JHJi‐Hoon Han

Ji‐Hoon Han

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Ji‐Hoon Han has a total of 13 co-authors. Here are the top co-authors by number of shared publications:

  • Kyung‐Woo Yi

    Department of Materials Science and Engineering Seoul National University Seoul Republic of Korea

    2 shared publications
  • Yoonju Shin

    Metropolitan Seoul Center Korea Basic Science Institute (KBSI) Seoul Republic of Korea

    2 shared publications
  • Young Whan Cho

    Center for Hydrogen Energy Materials Korea Institute of Science and Technology (KIST) Seoul Republic of Korea

    2 shared publications
  • Hyun-Woo Gong

    Advanced Analysis Center, Korea Institute of Science and Technology (KIST), Seoul 02792, Republic of Korea

    1 shared publication
  • Jae-Pyoung Ahn

    Advanced Analysis Center, Korea Institute of Science and Technology (KIST), Seoul 02792, Republic of Korea

    1 shared publication
  • Kyung-Woo Yi

    Department of Materials Science and Engineering, Seoul National University, Seoul 08826, Republic of Korea

    1 shared publication

Latest Publications

  • Open Access

    HCl‐Free Mechanochemical Synthesis of Lithium Niobium Oxychlorides

    by Ji‐Hoon Han, Yoonju Shin, Young Joo Lee, Sangdoo Ahn, Young‐Su Lee, Kyung‐Woo Yi, Young Whan Cho

    Halide‐based oxychloride electrolytes, including LiNbOCl 4 , are promising candidates for all‐solid‐state batteries (ASSBs) due to their high ionic conductivity and compatibility with oxide cathodes. Common synthesis using LiOH and NbCl 5 produces corrosive HCl gas, raising environmental and safety concerns. Here, we report an alternative route using mixtures of oxides and chlorides that eliminates HCl byproduct. LiNbOCl 4 synthesized via this method forms a crystalline phase without postannealing and exhibits an ionic conductivity of 11.8 mS cm −1 at 25 °C. The soft lattice and flexible [NbOCl 4 ] − chains facilitate rapid Li + diffusion with low activation energy, enhancing ionic transport. Electrochemical tests demonstrate that LiNbOCl 4 functions effectively as a catholyte with high‐nickel cathodes (LiNi 0.8 Co 0.1 Mn 0.1 O 2 ) in a dual‐electrolyte architecture, underscoring its practical applicability. This work establishes a safe and environmentally friendly, HCl‐free mechanochemical synthesis pathway and highlights the critical role of precursor selection in achieving high‐conductivity oxyhalide solid electrolytes without postannealing for next‐generation ASSBs.


  • Open Access

    Characterization of densification behavior and mechanical properties of solid electrolyte powders for all solid-state batteries

    by Seung-Yong Lee, Ji-Hoon Han, Hyun-Woo Gong, Jae-Pyoung Ahn, Kyung-Woo Yi, Young Whan Cho

    BH4-substituted argyrodite solid electrolytes are mechanically softer and achieve near-theoretical density at lower pressures and room temperature compared to Cl- or Br-substituted counterparts, which is consistent with nanoindentation test results.


  • Open Access

    Wet Mechanochemical Synthesis of BH4‐Substituted Lithium Argyrodites

    by Ji‐Hoon Han, Yoonju Shin, Young Joo Lee, Sangdoo Ahn, Kyung‐Woo Yi, Young Whan Cho

    In all‐solid‐state batteries, a solid electrolyte with high ionic conductivity is required for fast charging, uniform lithium deposition, and increased cathode capacity. Lithium argyrodite with BH4− substitution has promising potential due to its higher ionic conductivity compared to argyrodites substituted with halides. In this study, Li5.25PS4.25(BH4)1.75, characterized by a high ionic conductivity of 13.8 mS cm−1 at 25 °C, is synthesized via wet ball‐milling employing o‐xylene. The investigation focused on optimizing wet ball‐milling parameters such as ball size, xylene content, drying temperature, as well as the amount of BH4− substitution in argyrodite. An all‐solid‐state battery prepared using Li5.25PS4.25(BH4)1.75 as the electrolyte and LiNbO3 coated NCM811 as the cathode exhibits an initial coulombic efficiency of 90.2% and maintains 93.9% of its initial capacity after 100 cycles at fast charging rate (5C). It is anticipated that the application of this wet mechanochemical synthesis will contribute further to the commercialization of all‐solid‐state batteries using BH4‐substituted argyrodites.