Xiaolong Sun
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Xiaolong Sun has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Xiaodong Qu
School of Information and Electronics, Beijing Institute of Technology, Beijing, China
5 shared publications - Hao Zhang
School of Information and Electronics, Beijing Institute of Technology, Beijing, China
4 shared publications - Xiaopeng Yang
School of Information and Electronics, Beijing Institute of Technology, Beijing, China
4 shared publications - Feiyang Liu
Beijing Institute of Technology
3 shared publications - Zeyu Ma
School of Information and Electronics, Beijing Institute of Technology, Beijing, China
2 shared publications - Haoyu Meng
School of Information and Electronics, Beijing Institute of Technology, Beijing, China
1 shared publication
Latest Publications
- 16 April 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Signal Processing Letters
- Vol. 32 (10709908) , 1775-1779
Moving Target Coherent Integration Method Based on TRCM-KT for UAV-Mounted Through-the-Wall Radar
Moving target detection in through-the-wall scenario can be achieved by utilizing unmanned aerial vehicle (UAV) radar. However, considering indoor human target detection, the distance between the radar and the moving target is relatively short, and the ratio of target's velocity to the UAV's velocity varies greatly, which makes the range migration and Doppler phase much more complex and poses huge challenges for coherent integration. To address this issue, this letter proposes a moving target coherent integration method based on time reverse conjugate multiply and keystone transform (TRCM-KT) for UAV-mounted through-the-wall radar. In the proposed method, the reference signal is constructed by azimuthal time reverse and conjugation. Then, by multiplying the echo signal and the reference signal, the second-order range migration and doppler phase terms are eliminated. Next, keystone transform is employed to correct the remained first-order range migration. Finally, the fully coherent integration results can be obtained by performing Fourier transform along the azimuth direction. The effectiveness of the proposed method is verified by both simulation and experiment results.
- 16 April 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Signal Processing Letters
- Vol. 32 (10709908) , 1775-1779
Moving Target Coherent Integration Method Based on TRCM-KT for UAV-Mounted Through-the-Wall Radar
Moving target detection in through-the-wall scenario can be achieved by utilizing unmanned aerial vehicle (UAV) radar. However, considering indoor human target detection, the distance between the radar and the moving target is relatively short, and the ratio of target's velocity to the UAV's velocity varies greatly, which makes the range migration and Doppler phase much more complex and poses huge challenges for coherent integration. To address this issue, this letter proposes a moving target coherent integration method based on time reverse conjugate multiply and keystone transform (TRCM-KT) for UAV-mounted through-the-wall radar. In the proposed method, the reference signal is constructed by azimuthal time reverse and conjugation. Then, by multiplying the echo signal and the reference signal, the second-order range migration and doppler phase terms are eliminated. Next, keystone transform is employed to correct the remained first-order range migration. Finally, the fully coherent integration results can be obtained by performing Fourier transform along the azimuth direction. The effectiveness of the proposed method is verified by both simulation and experiment results.
- 24 March 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 74 (00189456) , 1-13
An Indoor Moving Target Relocation Method Based on Interferometric Phase of Dual-Channel UAV-Mounted Through-the-Wall Radar
Unmanned aerial vehicle (UAV) mounted through-the-wall radar (TWR) can penetrate buildings and achieve indoor moving target detection. However, unknown radial velocity of the moving target leads to Doppler centroid shift and consequently deviation in radar image. The real azimuth location cannot be obtained directly from radar image. Therefore, this article proposes a moving target azimuth relocation method based on UAV mounted TWR. In this method, firstly, the dual channel phase history of the moving target in range-compressed domain is extracted based on Keystone transform and azimuthal non-coherent accumulation. Secondly, the interferometric phase is then obtained and fitted using least-squares method. Thirdly, an optimization problem regarding to moving target azimuth location is constructed and solved. Numerical simulation, field and comparative experiments validate the effectiveness of the proposed method.
- 24 March 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 74 (00189456) , 1-13
An Indoor Moving Target Relocation Method Based on Interferometric Phase of Dual-Channel UAV-Mounted Through-the-Wall Radar
Unmanned aerial vehicle (UAV) mounted through-the-wall radar (TWR) can penetrate buildings and achieve indoor moving target detection. However, unknown radial velocity of the moving target leads to Doppler centroid shift and consequently deviation in radar image. The real azimuth location cannot be obtained directly from radar image. Therefore, this article proposes a moving target azimuth relocation method based on UAV mounted TWR. In this method, firstly, the dual channel phase history of the moving target in range-compressed domain is extracted based on Keystone transform and azimuthal non-coherent accumulation. Secondly, the interferometric phase is then obtained and fitted using least-squares method. Thirdly, an optimization problem regarding to moving target azimuth location is constructed and solved. Numerical simulation, field and comparative experiments validate the effectiveness of the proposed method.
- 12 February 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Internet of Things Journal
- Vol. 12 (11) , 18235-18248
An Indoor Moving Target Detection Method Based on Doppler Chirp Rate Profile and Range Gating Filter
The detection of indoor moving targets using unmanned aerial vehicle (UAV)-mounted through-the-wall radar (TWR) has been widely applied in both military and civilian fields. However, the imaging results of moving targets often suffer from defocusing and are prone to be submerged in strong stationary clutter, which reduces the detection rate of moving targets. To address this issue, this paper proposes a detection method for indoor moving targets based on Doppler chirp rate profile and range gating filter using UAV-mounted through-the-wall radar. In the proposed method, the characteristics of Doppler chirp rate for both clutter and moving targets are analyzed. The range migration of the target echo is corrected in the range-Doppler domain through sinc interpolation. Then, the fractional Fourier transform (FrFT) is applied to estimate the chirp rate at each range bin. Subsequently, the estimated chirp rate values are compared with the theoretical chirp rate values of stationary objects. Based on the differences of Doppler chirp rates, a gating filter in fast time domain is designed to suppress clutter originated from walls and stationary objects. Finally, an azimuth compression filter is constructed to achieve focused imaging of moving targets. Both simulation and field experiments demonstrate the feasibility and effectiveness of the proposed method. The proposed method shows strengths over other methods in terms of improvement factor, image entropy and peak-sidelobe ratio.
- 12 February 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Internet of Things Journal
- Vol. 12 (11) , 18235-18248
An Indoor Moving Target Detection Method Based on Doppler Chirp Rate Profile and Range Gating Filter
The detection of indoor moving targets using unmanned aerial vehicle (UAV)-mounted through-the-wall radar (TWR) has been widely applied in both military and civilian fields. However, the imaging results of moving targets often suffer from defocusing and are prone to be submerged in strong stationary clutter, which reduces the detection rate of moving targets. To address this issue, this paper proposes a detection method for indoor moving targets based on Doppler chirp rate profile and range gating filter using UAV-mounted through-the-wall radar. In the proposed method, the characteristics of Doppler chirp rate for both clutter and moving targets are analyzed. The range migration of the target echo is corrected in the range-Doppler domain through sinc interpolation. Then, the fractional Fourier transform (FrFT) is applied to estimate the chirp rate at each range bin. Subsequently, the estimated chirp rate values are compared with the theoretical chirp rate values of stationary objects. Based on the differences of Doppler chirp rates, a gating filter in fast time domain is designed to suppress clutter originated from walls and stationary objects. Finally, an azimuth compression filter is constructed to achieve focused imaging of moving targets. Both simulation and field experiments demonstrate the feasibility and effectiveness of the proposed method. The proposed method shows strengths over other methods in terms of improvement factor, image entropy and peak-sidelobe ratio.
- 11 February 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Signal Processing Letters
- Vol. 32 (10709908) , 1001-1005
Target Tracking Method Based on Scale-Adaptive Rotation Kernelized Correlation Filter for Through-the-Wall Radar
Through-the-wall radar (TWR) can track moving human targets in obscured spaces, providing real-time information to operators. Changes in the position and angle of targets during movement will lead to diversity in the scale and orientation of the radar images, causing difficulty in target tracking. In order to solve this problem, this letter proposes a TWR target tracking method based on scale-adaptive rotation kernelized correlation filter (SA-RKCF). In the proposed method, the size and angle of the target region are both estimated, which are used for training samples generation and correlation filter updating. The candidate target region of current frame is delineated based on the geometric information of the previous frame, and then the correlation filter is used to localize the target position. The effectiveness of the proposed method is verified using both numerical simulation and experiment
- 11 February 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Signal Processing Letters
- Vol. 32 (10709908) , 1001-1005
Target Tracking Method Based on Scale-Adaptive Rotation Kernelized Correlation Filter for Through-the-Wall Radar
Through-the-wall radar (TWR) can track moving human targets in obscured spaces, providing real-time information to operators. Changes in the position and angle of targets during movement will lead to diversity in the scale and orientation of the radar images, causing difficulty in target tracking. In order to solve this problem, this letter proposes a TWR target tracking method based on scale-adaptive rotation kernelized correlation filter (SA-RKCF). In the proposed method, the size and angle of the target region are both estimated, which are used for training samples generation and correlation filter updating. The candidate target region of current frame is delineated based on the geometric information of the previous frame, and then the correlation filter is used to localize the target position. The effectiveness of the proposed method is verified using both numerical simulation and experiment
- 18 March 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Signal Processing Letters
- Vol. 31 (10709908) , 860-864
Adaptive Micro-Doppler Corner Feature Extraction Method Based on Difference of Gaussian Filter and Deformable Convolution
Through-the-wall radar (TWR) utilizes range and Doppler information to achieve indoor human activity recognition. However, traditional recognition methods are developed based on range-time maps (RTM) and Doppler-time maps (DTM), resulting in low accuracy and poor robustness. In order to solve these problems, this letter proposes to use micro-Doppler corner feature to achieve activity recognition and gives an adaptive corner feature extraction method based on difference of Gaussian (DoG) filter and deformable convolution. Micro-Doppler corner feature is defined as the points on the radar squared-range and squared-Doppler images where the gray scale changes sharply in different directions, reflecting the inflection, stationing, intersection, and boundaries of the motion trajectory curves of the human limb nodes. The proposed corner feature extraction method utilizes the DoG filter to extract the micro-Doppler corner supervisory labels on simulated data. The labels are then used to train the $\boldsymbol{\mu }$ D-CornerDet, which is constructed based on deformable convolution network (DCN), task-adaptive deformable convolution network (TDCN), feature pyramid network (FPN) and learnable regression global attention module (LRGA). For predictions, only $\mu$ D-CornerDet is used on measured data to obatin the corner feature maps. Both numerical simulations and experiments are conducted to verify the effectiveness and robustness of the proposed method.
- 18 March 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Signal Processing Letters
- Vol. 31 (10709908) , 860-864
Adaptive Micro-Doppler Corner Feature Extraction Method Based on Difference of Gaussian Filter and Deformable Convolution
Through-the-wall radar (TWR) utilizes range and Doppler information to achieve indoor human activity recognition. However, traditional recognition methods are developed based on range-time maps (RTM) and Doppler-time maps (DTM), resulting in low accuracy and poor robustness. In order to solve these problems, this letter proposes to use micro-Doppler corner feature to achieve activity recognition and gives an adaptive corner feature extraction method based on difference of Gaussian (DoG) filter and deformable convolution. Micro-Doppler corner feature is defined as the points on the radar squared-range and squared-Doppler images where the gray scale changes sharply in different directions, reflecting the inflection, stationing, intersection, and boundaries of the motion trajectory curves of the human limb nodes. The proposed corner feature extraction method utilizes the DoG filter to extract the micro-Doppler corner supervisory labels on simulated data. The labels are then used to train the $\boldsymbol{\mu }$ D-CornerDet, which is constructed based on deformable convolution network (DCN), task-adaptive deformable convolution network (TDCN), feature pyramid network (FPN) and learnable regression global attention module (LRGA). For predictions, only $\mu$ D-CornerDet is used on measured data to obatin the corner feature maps. Both numerical simulations and experiments are conducted to verify the effectiveness and robustness of the proposed method.