Guizhen Tian
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Guizhen Tian has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Guangchen Liu
School of Electric Power, Inner Mongolia University of Technology, Hohhot 010080, China
3 shared publications - Jianwei Zhang
College of Electric Power Inner Mongolia University of Technology Hohhot China
2 shared publications Huidong Wang
College of Electric Power, Inner Mongolia University of Technology, Hohhot, China
1 shared publication- Junhao Cui
Shien-Ming Wu School of Intelligent Engineering, South China University of Technology, Guangzhou, Guangdong, China
1 shared publication - Marco Rivera
University of Nottingham
1 shared publication - Patrick Wheeler
University of Nottingham
1 shared publication
Latest Publications
- Open Access
- 1 August 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 12, 106672-106684
Virtual Synchronous Generator Control Strategy of Grid-Forming Matrix Converter for Renewable Power Generation
Matrix converters (MC) have been considered for applications in renewable power generation and microgrids. However, similar to other power electronic converter-interfaced power generation systems, the MC-interfaced system cannot provide inertia or damping effect to support the grid’s frequency or voltage. To improve the inertia and damping effect of the MC-interfaced distributed generation system and realize the grid-friendly connection of new energy power generation, a virtual synchronous generator (VSG) control strategy suitable for the MC-interfaced system is proposed. Aiming at the problem that the system frequency in the traditional VSG cannot be restored to the nominal value after the load power fluctuations, the VSG secondary frequency control strategy is introduced. To ensure a smooth grid connection, a synchronization control strategy based on virtual power has been designed. An experimental validation platform was built and the experimental results verify the correctness and effectiveness of the proposed control strategies for a grid-forming MC.
- 1 August 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 12, 106672-106684
Open AccessVirtual Synchronous Generator Control Strategy of Grid-Forming Matrix Converter for Renewable Power Generation
Matrix converters (MC) have been considered for applications in renewable power generation and microgrids. However, similar to other power electronic converter-interfaced power generation systems, the MC-interfaced system cannot provide inertia or damping effect to support the grid’s frequency or voltage. To improve the inertia and damping effect of the MC-interfaced distributed generation system and realize the grid-friendly connection of new energy power generation, a virtual synchronous generator (VSG) control strategy suitable for the MC-interfaced system is proposed. Aiming at the problem that the system frequency in the traditional VSG cannot be restored to the nominal value after the load power fluctuations, the VSG secondary frequency control strategy is introduced. To ensure a smooth grid connection, a synchronization control strategy based on virtual power has been designed. An experimental validation platform was built and the experimental results verify the correctness and effectiveness of the proposed control strategies for a grid-forming MC.
- Open Access
- 9 June 2022
- Published by Elsevier in Energy Reports
- Vol. 8, 893-899
Research on coordinated control strategy of isolated DC microgrid with PV/hybrid energy storage
- 9 June 2022
- Published by Elsevier in Energy Reports
- Vol. 8, 893-899
Open AccessResearch on coordinated control strategy of isolated DC microgrid with PV/hybrid energy storage
- 7 May 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 432-436
SOC Balancing Control Strategy Based on Piecewise Adaptive Droop Coefficient Algorithm for Multi-energy Storage Units in DC Microgrid
In order to achieve the state of charge (SOC) balancing among multiple energy storage units in an islanded DC microgrid, the SOC balancing control strategy of multi-energy storage based on a piecewise adaptive droop coefficient algorithm is proposed. The proposed algorithm dynamically adjusts the droop coefficient according to the lithium battery SOC deviation. When the SOC deviation is large, the droop coefficient is adjusted so that the lithium battery that has a high (low) SOC when discharging (charging) is discharged (charged) with the maximum power. Simultaneously, another lithium battery is controlled to make up the remaining power, so the SOC balancing is accelerated. When the SOC deviation is small, the droop coefficient is optimized based on the different line impedance and the real capacity to realize the SOC balancing control. The voltage automatic recovery control is adopted to realize the non-difference of bus voltage and stabilize the bus voltage and improve the power supply quality. Finally, simulation is implemented in MATLAB/Simulink for verification. The simulation results show that the proposed control strategy can rapidly balance the SOC of multiple energy storage units and maintain the stability of the bus voltage.
- 7 May 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 432-436
SOC Balancing Control Strategy Based on Piecewise Adaptive Droop Coefficient Algorithm for Multi-energy Storage Units in DC Microgrid
In order to achieve the state of charge (SOC) balancing among multiple energy storage units in an islanded DC microgrid, the SOC balancing control strategy of multi-energy storage based on a piecewise adaptive droop coefficient algorithm is proposed. The proposed algorithm dynamically adjusts the droop coefficient according to the lithium battery SOC deviation. When the SOC deviation is large, the droop coefficient is adjusted so that the lithium battery that has a high (low) SOC when discharging (charging) is discharged (charged) with the maximum power. Simultaneously, another lithium battery is controlled to make up the remaining power, so the SOC balancing is accelerated. When the SOC deviation is small, the droop coefficient is optimized based on the different line impedance and the real capacity to realize the SOC balancing control. The voltage automatic recovery control is adopted to realize the non-difference of bus voltage and stabilize the bus voltage and improve the power supply quality. Finally, simulation is implemented in MATLAB/Simulink for verification. The simulation results show that the proposed control strategy can rapidly balance the SOC of multiple energy storage units and maintain the stability of the bus voltage.
- 1 October 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Power quality and transient stability improvement of wind farm with fixed-speed induction generators using a STATCOM
This paper investigates the use of a static synchronous compensator (STATCOM) to mitigate the voltage fluctuations and improve fault ride-through capability of wind farm with fixed speed induction generators. In order to assure STATCOM of running safely and reliably in both normal and faulty conditions, a novel control strategy which combines negative-sequence voltage feed-forward control with conventional vector control is proposed to make the negative sequence current of STATCOM zero and effectively suppress STATCOM overcurrent. The positive-sequence and negative-sequence components of the voltage at point of common coupling (PCC) are obtained quickly and accurately by the specially designed double synchronous reference frame phase locked loop (DSRF PLL). The simulation results show that the STATCOM not only significantly improves the power quality, but also enhances fault ride-through capability of wind farm. It is also concluded from the simulation results that the proposed control strategy can effectively suppress STATCOM overcurrent and guarantee that STATCOM can operate safely even in abnormal conditions.
- 1 October 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Power quality and transient stability improvement of wind farm with fixed-speed induction generators using a STATCOM
This paper investigates the use of a static synchronous compensator (STATCOM) to mitigate the voltage fluctuations and improve fault ride-through capability of wind farm with fixed speed induction generators. In order to assure STATCOM of running safely and reliably in both normal and faulty conditions, a novel control strategy which combines negative-sequence voltage feed-forward control with conventional vector control is proposed to make the negative sequence current of STATCOM zero and effectively suppress STATCOM overcurrent. The positive-sequence and negative-sequence components of the voltage at point of common coupling (PCC) are obtained quickly and accurately by the specially designed double synchronous reference frame phase locked loop (DSRF PLL). The simulation results show that the STATCOM not only significantly improves the power quality, but also enhances fault ride-through capability of wind farm. It is also concluded from the simulation results that the proposed control strategy can effectively suppress STATCOM overcurrent and guarantee that STATCOM can operate safely even in abnormal conditions.