Dongdong Yang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Dongdong Yang has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
Hua Yang
7 shared publicationsFaqi Liu
Key Lab of Structures Dynamic Behaviour and Control, Ministry of Education, Harbin Institute of Technology, Harbin, China
4 shared publications- Faqi Liu
School of Civil Engineering Harbin Institute of Technology Harbin China
3 shared publications Shan-Shan Huang
Department of Civil and Structural Engineering, The University of Sheffield, Sheffield, UK
3 shared publications- Shan-Shan Huang
Department of Civil and Structural Engineering, University of Sheffield, Sheffield, UK
3 shared publications Guangyong Wang
2 shared publications
Latest Publications
- Open Access
Influence of Coupled Activated Recycled Fine Powder on the Performance of Ultra-High-Performance Concrete
Ultra-High-Performance Concrete (UHPC) is being increasingly utilized in major engineering projects due to its excellent mechanical properties, strong durability, and superior overall performance. Nevertheless, the widespread use of premium cementitious materials leads to high expenses and a substantial environmental impact. In this work, crushed recycled paste was calcined at 600 °C for two hours to produce calcined recycled fine powder (RFP) with varying hydration reactivity. UHPC was produced using the RFP in place of some of the cement. Chemical activation was accomplished by adding a composite activator system made up of Ca(OH)2, Na2SO4, Na2SiO3·9H2O, and K2SO4 in order to further improve the performance of UHPC. Particle size, viscosity, fluidity, mechanical properties, and hydration products were analyzed to establish the best activator type and dosage, as well as the ideal activation procedure for recycled fine powder. By mass replacement of cementitious materials, when 15.0% of the calcined recycled fine powder was added, the compressive strength of UHPC reached 149.1 MPa, a 23.2% increase over reference UHPC without calcined recycled fine powder. The results show that the calcined recycled fine powder ground for 60 min exhibits the highest activity. More hydrated products were formed in UHPC as a result of the addition of Ca(OH)2. The compressive strength peaked at 162.2 MPa at an incorporation rate of 1.5%, which is 8.8% higher than UHPC without an activator.
Open AccessInfluence of Coupled Activated Recycled Fine Powder on the Performance of Ultra-High-Performance Concrete
Ultra-High-Performance Concrete (UHPC) is being increasingly utilized in major engineering projects due to its excellent mechanical properties, strong durability, and superior overall performance. Nevertheless, the widespread use of premium cementitious materials leads to high expenses and a substantial environmental impact. In this work, crushed recycled paste was calcined at 600 °C for two hours to produce calcined recycled fine powder (RFP) with varying hydration reactivity. UHPC was produced using the RFP in place of some of the cement. Chemical activation was accomplished by adding a composite activator system made up of Ca(OH)2, Na2SO4, Na2SiO3·9H2O, and K2SO4 in order to further improve the performance of UHPC. Particle size, viscosity, fluidity, mechanical properties, and hydration products were analyzed to establish the best activator type and dosage, as well as the ideal activation procedure for recycled fine powder. By mass replacement of cementitious materials, when 15.0% of the calcined recycled fine powder was added, the compressive strength of UHPC reached 149.1 MPa, a 23.2% increase over reference UHPC without calcined recycled fine powder. The results show that the calcined recycled fine powder ground for 60 min exhibits the highest activity. More hydrated products were formed in UHPC as a result of the addition of Ca(OH)2. The compressive strength peaked at 162.2 MPa at an incorporation rate of 1.5%, which is 8.8% higher than UHPC without an activator.
- 12 October 2025
- Published by Elsevier in Journal of Building Engineering
- Vol. 114
Experimental study and simulation analysis on the fire performance of SRC column-RC beam frame structures
- 12 October 2025
- Published by Elsevier in Journal of Building Engineering
- Vol. 114
Experimental study and simulation analysis on the fire performance of SRC column-RC beam frame structures
- 18 September 2024
- Published by Springer Nature in International Journal of Steel Structures
- Vol. 24 (6) , 1406-1421
Fire Behaviour of Rectangular Steel Tubed-Reinforced-Concrete Columns with End Restraints
- 18 September 2024
- Published by Springer Nature in International Journal of Steel Structures
- Vol. 24 (6) , 1406-1421
Fire Behaviour of Rectangular Steel Tubed-Reinforced-Concrete Columns with End Restraints
- 24 November 2022
- Published by Elsevier in Journal of Constructional Steel Research
- Vol. 201
Axial compression behaviour of rectangular recycled aggregate concrete-filled steel tubular stub columns
- 24 November 2022
- Published by Elsevier in Journal of Constructional Steel Research
- Vol. 201
Axial compression behaviour of rectangular recycled aggregate concrete-filled steel tubular stub columns
- 3 October 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 41, 727-730
Tomography Technology of GIS Basin Insulator Based on Laser Ultrasonic
GIS is widely used in high voltage transmission and transformation system due to its small area and good insulation performance. As an important component of GIS, basin insulators play the role of supporting conductors, isolating gas chambers and electrical insulation. If there are cracks, bubbles and other defects in the basin insulator, partial discharge will be caused, which seriously threatens the safe and stable operation of the equipment. In order to conveniently and timely detect the cracks and bubbles of basin insulator, the GIS imaging method enhanced by laser focused ultrasound is proposed. This method can not only detect defects but also image, providing intuitive image information for power grid operation and maintenance personnel.
- 3 October 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 41, 727-730
Tomography Technology of GIS Basin Insulator Based on Laser Ultrasonic
GIS is widely used in high voltage transmission and transformation system due to its small area and good insulation performance. As an important component of GIS, basin insulators play the role of supporting conductors, isolating gas chambers and electrical insulation. If there are cracks, bubbles and other defects in the basin insulator, partial discharge will be caused, which seriously threatens the safe and stable operation of the equipment. In order to conveniently and timely detect the cracks and bubbles of basin insulator, the GIS imaging method enhanced by laser focused ultrasound is proposed. This method can not only detect defects but also image, providing intuitive image information for power grid operation and maintenance personnel.
- 1 October 2021
- Published by Elsevier in Structures
- Vol. 33, 1053-1076
Fire performance of eccentrically-loaded square and rectangular tubed-reinforced-concrete columns
- 1 October 2021
- Published by Elsevier in Structures
- Vol. 33, 1053-1076
Fire performance of eccentrically-loaded square and rectangular tubed-reinforced-concrete columns