YLYing Luo

Ying Luo

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Ying Luo has a total of 21 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    An FPGA-Based Reconfigurable Accelerator for Real-Time Affine Transformation in Industrial Imaging Heterogeneous SoC

    by Yang Zhang, Dejun Chen, Huixiong Ruan, Hongyu Jia, Yong Liu, Ying Luo

    Real-time affine transformation, a core operation for image correction and registration of industrial cameras and scanners, faces challenges including the high computational cost of interpolation and inefficient data access. In this study, we propose a reconfigurable accelerator architecture based on a heterogeneous system-on-chip (SoC). The architecture decouples tasks into control and data paths: the ARM core in the processing system (PS) handles parameter matrix generation and scheduling, whereas the FPGA-based acceleration module in programmable logic (PL) implements the proposed PATRM algorithm. By integrating multiplication-free design and affine matrix properties, PATRM adopts Q15.16 fixed-point computation and AXI4 burst transmission for efficient block data prefetching and pipelined processing. Experimental results demonstrate 25 frames per second (FPS) for 2095×2448 resolution images, representing a 128.21 M pixel/s throughput, which is 5.3× faster than the Block AT baseline with a peak signal-to-noise ratio (PSNR) exceeding 26 dB. Featuring low resource consumption and dynamic reconfigurability, the accelerator meets the real-time requirements of industrial scanner correction and other high-performance image processing tasks.


  • Open Access

    Dynamic adjustment of optimal sampling phase for non-source-synchronous parallel interfaces in FPGA systems

    by Juhe Ma, Dejun Chen, Huixiong Ruan, Hongyu Jia, Zexin Han, Jieheng Wang, Yong Liu, Ying Luo

    Timing misalignment in non-source-synchronous field-programmable gate array (FPGA) interfaces results in significant image degradation in cost-sensitive Contact Image Sensor (CIS) scanners. To address this issue, we propose a Dynamic Adjustment of Optimal Sampling Phase (DAOSP) module, which facilitates autonomous 360° phase scanning with a resolution of 78 ps. The DAOSP utilizes in-situ transition detection and closed-loop adjustment to achieve phase convergence within 5 μs, thereby eliminating the need for iterative FPGA bitstream regeneration. Implemented on Xilinx Artix-7 devices, this solution enables robust data capture at 120 MHz over 10 cm of unshielded cabling (BER<10⁻¹²) with minimal resource utilization (234 LUTs, 479 FFs). Deployed in over 200,000 industrial scanners, the DAOSP enhances the reconstructed image quality by 7.84 dB PSNR while obviating the need for production-line calibration. DAOSP provides a cost-effective, high-precision, and easily integrable solution in the field of FPGA data sampling.


  • Open Access

    Emerging Thermal Detectors Based on Low-Dimensional Materials: Strategies and Progress

    by Yang Peng, Jun Liu, Jintao Fu, Ying Luo, Xiangrui Zhao, Xingzhan Wei

    Thermal detectors, owing to their broadband spectral response and ambient operating temperature capabilities, represent a key technological avenue for surpassing the inherent limitations of traditional photon detectors. A fundamental trade-off exists between the thermal properties and the response performance of conventional thermosensitive materials (e.g., vanadium oxide and amorphous silicon), significantly hindering the simultaneous enhancement of device sensitivity and response speed. Recently, low-dimensional materials, with their atomically thin thickness leading to ultralow thermal capacitance and tunable thermoelectric properties, have emerged as a promising perspective for addressing these bottlenecks. Integrating low-dimensional materials with metasurfaces enables the utilization of subwavelength periodic configurations and localized electromagnetic field enhancements. This not only overcomes the limitation of low light absorption efficiency in thermal detectors based on low-dimensional materials (TDLMs) but also imparts full Stokes polarization detection capability, thus offering a paradigm shift towards multidimensional light field sensing. This review systematically elucidates the working principle and device architecture of TDLMs. Subsequently, it reviews recent research advancements in this field, delving into the unique advantages of metasurface design in terms of light localization and interfacial heat transfer optimization. Furthermore, it summarizes the cutting-edge applications of TDLMs in wideband communication, flexible sensing, and multidimensional photodetection. Finally, it analyzes the major challenges confronting TDLMs and provides an outlook on their future development prospects.


  • Open Access

    Photovoltage-Driven Photoconductor Based on Horizontal p-n-p Junction

    by Feng Han, Guanyu Mi, Ying Luo, Jian Lv

    The photoconductive gain theory demonstrates that the photoconductive gain is related to the ratio of carrier lifetime to carrier transit time. Theoretically, to achieve higher gain, one can either prolong the carrier lifetime or select materials with high mobility to shorten the transit time. However, the former slows the response speed of the device, while the latter increases the dark current and degrades device sensitivity. To address this challenge, a horizontal p-n-p junction-based photoconductor is proposed in this work. This device utilizes the n-region as the charge transport channel, with the charge transport direction perpendicular to the p-n-p junction. This design offers two advantages: (i) the channel is depleted by the space charge layer generated by the p and n regions, enabling the device to maintain a low dark current. (ii) The photovoltage generated in the p-n junction upon light absorption can compress the space charge layer and expand the conductive path in the n-region, enabling the device to achieve high gain and responsivity without relying on long carrier lifetimes. By adopting this device structure design, a balance between responsivity, dark current, and response speed is achieved, offering a new approach to designing high-performance photodetectors based on both traditional materials and emerging nanomaterials.