреднение угольной массы и повысить коэффициент извлечения. Испытания установок сухой пневмосепарации подтвердили возможность снижения зольности до 9–11% при выходе концентрата до 60%. Дополнительным преимуществом является брикетирование угольной мелочи, что обеспечивает полное использование сырья и улучшает экологию. Экономика показывает, что внедрение комплекса технологий увеличивает рыночную стоимость угля более чем в 2 раза и снижает себестоимость на 15–20% Мақалада Шұбаркөл кен орнындағы көмір сапасын басқару зерттеулерінің нәтижелері қарастырылған. Зерттеу нысаны – төмен күлділігі және жоғары жылу сыйымдылығымен ерекшеленетін 2V және 1V қабаттары. Негізгі назар циклдік-ағын технологиясын, селективті өндіруді және пневмосепарацияны қолдануға аударылған. Бұл технологияларды енгізу күлдік көрсеткішті азайтуға, көмір массасының біркелкілігіне қол жеткізуге және өндіру коэффициентін арттыруға мүмкіндік беретіні анықталды. Құрғақ пневмосепарация қондырғыларын сынау кезінде концентраттың түсімі 60%-ға дейін болғанда күлдік 9–11%-ға дейін төмендейтіні расталды. Тиімділікті арттырудың қосымша жолы – көмір ұнтағын брикеттеу, бұл шикізатты толық пайдалануға мен экологияны жақсартуға мүмкіндік береді. Экономикалық есептеулер бойынша, технологиялар кешенін енгізу көмірдің құнын 2 еседен астам арттырып, өзіндік құнын 15–20%-ға төмендетеді The article presents research results on coal quality management at the Shubarkol deposit. The study focuses on seams 2V and 1V, characterized by low ash content and high calorific value. Main attention is given to the application of cyclic-flow technology, selective mining, and pneumatic separation. It was found that implementing these technologies reduces ash variability, ensures more uniform coal mass homogenization, and increases the recovery rate. Tests of dry pneumatic separation units confirmed the possibility of reducing ash content to 9–11% with a concentrate yield of up to 60%. An additional advantage is briquetting fine coal, which ensures full raw material utilization and improves environmental performance. Economic analysis shows that introducing the technology complex more than doubles the coal’s market value and reduces production costs by 15–20%

  • Integrated geophysical assessment of coal mass structural weakening zones for optimization of drilling-blasting operations and coal size control

    by Ravil’ Mussin, Piotr Małkowski, Fariza Murtazina, Ainash Kainazarova, Denis Akhmatnurov, Nail’ Zamaliyev, Dinara Doni

    Purpose. The purpose of this research is to develop a scientifically sound system for managing the coarse-grained raw coal at JSC Shubarkol Komir enterprise based on comprehensive geophysical diagnostics of structural weakening and fracturing zones in coal seams. The research aims at improving the efficiency of drilling-blasting operations, reducing the proportion of fines and ensuring the stability of quarry benches through the use of geophysical rock mass state indicators. Methods. The research was performed using a set of geophysical methods, including electrical resistivity prospecting using the Electrical Tomography (ERT) method, electrical prospecting using the Mean Gradient (MG) installation, seismic prospec-ting using refracted waves (Refraction Seismic, RS) method, Spectral Seismic Profiling (SSP), ground-penetrating radar (GPR) surveying and radonometry (emanation surveying). Complex data interpretation was performed using 3D modeling of the specific electrical resistance (ρ) and longitudinal wave velocity (Vₚ) distributions, as well as statistical analysis of correlations between ρ, Vₚ and C(Rn) parameters. Findings. It has been found that a decrease in specific electrical resistance below 60-100 Ohm·m and a decrease in longitudinal wave velocities below 1500-1800 m/s reliably reflect the development of fracturing and loosening of the rock mass. Radon concentration increases by 1.5-2 times in the same zones, confirming their tectonic activity. ERT and MG methods are recognized as basic for diagnosing weakened zones, RS method – as a calibration method, radonometry – as a verification method, and SSP and GPR methods – as methods that are limited in their applicability in conditions of high water content. Originality. For the first time for the Shubarkol deposit, a comprehensive methodology for cross-spectrum analysis of electrical, seismic and radiation parameters has been developed and tested, providing a quantitative assessment of the geomechanical state of the mass and a prediction of its structural changes. Practical implications. The implementation of the proposed methodology allows for the identification of weakening zones with an accuracy of ±5 m in depth and ±10 m along the strike, the adjustment of parameters of drilling-blasting operations, a 3-5% reduction in the proportion of fine material (< 6 mm), and an increase in the stability of quarry benches.


  • Электротомография әдістемесі бойынша қарсылық әдісімен электрбарлауды зерттеу нәтижелері

    by Р.а. Мусин, Ф.е. Муртазина, Ж.м. Асанова, Э.р. Халикова

    Настоящая статья посвящена разработке методики дифференциации и ранжирования угольных блоков по степени структурного ослабления и повышенной трещиноватости в природных и технологических условиях разрезов АО «Шубарколь Комир». Предлагается исследование электроразведкой методом сопротивлений по методике электротомографии, которые дают возможность определять пространственные параметры зон структурного ослабления и повышенной трещиноватости угля. В данной статье представлены результаты электротомографии, проведенные установками Шлюмберже и дипольной осевой на экспериментальном блоке №1, 2В чистый «Запад», разрезы УЭС по профилю 06, 05, 04 по пласту 2В с прослоями на участке центрального карьера, разрезы УЭС по профилю 07, 08, 09 участка №3 1В2 с «Центр», разрезы УЭС по профилю 03 по пласту 2В Берма на участке центрального карьера Осы мақала «Шұбаркөл Көмір» АҚ қималарының табиғи және технологиялық жағдайларында құрылымдық әлсіреу және жарықтың жоғарылау дәрежесі бойынша көмір блоктарын саралау және саралау әдістемесін әзірлеуге арналған. Зерттеу электротомография әдістемесі бойынша кедергілер әдісімен электро барлау арқылы ұсынылады, бұл құрылымдық әлсіреу аймақтарының кеңістіктік параметрлерін және көмірдің жарылуының жоғарылауын анықтауға мүмкіндік береді. Бұл мақалада №1, 2в таза «Батыс» эксперименттік блогында Шлюмберже және дипольдік осьтік қондырғылармен жүргізілген электротомография нәтижелері, орталық Карьер учаскесінде қабаттары бар 2В қабаты бойынша МЭК қималары, «Орталық» с №3 1В2 учаскесінің 07, 08, 09 бейіні бойынша МЭК қималары ұсынылған, орталық Карьер учаскесіндегі 2В берма қабаты бойынша 03-профиль бойынша УЭС кесінділері This article is devoted to the development of a methodology for differentiating and ranking coal blocks according to the degree of structural weakening and increased fracturing in the natural and technological conditions of the sections of JSC «Shubarkol Komir». The study is proposed by electrical exploration, by the method of resistances according to the method of electrotomography, which make it possible to determine the spatial parameters of zones of structural weakening and increased fracturing of coal. This article presents the results of electrotomography carried out by Schlumberger and dipole axial installations on the experimental block №1, 2V pure «West», sections of the UES along the profile 06, 05, 04 along the 2V formation with interlayers on the site of the central quarry, sections of the UES along the profile 07, 08, 09 of the site №3 1V2 with «Center», sections of the UES according to profile 03 along the 2V Berm formation at the site of the central quarry