Andreea-Mihaela ComșIț
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Andreea-Mihaela ComșIț has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Daniel Tudor Cotfas
Department of Electronics and Computers, Faculty of Electrical Engineering and Computer Science, Transilvania University of Brasov, 500036 Brasov, Romania
4 shared publications - Petru Adrian Cotfas
Department of Electronics and Computers, Faculty of Electrical Engineering and Computer Science, Transilvania University of Brasov, 500036 Brasov, Romania
4 shared publications - Cristina-Ioana Călin
Transylvania University of Brasov,Faculty of Electrical Engineering and Computer Science,Brasov,Romania
2 shared publications - Cosmin-Sebastian Badea
Department of Electronics and Computers, Faculty of Electrical Engineering and Computer Science, Transilvania University of Brasov, 500036 Brasov, Romania
1 shared publication - Marian Alexandru
Department of Electronics and Computers, Faculty of Electrical Engineering and Computer Science, Transilvania University of Brasov, 500036 Brasov, Romania
1 shared publication Nesrine Merabti
Transylvania University of Brasov,Faculty of Electrical Engineering and Computer Science,Brasov,Romania
1 shared publication
Latest Publications
- Open Access
- 20 September 2026
- Published by MDPI AG in Applied Sciences
- Vol. 16 (18) , 9346
Application-Layer Intrusion Detection for VoIP over Open-Source 5G Standalone Networks
Many open-source 5G standalone testbeds emphasise deployment rather than continuous detection of application-layer abuse. This work presents a reproducible, RF-free, three-node testbed in which SIP signalling traverses a PDU session while a sensor correlates SIP transactions and Asterisk events with Open5GS session records, providing subscriber and data-network attribution. The detector combines a request-rate window with an unanswered-challenge ratio. A separate 5G-dependent rule determines whether SIP traffic attributed to the UE address pool has a corresponding active PDU session. Before execution, the experimental configurations and per-run ground-truth files were hashed; 67 of 70 runs passed the automated validity gates, and every exclusion is reported with its criterion. The detector identified all 60 attack episodes: REGISTER flooding at 2, 5, 10, and 20 requests/s and INVITE flooding at 10 and 20 requests/s. Median first-alert latency for REGISTER decreased from 11.403 s at 2 requests/s to 2.900 s at 20 requests/s; at the two matched rates, mean latencies for the two methods differed by, at most, 28.9 ms. Seven benign runs totalling 3.50 h produced no false alerts and a one-sided 95% Poisson upper bound of 0.86 alerts per hour, and 300 of 300 eligible alerts carried the expected subscriber identity.
- 20 September 2026
- Published by MDPI AG in Applied Sciences
- Vol. 16 (18) , 9346
Open AccessApplication-Layer Intrusion Detection for VoIP over Open-Source 5G Standalone Networks
Many open-source 5G standalone testbeds emphasise deployment rather than continuous detection of application-layer abuse. This work presents a reproducible, RF-free, three-node testbed in which SIP signalling traverses a PDU session while a sensor correlates SIP transactions and Asterisk events with Open5GS session records, providing subscriber and data-network attribution. The detector combines a request-rate window with an unanswered-challenge ratio. A separate 5G-dependent rule determines whether SIP traffic attributed to the UE address pool has a corresponding active PDU session. Before execution, the experimental configurations and per-run ground-truth files were hashed; 67 of 70 runs passed the automated validity gates, and every exclusion is reported with its criterion. The detector identified all 60 attack episodes: REGISTER flooding at 2, 5, 10, and 20 requests/s and INVITE flooding at 10 and 20 requests/s. Median first-alert latency for REGISTER decreased from 11.403 s at 2 requests/s to 2.900 s at 20 requests/s; at the two matched rates, mean latencies for the two methods differed by, at most, 28.9 ms. Seven benign runs totalling 3.50 h produced no false alerts and a one-sided 95% Poisson upper bound of 0.86 alerts per hour, and 300 of 300 eligible alerts carried the expected subscriber identity.
- 31 January 2026
- Published by Springer Nature
- p. 293-307
Immersion Meets Education: Redefining Learning Through XR Technologies
- 31 January 2026
- Published by Springer Nature
- p. 293-307
Immersion Meets Education: Redefining Learning Through XR Technologies
- 22 October 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 74-78
Time-Series Forecasting of PV Charging Power Using a Hybrid Model
Renewable energy systems, particularly photovoltaic (PV) energy, play a crucial role in addressing the environmental and economic challenges associated with traditional power sources. PV panels are essential for sustainable energy production; however, their power output is highly sensitive to changing weather conditions. As the global adoption of PV systems increases, accurate forecasting of solar energy becomes critical, especially in off-grid applications where battery storage is involved. This study proposes a hybrid model machine learning framework that combines a Random Walk-based drift model with a Gated Recurrent Unit (GRU) neural network to forecast the PV charging power for a Li-ion battery in a standalone PV system located in a mountainous region of Romania. The model is trained and tested on real world data collected hourly between March and June 2025. Forecasting performance is evaluated over 1-hour, 2-hour, and 5-hour timeframes. The results reveal that the GRU-RW model consistently outperforms conventional baselines, achieving good accuracy across all time horizons, as measured by important assessment metrics such as normalized RMSE, mean absolute percentage error, and the percentage of predictions within a 5% error margin. This demonstrates the model's effectiveness in predicting short-term PV charging power, as well as its potential to enhance energy management in standalone PV-battery systems operating under unpredictable weather conditions.
- 22 October 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 74-78
Time-Series Forecasting of PV Charging Power Using a Hybrid Model
Renewable energy systems, particularly photovoltaic (PV) energy, play a crucial role in addressing the environmental and economic challenges associated with traditional power sources. PV panels are essential for sustainable energy production; however, their power output is highly sensitive to changing weather conditions. As the global adoption of PV systems increases, accurate forecasting of solar energy becomes critical, especially in off-grid applications where battery storage is involved. This study proposes a hybrid model machine learning framework that combines a Random Walk-based drift model with a Gated Recurrent Unit (GRU) neural network to forecast the PV charging power for a Li-ion battery in a standalone PV system located in a mountainous region of Romania. The model is trained and tested on real world data collected hourly between March and June 2025. Forecasting performance is evaluated over 1-hour, 2-hour, and 5-hour timeframes. The results reveal that the GRU-RW model consistently outperforms conventional baselines, achieving good accuracy across all time horizons, as measured by important assessment metrics such as normalized RMSE, mean absolute percentage error, and the percentage of predictions within a 5% error margin. This demonstrates the model's effectiveness in predicting short-term PV charging power, as well as its potential to enhance energy management in standalone PV-battery systems operating under unpredictable weather conditions.
- Open Access
- 1 January 2025
- Published by Wiley in International Journal of Energy Research
- Vol. 2025 (1)
Smart Design and Deployment of Standalone PV System in Mountain Area in Romania
Renewable energy sources are a promising method of generating clean electricity in remote areas. Solar energy is especially useful for isolated communities without access to electricity. Off‐grid photovoltaic (PV) systems’ performance depends on the operating conditions and is strongly affected by the environmental conditions. In this research, a standalone PV system is designed and installed in a mountain area in Romania. A family of four is using the system for their daily needs. During the design phase of the system, the electrical needs of the household were evaluated, leading to the conclusion that 18 solar panels of 265 W each and a 58 V lithium‐ion (Li‐ion) battery with a capacity of 14.7 kWh are sufficient to provide the necessary electrical energy. The performance of the system has been analyzed by collecting data remotely, and the results showed that the system is well designed because the consumers do not remain without electricity, especially in critical weather conditions when the energy production is lower. The system produces less electricity, and the battery is not fully charged on all days in November and December because the solar radiation in these months is low. In the event of battery depletion, the system may experience a power interruption of up to 9 days/month in the month of December.
- 1 January 2025
- Published by Wiley in International Journal of Energy Research
- Vol. 2025 (1)
Open AccessSmart Design and Deployment of Standalone PV System in Mountain Area in Romania
Renewable energy sources are a promising method of generating clean electricity in remote areas. Solar energy is especially useful for isolated communities without access to electricity. Off‐grid photovoltaic (PV) systems’ performance depends on the operating conditions and is strongly affected by the environmental conditions. In this research, a standalone PV system is designed and installed in a mountain area in Romania. A family of four is using the system for their daily needs. During the design phase of the system, the electrical needs of the household were evaluated, leading to the conclusion that 18 solar panels of 265 W each and a 58 V lithium‐ion (Li‐ion) battery with a capacity of 14.7 kWh are sufficient to provide the necessary electrical energy. The performance of the system has been analyzed by collecting data remotely, and the results showed that the system is well designed because the consumers do not remain without electricity, especially in critical weather conditions when the energy production is lower. The system produces less electricity, and the battery is not fully charged on all days in November and December because the solar radiation in these months is low. In the event of battery depletion, the system may experience a power interruption of up to 9 days/month in the month of December.
- 24 October 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Design and Implementation of a Remote Controlled Emulator for Standalone PV Systems
Immeasurable efforts have been put into strengthening energy security and reducing greenhouse gas emissions by meeting growing energy demand. With declining costs and increasing performance, the deployment of PV systems is growing faster. The focus is on standalone solar photovoltaic systems in rural areas or where grid extension is not feasible. Meteorological conditions impact the standalone PV system's behavior. To avoid critical situations during the PV system operation, it is necessary to implement preventive measures. A PV emulator helps to understand better the behavior of the standalone PV system in critical conditions. This paper presents an intelligent and low-cost PV emulator, with focus on behavior of Li-ion battery, which can be remotely monitored and controlled. The proposed PV emulator consists of: a power supply which has the same behavior as the PV panels, battery storage, consumers which are represented by a electronic load (eload) and remote control functions by using mobile applications. The PV emulator was tested and the behavior of battery was analyzed during the charging and discharging processes. It was determined the capacity of battery is influenced by the values of charging and discharging currents. The ambient temperature influences the internal temperature of Li-ion battery and the PV emulator was stopped when the temperature of Li-ion battery was greater than 53o C.
- 24 October 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Design and Implementation of a Remote Controlled Emulator for Standalone PV Systems
Immeasurable efforts have been put into strengthening energy security and reducing greenhouse gas emissions by meeting growing energy demand. With declining costs and increasing performance, the deployment of PV systems is growing faster. The focus is on standalone solar photovoltaic systems in rural areas or where grid extension is not feasible. Meteorological conditions impact the standalone PV system's behavior. To avoid critical situations during the PV system operation, it is necessary to implement preventive measures. A PV emulator helps to understand better the behavior of the standalone PV system in critical conditions. This paper presents an intelligent and low-cost PV emulator, with focus on behavior of Li-ion battery, which can be remotely monitored and controlled. The proposed PV emulator consists of: a power supply which has the same behavior as the PV panels, battery storage, consumers which are represented by a electronic load (eload) and remote control functions by using mobile applications. The PV emulator was tested and the behavior of battery was analyzed during the charging and discharging processes. It was determined the capacity of battery is influenced by the values of charging and discharging currents. The ambient temperature influences the internal temperature of Li-ion battery and the PV emulator was stopped when the temperature of Li-ion battery was greater than 53o C.
- Open Access
- 4 September 2024
- Published by MDPI AG in Applied Sciences
- Vol. 14 (17) , 7838
A Review of Smart Photovoltaic Systems Which Are Using Remote-Control, AI, and Cybersecurity Approaches
In recent years, interest in renewable energy and photovoltaic systems has increased significantly. The design and implementation of photovoltaic systems are various, and they are in continuous development due to the technologies used. Photovoltaic systems are becoming increasingly complex due to the constantly changing needs of people, who are using more and more intelligent functions such as remote control and monitoring, power/energy prediction, and detection of broken devices. Advanced remote supervision and control applications use artificial intelligence approaches and expose photovoltaic systems to cyber threats. This article presents a detailed examination of the applications of various remote-control, artificial intelligence, and cybersecurity techniques across a diverse range of solar energy sources. The discussion covers the latest technological innovations, research outcomes, and case studies in the photovoltaics field, as well as potential challenges and the possible solutions to these challenges.
- 4 September 2024
- Published by MDPI AG in Applied Sciences
- Vol. 14 (17) , 7838
Open AccessA Review of Smart Photovoltaic Systems Which Are Using Remote-Control, AI, and Cybersecurity Approaches
In recent years, interest in renewable energy and photovoltaic systems has increased significantly. The design and implementation of photovoltaic systems are various, and they are in continuous development due to the technologies used. Photovoltaic systems are becoming increasingly complex due to the constantly changing needs of people, who are using more and more intelligent functions such as remote control and monitoring, power/energy prediction, and detection of broken devices. Advanced remote supervision and control applications use artificial intelligence approaches and expose photovoltaic systems to cyber threats. This article presents a detailed examination of the applications of various remote-control, artificial intelligence, and cybersecurity techniques across a diverse range of solar energy sources. The discussion covers the latest technological innovations, research outcomes, and case studies in the photovoltaics field, as well as potential challenges and the possible solutions to these challenges.