Hamidul Islam
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Hamidul Islam has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Abdul Momin
School of Agriculture, Tennessee Tech University, Cookeville, TN 38505, USA
2 shared publications Abdullah Al Siam
Department of Farm Power and Machinery, Bangladesh Agricultural University, Mymensingh, 2202, Bangladesh
1 shared publication- Alin Khaliduzzaman
Sylhet Agricultural University
1 shared publication - Anisur Rahman
Department of Farm Power and Machinery Bangladesh Agricultural University Mymensingh Bangladesh
1 shared publication - Chayan Kumer Saha
Department of Farm Power and Machinery, Bangladesh Agricultural University, Mymensingh-2202, Bangladesh
1 shared publication M. I. Hossain
Farm Machinery and Postharvest Process Engineering Division, Bangladesh Agricultural Research Institute, Joydebpur, Gazipur-1701, Bangladesh
1 shared publication
Latest Publications
- Open Access
- 12 November 2024
- Published by MDPI AG in Sustainability
- Vol. 16 (22) , 9846
Techno-Economic Analysis of BAU-STR Dryer for Rice Drying: An Approach to Accelerate Adoption
Postharvest food loss and waste offset worldwide agricultural productivity and food security. Insufficient drying and storage are the prominent drivers of food loss and waste in underdeveloped countries. Mechanical grain drying systems have distinct benefits over sun drying but are inaccessible to underserved communities due to high capital costs and energy demand. This study evaluated the techno-economic and financial performance of a half-ton-capacity BAU-STR dryer. The moisture extraction rate, drying rate, drying efficiency, and energy consumption were used as technical performance indicators. In contrast, the net present value (NPV), internal rate of return (IRR), benefit–cost ratio (BCR), and payback period were considered economic performance indicators. The technical performance analysis results revealed that the moisture content of rice was reduced from 19.5% to 13.5 ± 0.15% in 4.0 h with an average drying rate of 1.5%/h and a drying efficiency of 75.1%. The financial performance analysis resulted in a drying cost, NPV, IRR, BCR, and PBP of USD 0.96 per 100 kg of grain, USD 3018, 135%, 3.0, and 0.73 yr., respectively, when the annual use was 240 h. If the yearly use of the dryer increased from 240 to 720 h, a higher NPV, IRR, and BCR, as well as a lower payback period and drying cost, could be achieved. Adopting a BAU-STR dryer for drying grain (rice and corn) among underserved communities could play a key role in postharvest food loss and waste.
- 12 November 2024
- Published by MDPI AG in Sustainability
- Vol. 16 (22) , 9846
Open AccessTechno-Economic Analysis of BAU-STR Dryer for Rice Drying: An Approach to Accelerate Adoption
Postharvest food loss and waste offset worldwide agricultural productivity and food security. Insufficient drying and storage are the prominent drivers of food loss and waste in underdeveloped countries. Mechanical grain drying systems have distinct benefits over sun drying but are inaccessible to underserved communities due to high capital costs and energy demand. This study evaluated the techno-economic and financial performance of a half-ton-capacity BAU-STR dryer. The moisture extraction rate, drying rate, drying efficiency, and energy consumption were used as technical performance indicators. In contrast, the net present value (NPV), internal rate of return (IRR), benefit–cost ratio (BCR), and payback period were considered economic performance indicators. The technical performance analysis results revealed that the moisture content of rice was reduced from 19.5% to 13.5 ± 0.15% in 4.0 h with an average drying rate of 1.5%/h and a drying efficiency of 75.1%. The financial performance analysis resulted in a drying cost, NPV, IRR, BCR, and PBP of USD 0.96 per 100 kg of grain, USD 3018, 135%, 3.0, and 0.73 yr., respectively, when the annual use was 240 h. If the yearly use of the dryer increased from 240 to 720 h, a higher NPV, IRR, and BCR, as well as a lower payback period and drying cost, could be achieved. Adopting a BAU-STR dryer for drying grain (rice and corn) among underserved communities could play a key role in postharvest food loss and waste.
- 1 December 2022
- Published by Springer Nature
- p. 111-126
Chemometric for Spectroscopy-Based Egg and Poultry Research
- 1 December 2022
- Published by Springer Nature
- p. 111-126
Chemometric for Spectroscopy-Based Egg and Poultry Research
- Open Access
- 31 December 2016
- Published by Bangladesh Agricultural University in Journal of Agricultural Machinery and Bioresources Engineering
- Vol. 7 (1) , 55-62
Zero-Till Drill for Wheat Establishment and Comparison of Performance with Power Tiller Operated Seeder (PTOS) and Conventional Method
A power tiller operated Zero-till drill had been developed in Wheat Research Centre (WRC), Dinajpur, Bangladesh with the assistance of CIMMYT. Performance of the Zero-till drill was evaluated at farmers’ field in Dinajpur area for the establishment of wheat after rice harvesting. Performance of the Zero-till drill was evaluated on the basis of seed rate, seed spacing, and depth of seeding, effective field capacity, fuel consumption, planting cost, yield, net saving and benefit cost ratio. For justification of suitability of Zero-till drill for the establishment of wheat, performance of the Zero-till drill was also compared with power tiller operated seeder (PTOS) and conventional method (broadcasting). Results showed that effective field capacity and fuel consumption rate of the Zero-till drill was 0.12 ha/hr and 1.5 lit/hr, respectively. During seed sowing 30 kg of seed per hectare was saved with Zero-tillage system. Zero-till drill also maintained uniform depth of seeding with better seed-soil contact. It was also observed that the number of effective tiller and effective spike were more in Zero-tillage system than in conventional method and wheat yield under Zero-tillage and PTOS planting methods were 6.5% and 13% higher than that under conventional method. Furthermore, wheat planted with Zero-till drill was less lodged compared to PTOS and conventional method. From economic view point, Zero-till drill was suitable for wheat establishment because it saved planting cost of Tk. 2585/ha which was 66% less expensive than conventional method and the benefit cost ratio (BCR) of the Zero-till drill was 2.0 indicating that Zero-till drill was profitable than PTOS (BCR = 1.88) and conventional method (BCR = 1.31).
- 31 December 2016
- Published by Bangladesh Agricultural University in Journal of Agricultural Machinery and Bioresources Engineering
- Vol. 7 (1) , 55-62
Open AccessZero-Till Drill for Wheat Establishment and Comparison of Performance with Power Tiller Operated Seeder (PTOS) and Conventional Method
A power tiller operated Zero-till drill had been developed in Wheat Research Centre (WRC), Dinajpur, Bangladesh with the assistance of CIMMYT. Performance of the Zero-till drill was evaluated at farmers’ field in Dinajpur area for the establishment of wheat after rice harvesting. Performance of the Zero-till drill was evaluated on the basis of seed rate, seed spacing, and depth of seeding, effective field capacity, fuel consumption, planting cost, yield, net saving and benefit cost ratio. For justification of suitability of Zero-till drill for the establishment of wheat, performance of the Zero-till drill was also compared with power tiller operated seeder (PTOS) and conventional method (broadcasting). Results showed that effective field capacity and fuel consumption rate of the Zero-till drill was 0.12 ha/hr and 1.5 lit/hr, respectively. During seed sowing 30 kg of seed per hectare was saved with Zero-tillage system. Zero-till drill also maintained uniform depth of seeding with better seed-soil contact. It was also observed that the number of effective tiller and effective spike were more in Zero-tillage system than in conventional method and wheat yield under Zero-tillage and PTOS planting methods were 6.5% and 13% higher than that under conventional method. Furthermore, wheat planted with Zero-till drill was less lodged compared to PTOS and conventional method. From economic view point, Zero-till drill was suitable for wheat establishment because it saved planting cost of Tk. 2585/ha which was 66% less expensive than conventional method and the benefit cost ratio (BCR) of the Zero-till drill was 2.0 indicating that Zero-till drill was profitable than PTOS (BCR = 1.88) and conventional method (BCR = 1.31).
- Open Access
- 26 May 2014
- Published by Center of Biomass and Renewable Energy Scientia Academy in International Journal of Renewable Energy Development
- Vol. 3 (2) , 119-123
Development of Briquette from Coir Dust and Rice Husk Blend: An Alternative Energy Source
Biomass is one of the predominant renewable energy sources and the use of biomass for the energy generation has got much attention due to its environmental friendliness. Densification of coir dust into fuel briquette can solve waste disposal problem as well as can serve as an alternative energy source. The objective of this study was to investigate the possibility of producing briquette from coir dust and rice husk blend without binder. During this study, a briquetting experiment was conducted with different coir dust and rice husk blends (i.e. coir dust and rice husk ratio of 80:20, 60:40, 50:50, 40:60, 20:80 and 0:100). Briquetting operation was performed using a die-screw press type briquetting machine. The briquettes were tested to evaluate their density, compressive strength, calorific value, burning rate and water vaporizing capacity and it was found that mixing ratio had a significant effect on the physical, mechanical and combustion properties of the coir dust-rice husk briquettes. Density, compressive strength and calorific value and water vaporizing capacity were increased with increasing mixing ratio while burning rate was decreased. Coir dust-rice husk briquettes with mixing ratio of 20:80 had higher density (1.413 g/cm3), compressive strength (218.4 N/cm2), calorific value (4879 kcal/kg), water vaporizing capacity (0.853 l/kg) and low burning rate (0.783 kg/hour) followed by the mixing ratio 40:60, 50:50, 60:40 and 0:100. The results indicate that coir dust and rice husk blend briquettes were found to have better overall handling characteristics over rice husk briquette. However, production of briquettes from coir dust and rice husk at mixing ratio of 50:50 was found to be more suitable for commercial application in terms of cost effectiveness.
- 26 May 2014
- Published by Center of Biomass and Renewable Energy Scientia Academy in International Journal of Renewable Energy Development
- Vol. 3 (2) , 119-123
Open AccessDevelopment of Briquette from Coir Dust and Rice Husk Blend: An Alternative Energy Source
Biomass is one of the predominant renewable energy sources and the use of biomass for the energy generation has got much attention due to its environmental friendliness. Densification of coir dust into fuel briquette can solve waste disposal problem as well as can serve as an alternative energy source. The objective of this study was to investigate the possibility of producing briquette from coir dust and rice husk blend without binder. During this study, a briquetting experiment was conducted with different coir dust and rice husk blends (i.e. coir dust and rice husk ratio of 80:20, 60:40, 50:50, 40:60, 20:80 and 0:100). Briquetting operation was performed using a die-screw press type briquetting machine. The briquettes were tested to evaluate their density, compressive strength, calorific value, burning rate and water vaporizing capacity and it was found that mixing ratio had a significant effect on the physical, mechanical and combustion properties of the coir dust-rice husk briquettes. Density, compressive strength and calorific value and water vaporizing capacity were increased with increasing mixing ratio while burning rate was decreased. Coir dust-rice husk briquettes with mixing ratio of 20:80 had higher density (1.413 g/cm3), compressive strength (218.4 N/cm2), calorific value (4879 kcal/kg), water vaporizing capacity (0.853 l/kg) and low burning rate (0.783 kg/hour) followed by the mixing ratio 40:60, 50:50, 60:40 and 0:100. The results indicate that coir dust and rice husk blend briquettes were found to have better overall handling characteristics over rice husk briquette. However, production of briquettes from coir dust and rice husk at mixing ratio of 50:50 was found to be more suitable for commercial application in terms of cost effectiveness.