Lili Cao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Lili Cao has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Jiajia Bai
School of Petroleum and Natural Gas Engineering, Changzhou University, Changzhou 213164, China
2 shared publications - Lei Tao
School of Petroleum and Natural Gas Engineering, Changzhou University, Changzhou 213164, China
2 shared publications - Na Zhang
School of Petrochemical Engineering, Changzhou University, Changzhou 213164, China
2 shared publications - Qingjie Zhu
School of Petroleum and Natural Gas Engineering, Changzhou University, Changzhou 213164, China
2 shared publications - Wenyang Shi
School of Petroleum and Natural Gas Engineering, Changzhou University, Changzhou 213164, China
2 shared publications - Yong Song
Petroleum Exploration and Production Research Institute, SINOPEC, Beijing 100083, China
2 shared publications
Latest Publications
- Open Access
Steam-Alternating CO2/Viscosity Reducer Huff and Puff for Improving Heavy Oil Recovery: A Case of Multi-Stage Series Sandpack Model with Expanded Sizes
Aiming at the challenges of rapid heat dissipation, limited swept efficiency, and a rapid water cut increase in steam huff and puff development in heavy oil reservoirs, an alternating steam and CO2/viscosity reducer huff and puff method for IOR was proposed. In this work, the effect of CO2 on the physical properties of heavy oil was evaluated, and the optimal concentration of viscosity reducer for synergistic interaction between CO2 and the viscosity reducer was determined. Next, novel huff and puff simulation experiments by three sandpack models of different sizes in series were analyzed. Then, the IOR difference between the pure steam huff and puff experiments and the steam-alternating CO2/viscosity reducer huff and puff were compared. Finally, the CO2 storage rate was obtained based on the principle of the conservation of matter. The results show that the optimal viscosity reducer concentration, 0.8 wt%, can achieve a 98.5% reduction after combining CO2. The steam-alternating CO2/viscosity reducer huff and puff reached about 45 cm at 80 °C in the fifth cycle due to the CO2/viscosity reducer effects. CO2/viscosity reducer huff and puff significantly reduces water cut during cold production, with an ultimate IOR 15.89% higher than pure steam huff and puff. The viscosity reducer alleviates heavy oil blockages, and CO2 decreases oil viscosity and enhances elastic repulsion energy. The highest CO2 storage rate of 76.8% occurs in the initial stage, declining to 15.2% by the sixth cycle, indicating carbon sequestration potential. These findings suggest that steam-alternating CO2/viscosity reducer huff and puff improves heavy oil reservoir development and provides theoretical guidance for optimizing steam huff and puff processes.
Open AccessSteam-Alternating CO2/Viscosity Reducer Huff and Puff for Improving Heavy Oil Recovery: A Case of Multi-Stage Series Sandpack Model with Expanded Sizes
Aiming at the challenges of rapid heat dissipation, limited swept efficiency, and a rapid water cut increase in steam huff and puff development in heavy oil reservoirs, an alternating steam and CO2/viscosity reducer huff and puff method for IOR was proposed. In this work, the effect of CO2 on the physical properties of heavy oil was evaluated, and the optimal concentration of viscosity reducer for synergistic interaction between CO2 and the viscosity reducer was determined. Next, novel huff and puff simulation experiments by three sandpack models of different sizes in series were analyzed. Then, the IOR difference between the pure steam huff and puff experiments and the steam-alternating CO2/viscosity reducer huff and puff were compared. Finally, the CO2 storage rate was obtained based on the principle of the conservation of matter. The results show that the optimal viscosity reducer concentration, 0.8 wt%, can achieve a 98.5% reduction after combining CO2. The steam-alternating CO2/viscosity reducer huff and puff reached about 45 cm at 80 °C in the fifth cycle due to the CO2/viscosity reducer effects. CO2/viscosity reducer huff and puff significantly reduces water cut during cold production, with an ultimate IOR 15.89% higher than pure steam huff and puff. The viscosity reducer alleviates heavy oil blockages, and CO2 decreases oil viscosity and enhances elastic repulsion energy. The highest CO2 storage rate of 76.8% occurs in the initial stage, declining to 15.2% by the sixth cycle, indicating carbon sequestration potential. These findings suggest that steam-alternating CO2/viscosity reducer huff and puff improves heavy oil reservoir development and provides theoretical guidance for optimizing steam huff and puff processes.
- 25 November 2024
- Published by ASME International in Journal of Energy Resources Technology, Part B: Subsurface Energy and Carbon Capture
- Vol. 1 (1) , 1-13
Research for the Enhanced Oil Recovery Mechanism of Heavy Oil After Composite Huff and Puff Assisted by Edge-Bottom Water Displacement
In the late stage of exploiting heavy oil reservoirs with edge-bottom water, we are faced with problems such as high crude oil viscosity, channeling of bottom water, and rapid rise in water cut. To clarify the synergistic effect of N2, CO2, N2 foam, and viscosity reducer in water control and oil increase, and solve the problem of edge-bottom water rushing into production wells, one-dimensional sand-pack huff and puff experiments were carried out. First, the N2 foam huff and puff experiment evaluated the effect of N2 foam on controlling bottom water. Then the viscosity reducer assisted CO2 huff and puff experiment analyzed the synergistic viscosity reduction ability between the two to mobilize the remaining heavy oil. Next, the N2 foam-viscosity reducer-CO2 huff and puff experiment clarified the synergistic effect between the three. Finally, the N2 foam-viscosity reducer-CO2-N2 huff and puff experiment solved the problem of insufficient reservoir energy based on synergistic precipitation and oil increase. Experimental results show that N2 foam-viscosity reducer-CO2-N2 huff and puff is the optimal water control and oil increase solution. This solution can significantly reduce water production and increase oil production. In the one-dimensional sand-pack experiment, this technical solution reduced the water content by 68% and increased the recovery rate by 16.09%. The research results provide a reference for the development of exploitation technology schemes for similar edge-bottom water heavy oil reservoirs after entering high water cut.
- 25 November 2024
- Published by ASME International in Journal of Energy Resources Technology, Part B: Subsurface Energy and Carbon Capture
- Vol. 1 (1) , 1-13
Research for the Enhanced Oil Recovery Mechanism of Heavy Oil After Composite Huff and Puff Assisted by Edge-Bottom Water Displacement
In the late stage of exploiting heavy oil reservoirs with edge-bottom water, we are faced with problems such as high crude oil viscosity, channeling of bottom water, and rapid rise in water cut. To clarify the synergistic effect of N2, CO2, N2 foam, and viscosity reducer in water control and oil increase, and solve the problem of edge-bottom water rushing into production wells, one-dimensional sand-pack huff and puff experiments were carried out. First, the N2 foam huff and puff experiment evaluated the effect of N2 foam on controlling bottom water. Then the viscosity reducer assisted CO2 huff and puff experiment analyzed the synergistic viscosity reduction ability between the two to mobilize the remaining heavy oil. Next, the N2 foam-viscosity reducer-CO2 huff and puff experiment clarified the synergistic effect between the three. Finally, the N2 foam-viscosity reducer-CO2-N2 huff and puff experiment solved the problem of insufficient reservoir energy based on synergistic precipitation and oil increase. Experimental results show that N2 foam-viscosity reducer-CO2-N2 huff and puff is the optimal water control and oil increase solution. This solution can significantly reduce water production and increase oil production. In the one-dimensional sand-pack experiment, this technical solution reduced the water content by 68% and increased the recovery rate by 16.09%. The research results provide a reference for the development of exploitation technology schemes for similar edge-bottom water heavy oil reservoirs after entering high water cut.