Kyaw Win
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Kyaw Win has a total of 39 co-authors. Here are the top co-authors by number of shared publications:
- Naoyuki Furuya
Forestry and Forest Products Research Institute, 1 Matsunosato, Tsukuba 305-8687, Ibaraki, Japan
4 shared publications - Nyein Chan
Kyoto University of Advanced Science Kyoto Japan
4 shared publications - Shinya Tanaka
Forestry and Forest Products Research Institute, 1 Matsunosato, Tsukuba 305-8687, Ibaraki, Japan
3 shared publications Eiji Kodani
2 shared publications- Eiji Kodani
Forestry and Forest Products Research Institute, 1 Matsunosato, Tsukuba 305-8687, Ibaraki, Japan
2 shared publications - Hideki Saito
Forestry and Forest Products Research Institute, 1 Matsunosato, Tsukuba 305-8687, Japan
2 shared publications
Latest Publications
- Open Access
Application of UAV-LiDAR Data for Assessing Forest Canopy Height Variations Across Forest Types and Topography
Understanding forest canopy height (H) variations across different forest types and topographic conditions is essential for sustainable forest management; however, quantitative information on how H varies among forest types and responds to topographic factors remains limited. This study investigated H variations among forest types and their relationships with topographic factors using UAV-LiDAR data. Digital surface and elevation models (DSM and DEM) were generated from UAV-LiDAR data, and a digital canopy height model (DCHM) was calculated by subtracting DEM from DSM. Individual treetops were detected using the local maxima algorithm, and H was extracted from the corresponding DCHM values. Differences in H among forest types were evaluated using Kruskal–Wallis test followed by Dunn’s post hoc test. Generalized additive model and random forest model were applied to examine the influence of topographic factors on H. A total of 26,886 individual trees were detected, with broadleaf-dominated natural forest accounting for the largest proportion (42.9%). H differed significantly among forest types, although no significant difference was observed between the larch and Pinus strobus plantation. The influence of topographic variables on H varied among forest types. Elevation was the most influential predictor in three of four forest types, whereas slope was the dominant predictor in the larch plantation. In contrast, topographic position index exhibited the lowest importance across all forest types. The findings demonstrate an effective application of UAV-LiDAR data for assessing H variations and understanding forest-type-specific responses to topographic conditions, thereby providing scientific references for sustainable forest management.
Open AccessApplication of UAV-LiDAR Data for Assessing Forest Canopy Height Variations Across Forest Types and Topography
Understanding forest canopy height (H) variations across different forest types and topographic conditions is essential for sustainable forest management; however, quantitative information on how H varies among forest types and responds to topographic factors remains limited. This study investigated H variations among forest types and their relationships with topographic factors using UAV-LiDAR data. Digital surface and elevation models (DSM and DEM) were generated from UAV-LiDAR data, and a digital canopy height model (DCHM) was calculated by subtracting DEM from DSM. Individual treetops were detected using the local maxima algorithm, and H was extracted from the corresponding DCHM values. Differences in H among forest types were evaluated using Kruskal–Wallis test followed by Dunn’s post hoc test. Generalized additive model and random forest model were applied to examine the influence of topographic factors on H. A total of 26,886 individual trees were detected, with broadleaf-dominated natural forest accounting for the largest proportion (42.9%). H differed significantly among forest types, although no significant difference was observed between the larch and Pinus strobus plantation. The influence of topographic variables on H varied among forest types. Elevation was the most influential predictor in three of four forest types, whereas slope was the dominant predictor in the larch plantation. In contrast, topographic position index exhibited the lowest importance across all forest types. The findings demonstrate an effective application of UAV-LiDAR data for assessing H variations and understanding forest-type-specific responses to topographic conditions, thereby providing scientific references for sustainable forest management.
- Open Access
Application of Photogrammetric Software for Digital Canopy Height Modelling from Old Aerial Photographs
Accurate digital canopy height models (DCHMs) derived from historical aerial photographs are essential for reconstructing long-term forest structural dynamics; however, the influence of photogrammetric software on DCHM quality and reliability remains insufficiently evaluated. This study compared the performance of two structure-from-motion (SfM) photogrammetric platforms, Metashape and Pix4Dmatic, for processing old aerial photographs and generating DCHMs in Ishikawa prefecture. Software performance was assessed using image processing efficiency, geometric accuracy based on root mean square error (RMSE), and correlation between derived DCHMs and National Forest Inventory (NFI) measurements. The results revealed that Metashape required shorter image processing times for the digital surface model generation and produced denser point clouds with broader spatial coverage. By contrast, Pix4Dmatic achieved higher geometric accuracy, with RMSE values of 0.571 m, 0.870 m, and 2.120 m in the X, Y, and Z directions, respectively. The Metashape-derived DCHM showed a higher mean value (15.267 ± 5.882 m) than Pix4Dmatic (14.749 ± 5.834 m), but Pix4Dmatic-generated DCHMs showed a closer relationship (r = 0.880) with NFI data (15.322 ± 5.451 m). These findings demonstrate that photogrammetric software selection substantially influences three-dimensional reconstruction from old aerial imagery and affects the reliability of DCHM generation. This study provides practical guidance for selecting SfM software for forest structural analysis and long-term forest monitoring.
Open AccessApplication of Photogrammetric Software for Digital Canopy Height Modelling from Old Aerial Photographs
Accurate digital canopy height models (DCHMs) derived from historical aerial photographs are essential for reconstructing long-term forest structural dynamics; however, the influence of photogrammetric software on DCHM quality and reliability remains insufficiently evaluated. This study compared the performance of two structure-from-motion (SfM) photogrammetric platforms, Metashape and Pix4Dmatic, for processing old aerial photographs and generating DCHMs in Ishikawa prefecture. Software performance was assessed using image processing efficiency, geometric accuracy based on root mean square error (RMSE), and correlation between derived DCHMs and National Forest Inventory (NFI) measurements. The results revealed that Metashape required shorter image processing times for the digital surface model generation and produced denser point clouds with broader spatial coverage. By contrast, Pix4Dmatic achieved higher geometric accuracy, with RMSE values of 0.571 m, 0.870 m, and 2.120 m in the X, Y, and Z directions, respectively. The Metashape-derived DCHM showed a higher mean value (15.267 ± 5.882 m) than Pix4Dmatic (14.749 ± 5.834 m), but Pix4Dmatic-generated DCHMs showed a closer relationship (r = 0.880) with NFI data (15.322 ± 5.451 m). These findings demonstrate that photogrammetric software selection substantially influences three-dimensional reconstruction from old aerial imagery and affects the reliability of DCHM generation. This study provides practical guidance for selecting SfM software for forest structural analysis and long-term forest monitoring.
- Open Access
Evaluation of orthophoto accuracy from old aerial photographs using various image digitization techniques
- 5 December 2025
- Published by Elsevier in Women's Studies International Forum
- Vol. 115
Toward gender-responsive forest governance and climate actions in Myanmar: Insights from a systematic review
- 5 December 2025
- Published by Elsevier in Women's Studies International Forum
- Vol. 115
Toward gender-responsive forest governance and climate actions in Myanmar: Insights from a systematic review
- 25 November 2025
- Published by Taylor & Francis in Landscape Research
- Vol. 51 (7) , 1567-1586
Gender dynamics in forest governance and climate adaptation: evidence from Myanmar
- 25 November 2025
- Published by Taylor & Francis in Landscape Research
- Vol. 51 (7) , 1567-1586
Gender dynamics in forest governance and climate adaptation: evidence from Myanmar
- Open Access
- 7 April 2025
- Published by Elsevier in Soil Advances
- Vol. 3
Applicability of remote sensing and machine learning for predicting bulk soil electrical conductivity under different forest types in central Japan
- 7 April 2025
- Published by Elsevier in Soil Advances
- Vol. 3
Open AccessApplicability of remote sensing and machine learning for predicting bulk soil electrical conductivity under different forest types in central Japan
- Open Access
- 11 October 2024
- Published by Elsevier in Trees, Forests and People
- Vol. 18
Influence of stand characteristics and management activities on aboveground carbon storage in Japanese cedar and cypress plantations: Sustainable management implications
- 11 October 2024
- Published by Elsevier in Trees, Forests and People
- Vol. 18
Open AccessInfluence of stand characteristics and management activities on aboveground carbon storage in Japanese cedar and cypress plantations: Sustainable management implications
- 26 September 2024
- Published by Elsevier in Environmental Development
- Vol. 52
Climate change, livelihood resilience, and gender: An intersectional analysis of Vietnam's forest-dependent communities
- 26 September 2024
- Published by Elsevier in Environmental Development
- Vol. 52
Climate change, livelihood resilience, and gender: An intersectional analysis of Vietnam's forest-dependent communities