Do Thi Khanh Linh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Do Thi Khanh Linh has a total of 34 co-authors. Here are the top co-authors by number of shared publications:
- Le Xuan Chung
Institute for Nuclear Science, and Technology
4 shared publications - Bui Thi Hoa
Faculty of Physics, VNU University of Science, Hanoi, Vietnam
3 shared publications - Le Tuan Anh
Institute for Nuclear Science and Technology, VINATOM, 179 Hoang Quoc Viet, Hanoi, Viet Nam
3 shared publications M. Sferrazza
2 shared publicationsP.D. Khue
2 shared publicationsA. Massara
1 shared publication
Latest Publications
- 8 June 2025
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 1080
An alternative method for determining the isomeric yield ratio and its application for 102m,gRh formed in 103Rh(γ,n) reaction with 60, 65, and 70 MeV bremsstrahlung
- 8 June 2025
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 1080
An alternative method for determining the isomeric yield ratio and its application for 102m,gRh formed in 103Rh(γ,n) reaction with 60, 65, and 70 MeV bremsstrahlung
- 23 September 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 72 (3) , 608-613
Faraday Cup Development for Beam Monitoring and Cross-Sectional Measurement of p+¹²C Elastic Scattering With Eₚ = 0.95–3.2 MeV
A Faraday cup (FC) suitable for nA intensive beams has been developed to be used in nuclear reaction studies using the pelletron at Hanoi University of Science (HUS) - Vietnam National University (VNU). Firstly, the FC operation was tested with proton beams of 0.8 and 2.63 MeV energies bombarding a 0.081 μm 197 Au target. By varying the high voltage (-HV) applied to the FC’s repeller ring, current increase due to negative charge loss as secondary electron escape was investigated. Saturation was observed at about 50 V in both experiment and simulation using the CST Studio Suite software. Subsequently, the HV was set to -350 V to ensure the measuring current’s precision. Afterward, the FC was used in an experiment to measure the cross sections of p +12 C elastic scattering with Ep =0.95-3.2 MeV at the laboratory angles of 50°, 106°, 120°, 130°, and 160° for its validation and further study for this reaction. Good agreement was obtained between our new data and those reported in the literature. The new data were analyzed with the R-matrix approach. The extracted level parameters are consistent with those of previous studies.
- 23 September 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 72 (3) , 608-613
Faraday Cup Development for Beam Monitoring and Cross-Sectional Measurement of p+¹²C Elastic Scattering With Eₚ = 0.95–3.2 MeV
A Faraday cup (FC) suitable for nA intensive beams has been developed to be used in nuclear reaction studies using the pelletron at Hanoi University of Science (HUS) - Vietnam National University (VNU). Firstly, the FC operation was tested with proton beams of 0.8 and 2.63 MeV energies bombarding a 0.081 μm 197 Au target. By varying the high voltage (-HV) applied to the FC’s repeller ring, current increase due to negative charge loss as secondary electron escape was investigated. Saturation was observed at about 50 V in both experiment and simulation using the CST Studio Suite software. Subsequently, the HV was set to -350 V to ensure the measuring current’s precision. Afterward, the FC was used in an experiment to measure the cross sections of p +12 C elastic scattering with Ep =0.95-3.2 MeV at the laboratory angles of 50°, 106°, 120°, 130°, and 160° for its validation and further study for this reaction. Good agreement was obtained between our new data and those reported in the literature. The new data were analyzed with the R-matrix approach. The extracted level parameters are consistent with those of previous studies.