Gorka Barquero-Carmona
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Gorka Barquero-Carmona has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Felix Antonio Lopez
University of Valladolid
6 shared publications - Olga Rodríguez
Centro Nacional de Investigaciones Metalúrgicas (CENIM-CSIC), Madrid, Spain
6 shared publications - Lorena Alcaraz
Centro Nacional de Investigaciones Metalúrgicas (CENIM), Consejo Superior de Investigaciones Científicas (CSIC), Avda. Gregorio del Amo, 8, 28040 Madrid, Spain
5 shared publications - Maria Isabel Martín
Centro Nacional de Investigaciones Metalúrgicas (CENIM-CSIC), Avda. Gregorio del Amo, 8, 28040 Madrid, Spain
2 shared publications - María Lourdes Rodríguez
Centro Nacional de Investigaciones Metalúrgicas (CENIM-CSIC), Avda. Gregorio del Amo, 8, 28040 Madrid, Spain
2 shared publications - Adrián Quesada
Instituto de Cerámica y Vidrio (ICV), Consejo Superior de Investigaciones Científicas (CSIC), Calle Kelsen 5, 28049 Madrid, Spain
1 shared publication
Latest Publications
- Open Access
Recovery and Purity Trade-Off in Nd/Ho Separation from Real NdFeB Magnet Leachates
The growing demand for electric vehicles has increased the need for rare earth elements (REEs), promoting the recycling of secondary sources such as end-of-life NdFeB permanent magnets. However, the selective separation of REEs with similar chemical properties, such as neodymium (Nd) and holmium (Ho), remains a major challenge. In this work, their separation from a real NdFeB permanent magnet leachate was investigated by liquid–liquid extraction using di-(2-ethylhexyl) phosphoric acid (D2EHPA) as an extractant. The effects of extractant concentration (0.05 M and 0.1 M), organic-to-aqueous phase ratio (1:1 and 2:1, O:A), and pH (0.6 and 2) on the extraction process were evaluated. Increasing extractant concentration and phase ratio improved Ho extraction, reaching above 90%, whereas Nd co-extraction remained relatively low at pH 0.6 (0.8–4.6%, depending on the conditions). However, pH was found to be the key parameter. At pH 2, Ho extraction exceeded 96% in all cases, while Nd co-extraction increased significantly (up to ~28%), reducing selectivity. Due to the high initial Nd:Ho concentration ratio (~12:1), even low Nd co-extraction percentages resulted in significant contamination of Ho-rich products, identifying product purity as the primary limiting factor. These results show a trade-off between recovery and selectivity, with low pH favoring selectivity and high pH favoring extraction efficiency.
Open AccessRecovery and Purity Trade-Off in Nd/Ho Separation from Real NdFeB Magnet Leachates
The growing demand for electric vehicles has increased the need for rare earth elements (REEs), promoting the recycling of secondary sources such as end-of-life NdFeB permanent magnets. However, the selective separation of REEs with similar chemical properties, such as neodymium (Nd) and holmium (Ho), remains a major challenge. In this work, their separation from a real NdFeB permanent magnet leachate was investigated by liquid–liquid extraction using di-(2-ethylhexyl) phosphoric acid (D2EHPA) as an extractant. The effects of extractant concentration (0.05 M and 0.1 M), organic-to-aqueous phase ratio (1:1 and 2:1, O:A), and pH (0.6 and 2) on the extraction process were evaluated. Increasing extractant concentration and phase ratio improved Ho extraction, reaching above 90%, whereas Nd co-extraction remained relatively low at pH 0.6 (0.8–4.6%, depending on the conditions). However, pH was found to be the key parameter. At pH 2, Ho extraction exceeded 96% in all cases, while Nd co-extraction increased significantly (up to ~28%), reducing selectivity. Due to the high initial Nd:Ho concentration ratio (~12:1), even low Nd co-extraction percentages resulted in significant contamination of Ho-rich products, identifying product purity as the primary limiting factor. These results show a trade-off between recovery and selectivity, with low pH favoring selectivity and high pH favoring extraction efficiency.
- Open Access
- 28 June 2026
- Published by Elsevier in Journal of Power Sources
- Vol. 690
Semi-continuous pilot-scale validation of an integrated pyro–hydrometallurgical process for lithium-ion battery black mass recycling
- 28 June 2026
- Published by Elsevier in Journal of Power Sources
- Vol. 690
Open AccessSemi-continuous pilot-scale validation of an integrated pyro–hydrometallurgical process for lithium-ion battery black mass recycling
- Open Access
Co(II) Recovery from Hydrochloric Acid Solution Using Menthol-Based Deep Eutectic Solvents (DESs): Application to NMC Battery Recycling
Lithium-ion batteries are essential to ensure electric mobility and reduce CO2 emissions from transportation. One of the most commonly used chemistries is nickel–cobalt–manganese (NMC) batteries, which also have applications beyond the automotive sector. The recycling of these batteries requires the development of technologies to enable the selective separation and recovery of the metals present in the battery. One of these selective technologies involves the use of deep eutectic solvents (DESs). This research study investigates the different parameters that influence the recovery of Co(II) from hydrochloric acid medium using the deep eutectic solvent 3 Aliquat 336:7 L-Menthol. Firstly, using synthetic Co(II) solutions, the parameters influencing the cobalt extraction process are examined, and then these optimal conditions are applied to the recovery of cobalt from solutions obtained by dissolving NMC 622 battery black mass in 10 M HCl. The obtained results show that the DES used is highly selective for Co(II) recovery compared to other metals present in the solution (Ni, Li and Mn), achieving recoveries of up to 90% of the cobalt initially present in solution. Stripping with H2SO4 0.5 M allows the recovery of cobalt as a crystalline monohydrate salt (CoSO4.H2O). The optimization of the Co/Cu separation conditions is carried out, achieving the separation of Cu(II) using Aliquat 336 in kerosene.
Open AccessCo(II) Recovery from Hydrochloric Acid Solution Using Menthol-Based Deep Eutectic Solvents (DESs): Application to NMC Battery Recycling
Lithium-ion batteries are essential to ensure electric mobility and reduce CO2 emissions from transportation. One of the most commonly used chemistries is nickel–cobalt–manganese (NMC) batteries, which also have applications beyond the automotive sector. The recycling of these batteries requires the development of technologies to enable the selective separation and recovery of the metals present in the battery. One of these selective technologies involves the use of deep eutectic solvents (DESs). This research study investigates the different parameters that influence the recovery of Co(II) from hydrochloric acid medium using the deep eutectic solvent 3 Aliquat 336:7 L-Menthol. Firstly, using synthetic Co(II) solutions, the parameters influencing the cobalt extraction process are examined, and then these optimal conditions are applied to the recovery of cobalt from solutions obtained by dissolving NMC 622 battery black mass in 10 M HCl. The obtained results show that the DES used is highly selective for Co(II) recovery compared to other metals present in the solution (Ni, Li and Mn), achieving recoveries of up to 90% of the cobalt initially present in solution. Stripping with H2SO4 0.5 M allows the recovery of cobalt as a crystalline monohydrate salt (CoSO4.H2O). The optimization of the Co/Cu separation conditions is carried out, achieving the separation of Cu(II) using Aliquat 336 in kerosene.
- Open Access
- 22 September 2025
- Published by MDPI AG in Preprints.org
Co(II) Recovery from Hydrochloric Acid Solution Using Menthol-based Deep Eutectic Solvents (DESs): Application to NMC Battery Recycling
Lithium-ion batteries are essential to ensure electric mobility and reduce CO2 emissions from transportation. One of the most commonly used chemistries is nick-el-cobalt-manganese (NMC) batteries, which also have applications beyond the automo-tive sector. The recycling of these batteries requires the development of technologies that allow for the selective separation and recovery of the metals present in the battery. One of these selective technologies involves the use of deep eutectic solvents (DESs). This research study investigates the different parameters affecting the recovery of Co(II) in hydrochloric acid medium using the deep eutectic solvent 3 Aliquat 336:7 L-Menthol. Firstly, using synthetic Co(II) solutions, the parameters influencing the cobalt extraction process are examined, and then these optimal conditions are applied to the recovery of cobalt from solutions obtained from the dissolution of NMC 622 battery black mass in 10 M HCl. The obtained results show that the used DES is highly selective for Co(II) recovery compared to other metals present in the solution (Ni, Li and Mn), achieving recoveries of up to 90% of the cobalt initially present in solution. Stripping with H2SO4 0.5 M allows for the recovery of cobalt in the form of a crystalline monohydrate salt (CoSO4.H2O). The optimization of the Co/Cu separation conditions is carried out, achieving the separation of Cu(II) using Aliquat 336 in kerosene.
- 22 September 2025
- Published by MDPI AG in Preprints.org
Open AccessCo(II) Recovery from Hydrochloric Acid Solution Using Menthol-based Deep Eutectic Solvents (DESs): Application to NMC Battery Recycling
Lithium-ion batteries are essential to ensure electric mobility and reduce CO2 emissions from transportation. One of the most commonly used chemistries is nick-el-cobalt-manganese (NMC) batteries, which also have applications beyond the automo-tive sector. The recycling of these batteries requires the development of technologies that allow for the selective separation and recovery of the metals present in the battery. One of these selective technologies involves the use of deep eutectic solvents (DESs). This research study investigates the different parameters affecting the recovery of Co(II) in hydrochloric acid medium using the deep eutectic solvent 3 Aliquat 336:7 L-Menthol. Firstly, using synthetic Co(II) solutions, the parameters influencing the cobalt extraction process are examined, and then these optimal conditions are applied to the recovery of cobalt from solutions obtained from the dissolution of NMC 622 battery black mass in 10 M HCl. The obtained results show that the used DES is highly selective for Co(II) recovery compared to other metals present in the solution (Ni, Li and Mn), achieving recoveries of up to 90% of the cobalt initially present in solution. Stripping with H2SO4 0.5 M allows for the recovery of cobalt in the form of a crystalline monohydrate salt (CoSO4.H2O). The optimization of the Co/Cu separation conditions is carried out, achieving the separation of Cu(II) using Aliquat 336 in kerosene.
- Open Access
- 20 February 2025
- Published by Wiley in ChemSusChem
- Vol. 18 (10) , e202402237
Recovery of Rare Earths from End‐of‐Life NdFeB Permanent Magnets from Wind Turbines
This work aims to recover rare earths from wind turbines NdFeB magnets through pyrometallurgical and hydrometallurgical techniques. First, a NdFeB hydride powder is obtained by decrepitation with hydrogen. Subsequently, this powder was subjected to a chlorination roasting process and successive leaching with water to bring the metals into solution. This was followed by a liquid‐liquid extraction to remove the iron and purify the rare earth solution. For this purpose, Aliquat 336 diluted in Solvesso was selected as the iron selective extraction agent. As a single extraction was not enough for complete iron removal, a second Fe extraction step was carried out. This second extraction step was performed using the restored organic phase. This restoration was achieved by treating the organic phase with Na2SO3 and then washing it with a 3 M HCl solution. In this way, the process was achieved more sustainably. Finally, the rare earths contained in the final solution were precipitated using oxalic acid to obtain mixed rare earth oxalates.
- 20 February 2025
- Published by Wiley in ChemSusChem
- Vol. 18 (10) , e202402237
Open AccessRecovery of Rare Earths from End‐of‐Life NdFeB Permanent Magnets from Wind Turbines
This work aims to recover rare earths from wind turbines NdFeB magnets through pyrometallurgical and hydrometallurgical techniques. First, a NdFeB hydride powder is obtained by decrepitation with hydrogen. Subsequently, this powder was subjected to a chlorination roasting process and successive leaching with water to bring the metals into solution. This was followed by a liquid‐liquid extraction to remove the iron and purify the rare earth solution. For this purpose, Aliquat 336 diluted in Solvesso was selected as the iron selective extraction agent. As a single extraction was not enough for complete iron removal, a second Fe extraction step was carried out. This second extraction step was performed using the restored organic phase. This restoration was achieved by treating the organic phase with Na2SO3 and then washing it with a 3 M HCl solution. In this way, the process was achieved more sustainably. Finally, the rare earths contained in the final solution were precipitated using oxalic acid to obtain mixed rare earth oxalates.
- Open Access
- 13 August 2024
- Published by Elsevier in Journal of Power Sources
- Vol. 619
Recovery of lithium from spent NMC batteries through water leaching, carbothermic reduction, and evaporative crystallization process
- 13 August 2024
- Published by Elsevier in Journal of Power Sources
- Vol. 619
Open AccessRecovery of lithium from spent NMC batteries through water leaching, carbothermic reduction, and evaporative crystallization process