Joddy Arya Laksmono
Joddy Arya Laksmono has a total of 32 co-authors. Here are the top co-authors by number of shared publications:
- Annisa Rifathin
Research Center for Polymer Technology-National Research and Innovation Agency, Jakarta 10310, Indonesia
2 shared publications - Adam Febriyanto Nugraha
Green Polymer Technology Laboratory, Department of Metallurgical and Material Engineering, Faculty of Engineering, Universitas Indonesia, Depok 16424, Indonesia
1 shared publication - Ade Mundari Wijaya
Research Center for Polymer Technology-National Research and Innovation Agency, Jakarta 10310, Indonesia
1 shared publication - Aemi Syazwani Abdul Keyon
Universiti Teknologi Malaysia
1 shared publication - Asep Riswoko
Directorate of Research and Innovation Partnerships National Research and Innovation Agency (BRIN) Jakarta Indonesia
1 shared publication - Cacu Cacu
Department of Chemistry, Faculty of Mathematics and Natural Sciences, Universitas Gadjah Mada
1 shared publication
Latest Publications
- Open Access
- 11 March 2026
- Published by MDPI AG in Journal of Composites Science
- Vol. 10 (3) , 152
Atmospheric Plasma-Treated Recycled Polyethylene (rPE) as a Compatibilizer in rPE/Oil Palm Empty Fruit Bunch Fiber Composites
Composites based on rPE and OPEFB waste are considered sustainable materials. However, their performance is limited by hydrophobic–hydrophilic incompatibility, which weakens interfacial adhesion. This study investigated the atmospheric-pressure air plasma treatment of rPE to enhance its compatibility with OPEFB fibers and evaluated its role as a compatibilizer. Atmospheric plasma treatment for 120 s introduced oxygen-containing groups onto the rPE surface, as evidenced by C-O and OH peaks in the FTIR spectra and the higher O/C ratio in the XPS analysis. Consequently, the water contact angle decreased, reducing the difference in surface tension between rPE and OPEFB from 45.61% to 7.80%. Composites containing 20 wt.% OPEFB were fabricated by varying the proportion of untreated rPE with p-rPE. All p-rPE-based composites exhibited fewer interfacial voids than untreated rPE composites, indicating improved fiber–matrix adhesion. The tensile strength and elastic modulus increased with the p-rPE content, whereas the elongation at break remained higher than that of the untreated composite. Therefore, p-rPE shows potential as a compatibilizer, enabling agricultural and plastic waste value enhancement.
- 11 March 2026
- Published by MDPI AG in Journal of Composites Science
- Vol. 10 (3) , 152
Open AccessAtmospheric Plasma-Treated Recycled Polyethylene (rPE) as a Compatibilizer in rPE/Oil Palm Empty Fruit Bunch Fiber Composites
Composites based on rPE and OPEFB waste are considered sustainable materials. However, their performance is limited by hydrophobic–hydrophilic incompatibility, which weakens interfacial adhesion. This study investigated the atmospheric-pressure air plasma treatment of rPE to enhance its compatibility with OPEFB fibers and evaluated its role as a compatibilizer. Atmospheric plasma treatment for 120 s introduced oxygen-containing groups onto the rPE surface, as evidenced by C-O and OH peaks in the FTIR spectra and the higher O/C ratio in the XPS analysis. Consequently, the water contact angle decreased, reducing the difference in surface tension between rPE and OPEFB from 45.61% to 7.80%. Composites containing 20 wt.% OPEFB were fabricated by varying the proportion of untreated rPE with p-rPE. All p-rPE-based composites exhibited fewer interfacial voids than untreated rPE composites, indicating improved fiber–matrix adhesion. The tensile strength and elastic modulus increased with the p-rPE content, whereas the elongation at break remained higher than that of the untreated composite. Therefore, p-rPE shows potential as a compatibilizer, enabling agricultural and plastic waste value enhancement.
- 12 September 2024
- Published by Springer Nature in Journal of The Institution of Engineers (India): Series D
- Vol. 106 (3) , 1945-1956
Mechanical Properties, Density, and Morphology Analysis of Strong and Lightweight Microfibril Cellulose Reinforced Epoxy/Micro Balloon Hybrid Composites
- 12 September 2024
- Published by Springer Nature in Journal of The Institution of Engineers (India): Series D
- Vol. 106 (3) , 1945-1956
Mechanical Properties, Density, and Morphology Analysis of Strong and Lightweight Microfibril Cellulose Reinforced Epoxy/Micro Balloon Hybrid Composites
- Open Access
Analysis of Aceclofenac, Ketorolac, and Sulindac in Human Urine Using the Microemulsion Electrokinetic Chromatography Method
A method to determine aceclofenac, ketorolac, and sulindac in human urine samples using microemulsion electrokinetic chromatography (MEEKC) has been developed in this study. The optimization of MEEKC conditions was carried out by changing the microemulsion compositions including the buffer pH, borate salt concentration, surfactant concentration, co-surfactant concentration, organic modifier concentration, and oil droplet concentration. The optimum separation of selected drugs was obtained with a composition of microemulsion containing 10 mM borate buffer pH 9, 0.5% sodium dodecyl sulphate (SDS), 6.6% n-butanol, 6.0% acetonitrile, and 0.8% ethyl acetate. Excellent linearity was obtained in the range concentration of 25 to 200 ppm with r2 > 0.999. Limits of detection (LOD, S/N = 3) and limits of quantification (LOQ, S/N = 10) were 2.72 to 4.75 and 9.08 to 15.85 ppm, respectively. The solid-phase extraction (SPE) method using C-18 as an adsorbent and the solid phase micro-tip extraction (SPMTE) method using multiwalled carbon nanotubes (MWCNTs) as an adsorbent were used to clean-up and pre-concentrate the urine samples prior to the MEEKC analysis. The best recoveries of the selected drugs in the spiked urine sample were 91 to 103% with RSD of 1.26 to 4.03% (n = 3) using the SPE-MEEKC method.
Open AccessAnalysis of Aceclofenac, Ketorolac, and Sulindac in Human Urine Using the Microemulsion Electrokinetic Chromatography Method
A method to determine aceclofenac, ketorolac, and sulindac in human urine samples using microemulsion electrokinetic chromatography (MEEKC) has been developed in this study. The optimization of MEEKC conditions was carried out by changing the microemulsion compositions including the buffer pH, borate salt concentration, surfactant concentration, co-surfactant concentration, organic modifier concentration, and oil droplet concentration. The optimum separation of selected drugs was obtained with a composition of microemulsion containing 10 mM borate buffer pH 9, 0.5% sodium dodecyl sulphate (SDS), 6.6% n-butanol, 6.0% acetonitrile, and 0.8% ethyl acetate. Excellent linearity was obtained in the range concentration of 25 to 200 ppm with r2 > 0.999. Limits of detection (LOD, S/N = 3) and limits of quantification (LOQ, S/N = 10) were 2.72 to 4.75 and 9.08 to 15.85 ppm, respectively. The solid-phase extraction (SPE) method using C-18 as an adsorbent and the solid phase micro-tip extraction (SPMTE) method using multiwalled carbon nanotubes (MWCNTs) as an adsorbent were used to clean-up and pre-concentrate the urine samples prior to the MEEKC analysis. The best recoveries of the selected drugs in the spiked urine sample were 91 to 103% with RSD of 1.26 to 4.03% (n = 3) using the SPE-MEEKC method.
- Open Access
- 20 March 2024
- Published by EDP Sciences in E3S Web of Conferences
- Vol. 503, 04010
Optimization of Methyl Ester Through Simultaneous Esterification –Transesterification Reactions Using Waste Cooking Oil as Raw Material
The increasing need for fossil energy does not equal the availability of alternative energy sources as a substitute generating new problems. In addition to decreasing availability, fossil energy harms the environment by producing dangerous gases from combustion such as carbon dioxide, sulfur, and nitrogen. These factors increasingly encourage researchers to create renewable energy sources with the same performance but are environmentally friendly. Biodiesel or Methyl Ester commonly called Fatty Acid Methyl Ester (FAME) is a renewable alternative energy produced from various raw materials such as animal, vegetable, or other oils. In this study, the methyl ester made from waste cooking oil was processed through two stages of esterification and transesterification using the addition of methanol with different catalysts, H2SO4 and NaOH relying on the reaction step. The research aimed to determine the optimal results from variations in the concentration of the acid catalyst used. From FTIR characterization found that functional groups indicating the formation of methyl esters have been identified at wave numbers 1800-1700 cm-1 with functional groups of -C=O ester the presence of FAME. Meanwhile, to determine the optimum methyl ester caloric value using Bomb Calorimetry according to ASTM D6751 standard. The caloric value was obtained at 9,572.58 Cal/g with catalyst 0,5% H2SO4. The methyl ester content was identified using GC-MS, and the results obtained for ME1, ME2, and ME3 are 74.90%, 77.15%, and 71.98%, respectively. From this study, it can be found that the methyl ester can be produced with esterification-transesterification reactions simultaneously.
- 20 March 2024
- Published by EDP Sciences in E3S Web of Conferences
- Vol. 503, 04010
Open AccessOptimization of Methyl Ester Through Simultaneous Esterification –Transesterification Reactions Using Waste Cooking Oil as Raw Material
The increasing need for fossil energy does not equal the availability of alternative energy sources as a substitute generating new problems. In addition to decreasing availability, fossil energy harms the environment by producing dangerous gases from combustion such as carbon dioxide, sulfur, and nitrogen. These factors increasingly encourage researchers to create renewable energy sources with the same performance but are environmentally friendly. Biodiesel or Methyl Ester commonly called Fatty Acid Methyl Ester (FAME) is a renewable alternative energy produced from various raw materials such as animal, vegetable, or other oils. In this study, the methyl ester made from waste cooking oil was processed through two stages of esterification and transesterification using the addition of methanol with different catalysts, H2SO4 and NaOH relying on the reaction step. The research aimed to determine the optimal results from variations in the concentration of the acid catalyst used. From FTIR characterization found that functional groups indicating the formation of methyl esters have been identified at wave numbers 1800-1700 cm-1 with functional groups of -C=O ester the presence of FAME. Meanwhile, to determine the optimum methyl ester caloric value using Bomb Calorimetry according to ASTM D6751 standard. The caloric value was obtained at 9,572.58 Cal/g with catalyst 0,5% H2SO4. The methyl ester content was identified using GC-MS, and the results obtained for ME1, ME2, and ME3 are 74.90%, 77.15%, and 71.98%, respectively. From this study, it can be found that the methyl ester can be produced with esterification-transesterification reactions simultaneously.
- Open Access
- 1 January 2023
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2902 (1)
Preliminary investigation of antibiotic potential from esters of citronella oil derivatives
Microbial resistance due to the overuse of antibiotics has become a global health problem. The discovery and development of new active compounds to solve the antimicrobial resistance problems are urgently required. This research was conducted to study the antimicrobial potential of citronellyl isobutyrate (CIB) and geranyl isobutyrate (GIB). CIB and GIB are derivatives of citronella oil extracted from the lemongrass plant, one of the Indonesian native medicinal plants. The esters’antimicrobial was analyzed in vitro by antibacterial and antifungal tests using the agar diffusion method and compared to streptomycin sulfate as a standard. The minimum inhibitory concentration (MIC) was then evaluated using a serial microdilution assay. The esters exhibited moderate to vigorous antimicrobial activity against Staphylococcus aureus, Bacillus subtilis, Escherichia coli, and Candida albicans, with activity index (AI) values between 34.17-93.59%. The results revealed that the compounds have the potential to be developed as antibiotics. Therefore, this study is expected to help overcome the problem of antibiotic resistance.
- 1 January 2023
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2902 (1)
Open AccessPreliminary investigation of antibiotic potential from esters of citronella oil derivatives
Microbial resistance due to the overuse of antibiotics has become a global health problem. The discovery and development of new active compounds to solve the antimicrobial resistance problems are urgently required. This research was conducted to study the antimicrobial potential of citronellyl isobutyrate (CIB) and geranyl isobutyrate (GIB). CIB and GIB are derivatives of citronella oil extracted from the lemongrass plant, one of the Indonesian native medicinal plants. The esters’antimicrobial was analyzed in vitro by antibacterial and antifungal tests using the agar diffusion method and compared to streptomycin sulfate as a standard. The minimum inhibitory concentration (MIC) was then evaluated using a serial microdilution assay. The esters exhibited moderate to vigorous antimicrobial activity against Staphylococcus aureus, Bacillus subtilis, Escherichia coli, and Candida albicans, with activity index (AI) values between 34.17-93.59%. The results revealed that the compounds have the potential to be developed as antibiotics. Therefore, this study is expected to help overcome the problem of antibiotic resistance.