Jan Skovajsa
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Jan Skovajsa has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
Martin Zálešák
Tomas Bata University in Zlin, Faculty of Applied Informatics, Department of Automation and Control Engineering, Nad Stranemi 4511, Zlin, Czech Republic
3 shared publications- Martin Zálešák
Faculty of Applied Informatics, Tomas Bata University in Zlín, 760 05 Zlín, Czech Republic
2 shared publications Stanislav Sehnalek
2 shared publications- Martin Kolacek
Department of Automation and Control Engineering, Faculty of Applied Informatics, TBU in Zlin, Nad Stranemi 4511, Zlin, Czech Republic
1 shared publication Martin Koláček
Tomas Bata University in Zlin, Faculty of Applied Informatics, Department of Automation and Control Engineering, Nad Stranemi 4511, Zlin, Czech Republic
1 shared publication- Martin Zálešák
The Department of Automation and Control Engineering, Faculty of Applied Informatics, Tomas Bata University in Zlín, Nad Stráněmi 4511, 76005 Zlín, Czech Republic
1 shared publication
Latest Publications
- Open Access
- 23 August 2024
- Published by Elsevier in Applied Thermal Engineering
- Vol. 257
Solution of the modular PCM-based cooling ceiling and ventilation system
- 23 August 2024
- Published by Elsevier in Applied Thermal Engineering
- Vol. 257
Open AccessSolution of the modular PCM-based cooling ceiling and ventilation system
- 15 August 2024
- Published by Elsevier in Applied Thermal Engineering
- Vol. 255
Editor’s note
- Open Access
- 24 September 2019
- Published by EDP Sciences in MATEC Web of Conferences
- Vol. 292, 01021
Optimization and economic assessment of renewable energy sources and their combinations for Central Europe
The article deals with the economic evaluation of investment and optimization of the renewable energy sources for family houses. For example, from the point of view of solar systems, the optimal solution is based on the specific application of it. The design is dependent on the location of the panels and ration between active aperture area and real daytime consumption. Common calculations according to actual standards often give overstated results, which also reflected in the value of the investments. The article shows the research of optimal parameters of the thermal solar system for preparing of domestic hot water. A combination of related standards and software TRNSYS are used to find optimal parameters. Thanks to created and verified simulation models, it is possible to design parameters so as to avoid under-dimensioning or over-dimensioning of the each system. Energy price is another factor affects the payback period of investments. This is affected by the used energy sources and their combination. For example, buildings that use electricity to heat water or heating have different energy charges than a building that uses natural gas. So, the aim is to find optimal solution of the combination of renewable energy sources.
- 24 September 2019
- Published by EDP Sciences in MATEC Web of Conferences
- Vol. 292, 01021
Open AccessOptimization and economic assessment of renewable energy sources and their combinations for Central Europe
The article deals with the economic evaluation of investment and optimization of the renewable energy sources for family houses. For example, from the point of view of solar systems, the optimal solution is based on the specific application of it. The design is dependent on the location of the panels and ration between active aperture area and real daytime consumption. Common calculations according to actual standards often give overstated results, which also reflected in the value of the investments. The article shows the research of optimal parameters of the thermal solar system for preparing of domestic hot water. A combination of related standards and software TRNSYS are used to find optimal parameters. Thanks to created and verified simulation models, it is possible to design parameters so as to avoid under-dimensioning or over-dimensioning of the each system. Energy price is another factor affects the payback period of investments. This is affected by the used energy sources and their combination. For example, buildings that use electricity to heat water or heating have different energy charges than a building that uses natural gas. So, the aim is to find optimal solution of the combination of renewable energy sources.
- Open Access
- 5 October 2018
- Published by EDP Sciences in MATEC Web of Conferences
- Vol. 210, 02023
Economic assessment and optimizing of the solar water heating system
The article deals with the economic evaluation of investment and optimization of the solar water heating system for family houses. From the point of view of solar systems, the optimal solution is based on the specific application of it. The design is dependent on the location of solar thermal collectors and ration between active aperture area and real daytime consumption. Common calculations according to actual standards often give overstated results, which also reflected in the value of the investments. The article presents the research of optimal parameters of the thermal solar system for preparing of domestic hot water. A combination of related standards and software TRNSYS are used to find optimal parameters. Thanks to created and verified simulation models, it is possible to design parameters so as to avoid under-dimensioning or over-dimensioning of the solar system. Energy price is another factor affects the payback period of investments. This is affected by the used energy sources and their combination. For example, buildings that use electricity to heat water or heating have different energy charges than a building that uses natural gas. So, the aim is to find technically and economically efficient solution.
- 5 October 2018
- Published by EDP Sciences in MATEC Web of Conferences
- Vol. 210, 02023
Open AccessEconomic assessment and optimizing of the solar water heating system
The article deals with the economic evaluation of investment and optimization of the solar water heating system for family houses. From the point of view of solar systems, the optimal solution is based on the specific application of it. The design is dependent on the location of solar thermal collectors and ration between active aperture area and real daytime consumption. Common calculations according to actual standards often give overstated results, which also reflected in the value of the investments. The article presents the research of optimal parameters of the thermal solar system for preparing of domestic hot water. A combination of related standards and software TRNSYS are used to find optimal parameters. Thanks to created and verified simulation models, it is possible to design parameters so as to avoid under-dimensioning or over-dimensioning of the solar system. Energy price is another factor affects the payback period of investments. This is affected by the used energy sources and their combination. For example, buildings that use electricity to heat water or heating have different energy charges than a building that uses natural gas. So, the aim is to find technically and economically efficient solution.
- Open Access
- 28 September 2018
- Published by MDPI AG in Applied Sciences
- Vol. 8 (10) , 1750
The Use of the Photovoltaic System in Combination With a Thermal Energy Storage for Heating and Thermoelectric Cooling
The article is focused on the research of the usage of modern accumulation technology. The proposed system is able to improve the thermal comfort of building interiors. That text depicts the technology, which uses a photovoltaics and other renewable energy sources for active heating and cooling. The bases of the presented technology are the phase change material and thermal energy storages. So, it passively improves the thermal capacity of the constructions of the buildings. Moreover, there is a possibility to use it for active heating and cooling. The technology contains thermoelectric assemblies, so, there is a very interesting possibility to store thermal energy with use of renewable energy sources (such as photovoltaic system) and thermoelectric coolers side by side. In the manuscript, there are shown measurements and results of the active operating modes of proposed technology. It was found the technology is able to work in active heating and cooling modes. It works quite well in active heating mode. On the other hand, thermoelectric cooling mode had a problem with overheating. In the end, the problem was solved and the cooling mode works. The measurements and results are described in the text.
- 28 September 2018
- Published by MDPI AG in Applied Sciences
- Vol. 8 (10) , 1750
Open AccessThe Use of the Photovoltaic System in Combination With a Thermal Energy Storage for Heating and Thermoelectric Cooling
The article is focused on the research of the usage of modern accumulation technology. The proposed system is able to improve the thermal comfort of building interiors. That text depicts the technology, which uses a photovoltaics and other renewable energy sources for active heating and cooling. The bases of the presented technology are the phase change material and thermal energy storages. So, it passively improves the thermal capacity of the constructions of the buildings. Moreover, there is a possibility to use it for active heating and cooling. The technology contains thermoelectric assemblies, so, there is a very interesting possibility to store thermal energy with use of renewable energy sources (such as photovoltaic system) and thermoelectric coolers side by side. In the manuscript, there are shown measurements and results of the active operating modes of proposed technology. It was found the technology is able to work in active heating and cooling modes. It works quite well in active heating mode. On the other hand, thermoelectric cooling mode had a problem with overheating. In the end, the problem was solved and the cooling mode works. The measurements and results are described in the text.
- Open Access
- 4 October 2017
- Published by EDP Sciences in MATEC Web of Conferences
- Vol. 125, 02032
Thermoelectric cooling in combination with photovoltaics and thermal energy storage
MATEC Web of Conferences, open access proceedings in Materials science, Engineering and Chemistry
- 4 October 2017
- Published by EDP Sciences in MATEC Web of Conferences
- Vol. 125, 02032
Open AccessThermoelectric cooling in combination with photovoltaics and thermal energy storage
MATEC Web of Conferences, open access proceedings in Materials science, Engineering and Chemistry
- Open Access
Phase Change Material Based Accumulation Panels in Combination with Renewable Energy Sources and Thermoelectric Cooling
The article deals with the use of modern materials and technologies that can improve the thermal comfort in buildings. The article describes the design and usage of a special accumulation device, which is composed of thermal panels based on phase change materials (PCMs). The thermal panels have an integrated tube heat exchanger and heating foils. The technology can be used as a passive or active system for heating and cooling. It is designed as a “green technology”, so it is able to use renewable energy sources, e.g., photovoltaic (PV) panels, solar thermal collectors and heat pumps. Moreover, an interesting possibility is the ability to use thermoelectric coolers. In the research, measurements of the different operating modes were made, and the results are presented in the text. The measurement approves that the technology improves the thermal capacity of the building, and it is possible to use it for active heating and cooling.
Open AccessPhase Change Material Based Accumulation Panels in Combination with Renewable Energy Sources and Thermoelectric Cooling
The article deals with the use of modern materials and technologies that can improve the thermal comfort in buildings. The article describes the design and usage of a special accumulation device, which is composed of thermal panels based on phase change materials (PCMs). The thermal panels have an integrated tube heat exchanger and heating foils. The technology can be used as a passive or active system for heating and cooling. It is designed as a “green technology”, so it is able to use renewable energy sources, e.g., photovoltaic (PV) panels, solar thermal collectors and heat pumps. Moreover, an interesting possibility is the ability to use thermoelectric coolers. In the research, measurements of the different operating modes were made, and the results are presented in the text. The measurement approves that the technology improves the thermal capacity of the building, and it is possible to use it for active heating and cooling.
- Open Access
- 21 October 2016
- Published by EDP Sciences in MATEC Web of Conferences
- Vol. 76, 02010
Effect of cloudiness on the production of electricity by photovoltaic panels
MATEC Web of Conferences, open access proceedings in Materials science, Engineering and Chemistry
- 21 October 2016
- Published by EDP Sciences in MATEC Web of Conferences
- Vol. 76, 02010
Open AccessEffect of cloudiness on the production of electricity by photovoltaic panels
MATEC Web of Conferences, open access proceedings in Materials science, Engineering and Chemistry
- Open Access
- 21 October 2016
- Published by EDP Sciences in MATEC Web of Conferences
- Vol. 76, 02014
Thermal energy storage in the form of heat or cold with using of the PCM-based accumulation panels
MATEC Web of Conferences, open access proceedings in Materials science, Engineering and Chemistry
- 21 October 2016
- Published by EDP Sciences in MATEC Web of Conferences
- Vol. 76, 02014
Open AccessThermal energy storage in the form of heat or cold with using of the PCM-based accumulation panels
MATEC Web of Conferences, open access proceedings in Materials science, Engineering and Chemistry