NXNertil Xhaferaj

Nertil Xhaferaj

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Nertil Xhaferaj has a total of 17 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Influence of Albanian Spring Water Mineral Composition on Fermentation Performance and Physicochemical Characteristics of Pale Ale Beer

    by Julian Karaulli, Onejda Kycyk, Fatbardha Lamce, Mamica Ruci, Nertil Xhaferaj, Bruno Testa, Albert Kopali, Massimo Iorizzo

    Water composition is a key factor influencing brewing performance and beer quality due to its impact on mash chemistry, fermentation kinetics, and fermentation-derived metabolites. This study evaluated the effect of four Albanian spring waters (Bogova, Germenji, Selita, and Lajthiza), each with distinct mineral compositions, on the fermentation behaviour and physicochemical characteristics of Pale Ale beer produced under standardised brewing conditions. All beers were brewed using the same malt formulation, hopping regime, yeast strain, and fermentation parameters, with water source as the sole experimental variable. The produced worts showed only moderate differences in pH, colour, extract, free amino nitrogen (FAN), bitterness, and density, whereas alcoholic fermentation proceeded efficiently in all treatments and was completed within seven days. Final alcohol contents ranged from 5.56 to 5.70% v/v, confirming comparable fermentation performance among treatments. More pronounced differences were observed in acidity-related parameters and fermentation-derived compounds. Volatile acidity ranged from 0.19 to 0.93 g/L, with the highest values in beers produced with Selita and Lajthiza waters. Glycerol concentrations varied from 0.88 to 1.24 g/L, with Germenji beer showing the highest value, whereas acetaldehyde ranged from 3.16 to 6.04 mg/L, with the lowest concentration in Germenji beer. Pearson correlation analysis and exploratory principal component analysis (PCA) identified associations between water mineralisation and selected physicochemical and fermentation-derived beer parameters. Calcium, magnesium, conductivity, and hardness were positively associated with glycerol concentration, whereas bicarbonate concentration was associated with beer pH and acidity-related parameters. The first two principal components explained 87.7% of the total variance. Overall, the results indicate that Albanian spring waters are suitable for Pale Ale production and show that differences in water mineral composition were associated with variations in the physicochemical and fermentation-derived characteristics of the final beers. These findings highlight that brewing water should not be regarded as a neutral processing medium but rather as an important technological factor associated with differences in the physicochemical characteristics of beer, while supporting the valorisation of Albanian spring waters for geographically distinctive craft brewing applications.

  • Open Access

    Influence of Albanian Spring Water Mineral Composition on Fermentation Performance and Physicochemical Characteristics of Pale Ale Beer

    by Julian Karaulli, Onejda Kycyk, Fatbardha Lamce, Mamica Ruci, Nertil Xhaferaj, Bruno Testa, Albert Kopali, Massimo Iorizzo

    Water composition is a key factor influencing brewing performance and beer quality due to its impact on mash chemistry, fermentation kinetics, and yeast metabolism. This study evaluated the effect of four Albanian spring waters (Bogova, Germenji, Selita, and Lajthiza), each with distinct mineral compositions, on the fermentation behaviour and physicochemical characteristics of Pale Ale beer produced under standardised brewing conditions. All beers were brewed using the same malt formulation, hopping regime, yeast strain, and fermentation parameters, with water source as the sole experimental variable. The beer worts showed only moderate differences in pH, colour, extract, and density, while alcoholic fermentation proceeded efficiently in all treatments and was completed within seven days. The final beers exhibited alcohol contents within the expected range for Pale Ale beers, while more pronounced differences were observed in acidity-related parameters and secondary metabolites. In particular, volatile acidity, glycerol, acetaldehyde, and organic acid concentrations varied significantly among treatments. Beers produced with Selita and Lajthiza waters showed higher volatile acidity and acetaldehyde levels, whereas Germenji water promoted increased glycerol production and lower acetaldehyde concentration. Correlation analysis and principal component analysis confirmed significant associations between brewing water mineralisation and fermentation-derived compounds. Calcium, magnesium, conductivity, and hardness were positively associated with glycerol production, while bicarbonate concentration influenced final beer pH and acidity development. Overall, the results demonstrate that Albanian spring waters are suitable for Pale Ale production and confirm that water mineral composition significantly affects yeast metabolism and the chemical profile of the final beers. These findings highlight the importance of water chemistry as a technological factor in craft beer production and may contribute to the valorisation of Albanian spring waters for geographically distinctive brewing applications.

  • Open Access

    Effect of Sequential Inoculation with Metschnikowia pulcherrima and Saccharomyces cerevisiae on the Chemical Composition of American Pale Ale (APA) Beer

    by Julian Karaulli, Nertil Xhaferaj, Bruno Testa, Rosaria Cozzolino, Cristina Matarazzo, Antonio de Nigris, Francesca Coppola, Mamica Ruci, Mariantonietta Succi, Renata Kongoli, et al.

    Recent studies have shown that the use of non-Saccharomyces yeasts, either alone or in co-fermentation with Saccharomyces cerevisiae, can enhance the development of specialty beers with distinctive compositional characteristics. This study aimed to evaluate the main compositional and sensory differences between American Pale Ale (APA) beers produced using the commercial strain S. cerevisiae US-05 as a single starter (Test 1), and those produced through sequential inoculation with Metschnikowia pulcherrima 62 followed by S. cerevisiae US-05 (Test 2). Analyses focused on key chemical parameters and volatile compounds at the end of primary fermentation (F1) and after 20 days of refermentation at 20 °C (F2). After F1, Test 2 samples showed higher concentrations of glycerol and higher alcohols (isoamyl alcohol, benzeneethanol) and lower concentrations of esters (isoamyl acetate, ethyl hexanoate, ethyl octanoate) compared to Test 1. After F2, the differences in higher alcohol content became less significant, whereas ester concentrations, particularly ethyl acetate and ethyl octanoate, were significantly higher in Test 2. Sensory evaluation revealed that beers from Test 2 exhibited more pronounced floral and fruity notes and achieved higher overall scores in the panel assessment. These findings indicate that sequential inoculation with M. pulcherrima 62 followed by S. cerevisiae enhances both the chemical complexity and sensory appeal of APA beers, highlighting the strain’s potential as a valuable tool for developing specialty beers with unique aromatic profiles.


  • Open Access

    Bioprospecting of Metschnikowia pulcherrima Strains, Isolated from a Vineyard Ecosystem, as Novel Starter Cultures for Craft Beer Production

    by Julian Karaulli, Nertil Xhaferaj, Francesca Coppola, Bruno Testa, Francesco Letizia, Onejda Kyçyk, Renata Kongoli, Mamica Ruci, Fatbardha Lamçe, Kapllan Sulaj, et al.

    Several studies in recent years have shown that the use of non-Saccharomyces yeasts, used both in single and in mixed fermentations with Saccharomyces cerevisiae, can help produce craft beers with distinctive compositional characteristics. The aim of this study was to evaluate the suitability of three Metschnikowia pulcherrima strains, isolated from Albanian vineyards, for use as starters in the brewing process. Because of its specific enzymatic activities (protease, β-glucosidase, and β-lyase) and its low production of hydrogen sulfide, M. pulcherrima 62 was selected as a starter culture for the production of craft beer. Specifically, the suitability of this yeast for use in sequential inoculation with S. cerevisiae S0-4 for the production of an American IPA-style beer and the main volatile compounds produced during fermentation were evaluated. The results show significant differences in the glycerol, isoamyl alcohol, and isoamyl acetate contents in beer obtained by sequential inoculum of M. pulcherrima 62 with S. cerevisiae S0-4 compared to beer obtained using S. cerevisiae S0-4 as a single starter. Therefore, these preliminary data support the candidacy of M. pulcherrima 62 as a new starter in the brewing process.


  • Open Access

    Bioprospecting of Metsnikowia pulcherrima Strains, Isolated from the Vineyard Ecosystem, as Novel Starter Cultures for Craft Beer Production

    by Julian Karaulli, Nertil Xhaferaj, Francesca Coppola, Bruno Testa, Francesco Letizia, Onejda Kyçyk, Renata Kongoli, Mamica Ruci, Fatbardha Lamçe, Kapllan Sulaj, et al.

    Several studies in recent years have shown that the use of non-Saccharomyces yeasts, used both in single and in mixed fermentations with Saccharomyces cerevisiae can help produce craft beers with distinctive compositional characteristics. The aim of this study was to evaluate the suitability of three Metschnikowia pulcherrima strains, isolated from Albanian vineyards, to be used as starters in the brewing process. Due to its specific enzymatic activities (protease, β-glucosidase and β-lyase) and its low production of hydrogen sulfide, M. pulcherrima 62 was selected as a starter culture for the production of craft beer. Specifically, the aptitude of this yeast to be used in sequential inoculation with S. cerevisiae S04 for the production of an American IPA-style beer and the main volatile compounds produced during fermentation were evaluated. Results showed significant differences in glycerol, isoamyl alcohol and isoamyl acetate content in beer obtained with sequential inoculum of M. pulcherrima 62 with S. cerevisiae S04 compared to beer obtained using S. cerevisiae S04 as a single starter. Therefore, these preliminary data support a candidacy of M. pulcherrima 62 as a new starter in the brewing process.