Alexander V. Kharakhordin
Alexander V. Kharakhordin has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Aleksandr Khegai
Prokhorov General Physics Institute of the Russian Academy of Sciences, Dianov Fiber Optics Research Center, Moscow, Russia
6 shared publications - Alexander V. Elopov
Prokhorov General Physics Institute of the Russian Academy of Sciences, Dianov Fiber Optics Research Center, Moscow, Russia
6 shared publications - Mikhail Aleksandrovich Melkumov
Prokhorov General Physics Institute of the Russian Academy of Sciences, Dianov Fiber Optics Research Center, Moscow, Russia
6 shared publications - Sergei V. Firstov
Prokhorov General Physics Institute of the Russian Academy of Sciences, Dianov Fiber Optics Research Center, Moscow, Russia
6 shared publications - Sergey Alyshev
Prokhorov General Physics Institute of the Russian Academy of Sciences, Dianov Fiber Optics Research Center, Moscow, Russia
6 shared publications - Andrey A. Umnikov
G.G. Devyatykh Institute of Chemistry of High-Purity Substances of the Russian Academy of Sciences
4 shared publications
Latest Publications
- 26 October 2026
- Published by Elsevier in Journal of Luminescence
- Vol. 301
Multi-center heterogeneous fibers doped with bismuth for advanced optical amplifiers
- 26 October 2026
- Published by Elsevier in Journal of Luminescence
- Vol. 301
Multi-center heterogeneous fibers doped with bismuth for advanced optical amplifiers
- 26 September 2025
- Published by Optica Publishing Group in Optics Letters
- Vol. 50 (19) , 6173-6176
Effect of optical anisotropy of bismuth active centers on polarization properties of fiber laser at 1.46 µm
A bismuth-doped fiber laser emitting optical radiation near 1.46 µm in two orthogonally polarized modes is presented. The laser was realized in an all-polarization-maintaining (PM) fiber configuration based on a gain medium with bismuth active centers associated with Si atoms (BACs-Si) and a fiber Bragg grating providing high reflectivity of two orthogonal polarizations. The single- and dual-polarized laser oscillations were achieved in various configurations. The polar plots of the laser output power in each mode as a function of pump polarization angle were obtained and analyzed. The conditions for achieving lasing in single- and dual-polarized modes were determined. In addition, the numerical model taking into account absorption and emission cross-section anisotropies of BACs-Si is proposed to study the behavior of the laser characteristics. The research can be useful for designing fiber laser sources with controllable polarization properties.
- 26 September 2025
- Published by Optica Publishing Group in Optics Letters
- Vol. 50 (19) , 6173-6176
Effect of optical anisotropy of bismuth active centers on polarization properties of fiber laser at 1.46 µm
A bismuth-doped fiber laser emitting optical radiation near 1.46 µm in two orthogonally polarized modes is presented. The laser was realized in an all-polarization-maintaining (PM) fiber configuration based on a gain medium with bismuth active centers associated with Si atoms (BACs-Si) and a fiber Bragg grating providing high reflectivity of two orthogonal polarizations. The single- and dual-polarized laser oscillations were achieved in various configurations. The polar plots of the laser output power in each mode as a function of pump polarization angle were obtained and analyzed. The conditions for achieving lasing in single- and dual-polarized modes were determined. In addition, the numerical model taking into account absorption and emission cross-section anisotropies of BACs-Si is proposed to study the behavior of the laser characteristics. The research can be useful for designing fiber laser sources with controllable polarization properties.
- 5 August 2025
- Published by Optica Publishing Group in Optics Letters
- Vol. 50 (16) , 4918-4921
Ultra-broadband optical amplifiers based on bismuth-doped heterogeneous-core fibers
We report on the development of a cladding-pumped ultra-broadband optical amplifier for a spectral region of 1260–1480 nm using a Bi-doped fiber (BDF) with heterogeneous core formed by combination of PO- and GeO-containing glass layers. This BDF design ensures a favorable local environment for the effective formation process of BACs associated with P and Si atoms. The BDF amplifier (BDFA) pumped into the cladding by multi-mode laser diodes at 793 and 808 nm is characterized by a peak gain of 24 dB, a minimum noise figure of 6 dB, and a bandwidth of 160 nm at a gain level of 20 dB. The effect of the parameters of the fiber design on the output characteristics of BDFA was analyzed by numerical simulation. The calculated data were in good agreement with the experimental ones, which allowed us to outline possible ways to improve the BDFA.
- 5 August 2025
- Published by Optica Publishing Group in Optics Letters
- Vol. 50 (16) , 4918-4921
Ultra-broadband optical amplifiers based on bismuth-doped heterogeneous-core fibers
We report on the development of a cladding-pumped ultra-broadband optical amplifier for a spectral region of 1260–1480 nm using a Bi-doped fiber (BDF) with heterogeneous core formed by combination of PO- and GeO-containing glass layers. This BDF design ensures a favorable local environment for the effective formation process of BACs associated with P and Si atoms. The BDF amplifier (BDFA) pumped into the cladding by multi-mode laser diodes at 793 and 808 nm is characterized by a peak gain of 24 dB, a minimum noise figure of 6 dB, and a bandwidth of 160 nm at a gain level of 20 dB. The effect of the parameters of the fiber design on the output characteristics of BDFA was analyzed by numerical simulation. The calculated data were in good agreement with the experimental ones, which allowed us to outline possible ways to improve the BDFA.
- 31 May 2025
- Published by Elsevier in Optical Fiber Technology
- Vol. 93
Dual-wavelength NIR lasers based on cladding-pumped bismuth-doped heterogeneous fibers
- 31 May 2025
- Published by Elsevier in Optical Fiber Technology
- Vol. 93
Dual-wavelength NIR lasers based on cladding-pumped bismuth-doped heterogeneous fibers
- 17 April 2025
- Published by Elsevier in Optical Materials
- Vol. 164
Thermally induced transformation of “dark” precursors into laser-active centers: Hidden potential of bismuth-doped fibers
- 17 April 2025
- Published by Elsevier in Optical Materials
- Vol. 164
Thermally induced transformation of “dark” precursors into laser-active centers: Hidden potential of bismuth-doped fibers
- 13 September 2024
- Published by Optica Publishing Group in Optics Letters
- Vol. 49 (18) , 5300-5303
Polarization-dependent gain in bismuth-doped phospho- and germanosilicate fiber amplifiers
Polarization-dependent gain (PDG) effect was studied in a conventional core-pumping configuration of bismuth-doped fiber amplifiers (BDFAs) based on PANDA-type phospho- and germanosilicate core fibers. The PDG value was determined as the gain difference between the orthogonal signal polarizations, which was found to be in range of 2.5–3 dB at total gain of >20 dB in such BDFAs. This effect is more pronounced for BDFA with a germanosilicate fiber. The experimental results are in a good agreement with the calculated data derived from the simulation model, relying on the anisotropy parameter of bismuth active centers (BACs) obtained from the degree of luminescence polarization, which ranges between 9 and 12% for BACs-Si and 18 and 22% for BACs-P. The obtained data can be useful for the optimization of performance of BDFAs and studying structural peculiarities of BACs.
- 13 September 2024
- Published by Optica Publishing Group in Optics Letters
- Vol. 49 (18) , 5300-5303
Polarization-dependent gain in bismuth-doped phospho- and germanosilicate fiber amplifiers
Polarization-dependent gain (PDG) effect was studied in a conventional core-pumping configuration of bismuth-doped fiber amplifiers (BDFAs) based on PANDA-type phospho- and germanosilicate core fibers. The PDG value was determined as the gain difference between the orthogonal signal polarizations, which was found to be in range of 2.5–3 dB at total gain of >20 dB in such BDFAs. This effect is more pronounced for BDFA with a germanosilicate fiber. The experimental results are in a good agreement with the calculated data derived from the simulation model, relying on the anisotropy parameter of bismuth active centers (BACs) obtained from the degree of luminescence polarization, which ranges between 9 and 12% for BACs-Si and 18 and 22% for BACs-P. The obtained data can be useful for the optimization of performance of BDFAs and studying structural peculiarities of BACs.