MPMarie Palla

Marie Palla

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Marie Palla has a total of 10 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Acoustic transparency and absorption in dense granular suspensions

    by Arnaud Tourin, Yamil Abraham, Marie Palla, Arthur Le Ber, Romain Pierrat, Nicolas Benech, Carlos Negreira, Xiaoping Jia

    We demonstrate the existence of a frequency band exhibiting acoustic transparency in two- and three-dimensional dense granular suspensions, enabling the transmission of a low-frequency ballistic wave excited by a high-frequency broadband ultrasound pulse. This phenomenon is attributed to spatial correlations in the structural disorder of the medium. To support this interpretation, we use an existing model that incorporates such correlations via the structure factor. Its predictions are shown to agree well with those of the generalized coherent potential approximation (GCPA) model, which is known to apply at high volume fractions, including the close packing limit, but does not explicitly account for disorder correlation. Within the transparency band, attenuation is found to be dominated by absorption rather than scattering. Measurements of the frequency dependence of the absorption coefficient reveal significant deviations from conventional models, challenging the current understanding of acoustic absorption in dense granular media.


  • Open Access

    Numerical modeling of the coupled heat transfer and ultrasonic time of flight during monitoring of a laser powder bed fusion process

    by M. Palla, F. Le Bourdais, G. Roux, J. P. Garandet

    This paper proposes a numerical model coupling heat transfer and ultrasonic time of flight (TOF) phenomena within the Laser Powder Bed Fusion (LPBF) process. A three-dimensional layer scale thermal model is developed to simulate the temperature field evolution during the LPBF process, considering the laser energy input, heat conduction, and convection heat transfer. A TOF model is developed based on the measured velocity of the ultrasonic wave in the materials involved, taking into account the temperature-dependent variations of the wave velocity in the plate and the part by coupling it to the thermal model output. The models are calibrated using experimental data from an aluminum part manufactured in a Farsoon FS271M LPBF machine. The experimental data consist of IR camera images of the part surface temperature, thermocouple measurements on the back plate, and TOF measurements throughout the process. The numerical simulations are compared with the experimental data to assess the model's accuracy and identify key parameters affecting the heat transfer and ultrasonic wave propagation. This work provides a framework for understanding the relationships between the temperature field, the TOF signal, and the LPBF process parameters, paving the way for improved process control and monitoring strategies.


  • Open Access

    On the potential of ultrasonic time of flight instrumentation for the monitoring of thermal phenomena in laser powder bed fusion

    by M. Palla, F. Le Bourdais, J. P. Garandet

    The present paper describes a proof of concept showing the ability of ultrasound time of flight measurements to complement existing temperature measurements in a laser powder bed fusion additive manufacturing process. To this end, two printers (a 3D Systems ProX DMP 320 and a Farsoon FS 271M) were instrumented with ultrasonic transducers, as well as with thermal cameras and thermocouples. The obtained results show that the time of flight signals can provide information that is both consistent and complementary with the data from the standard thermal camera and thermocouple systems. Such a conclusion is shown to be valid at both the macroscopic (i.e., whole fabrication) and the microscopic (individual layer melting and solidification) time scales. The present work shows that ultrasound time of flight data are a useful in situ diagnostic measurement. In addition, we discuss how it could be used for the validation of layer scale numerical models of the thermal phenomena during the printing process.