LFLuciano Ferreyro

Luciano Ferreyro

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Luciano Ferreyro has a total of 34 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Ultraviolet plastic scintillators based on naphthalene-doped polystyrene and polyvinyltoluene

    by Nicolas Molina, Victoria Alejandra Gómez Andrade, Javier Martin Abbas, Alan Fuster, Luciano Ferreyro, Martin Alurralde, Martin Mirenda, María Dolores Pérez, Paula Giudici

    This work reports the fabrication and optical characterization of ultraviolet-emitting plastic scintillators based on polystyrene and polyvinyltoluene doped with different concentrations of naphthalene. Photoluminescence measurements show that naphthalene incorporation enhances the emission intensity, inducing a red shift in the emission wavelength of polystyrene, while naphthalene-doped polyvinyltoluene exhibits a bimodal emission with peaks around 335 and 350 nm. Time-resolved photoluminescence reveals fast decay components for the undoped matrices and a dominant slow component of approximately 87 ns in the doped samples. Scintillation light yield measurements indicate moderate performance for the undoped polymers and a significant enhancement upon naphthalene doping. Proton irradiation experiments reveal a reduction in light yield for all samples, with naphthalene-doped polyvinyltoluene retaining a larger fraction of its initial light yield compared to polystyrene-based scintillators, indicating improved radiation tolerance. Overall, these results demonstrate the effectiveness of naphthalene as an ultraviolet emission enhancer and highlight naphthalene-doped polyvinyltoluene as a promising candidate for compact and radiation-resistant scintillation detectors.

  • Toward a Superconducting Magnetic Thermal Modulator for Bolometric Detectors

    by Enrico Petriella, Matías Hampel, Juan J. Bonaparte, Jesús Bonilla-Neira, Gabriel Bosch, Juan M. Geria, Nahuel Müller, Manuel García Redondo, Lucía Sucunza, Luciano Ferreyro, et al.

    We present the preliminary development and characterization of a superconducting thermal switch designed to modulate the thermal response of cryogenic bolometers. The device uses an aluminum thermal link whose conductance is modulated by a niobium control coil. Initial measurements confirm the feasibility of the switching principle and demonstrate dynamic operation at least up to 50 kHz. These early results indicate that this approach can shift the signal spectrum away from 1/f noise, with ongoing efforts focused on integration with bolometric sensors and optimizing device geometry.

  • Microwave SQUID Multiplexer Readout Performance Using a Direct-RF RFSoC-Based Software-Defined Radio

    by M. E. García Redondo, J. D. Bonilla Neira, N. A. Müller, L. P. Ferreyro, J. M. Geria, T. Muscheid, R. Gartmann, A. Almela, M. R. Hampel, L. Ardila-Perez, et al.

    In this work, we report the experimental readout results of a $µ$ MUX device using a Direct-RF Software-Defined Radio (SDR) prototype based on the ZCU216 Radio-Frequency System-on-Chip (RFSoC) evaluation board. First, the Direct-RF SDR architecture is described. Then, the analog performance of the SDR system was characterized both in loopback and when coupled to the cryogenic multiplexing system to evaluate the noise contributions of the SDR readout system. Later, the SDR system performance was optimized for $µ$ MUX readout, focusing on bolometric applications. Finally, the minimum demodulated flux noise was obtained through the optimally conditioned readout of a $µ$ MUX channel. The results obtained showed a minimum demodulated white flux noise of $\approx 4 \mu \Phi _{0}/\sqrt{Hz}$ in both demodulation domains (i.e. amplitude $\gamma$ and resonator phase $\theta$) and dominated by the cryogenic microwave chain noise temperature of $T_{n}^{cryo}=4.6$ K. These results are comparable to those obtained with traditional SDR architectures and demonstrate that the Direct-RF SDR prototype is suitable for the readout of $µ$ MUX devices.

  • Josephson Arbitrary Waveform Synthesizer for Flux-Ramp Modulation in Microwave SQUID Multiplexers

    by Matías Hampel, Luciano Ferreyro, Oliver Kieler, Ricardo Iuzzolino, Mariano Real, Stephan Bauer, Nahuel Müller, Jesús Bonilla Neira, Manuel García Redondo, Juan Bonaparte, et al.

    Microwave SQUID multiplexers (μMUX) have become a key technology for the readout of large arrays of low-temperature detectors, particularly in cosmic microwave background experiments. A critical element of this technique is the flux-ramp modulation signal, whose noise, especially at low frequencies, directly limits the readout performance. This work proposes and experimentally demonstrates the use of a Josephson Arbitrary Waveform Synthesizer (JAWS) as a low-noise, high precision source for generating the sawtooth-shaped flux-ramp signal required in μMUX readout systems. The JAWS, based on the AC Josephson effect, provides intrinsically quantized and spectrally pure waveforms with excellent signal-to-noise ratio. The operation of a 9000-junction JAWS array is characterized and integrated with a cryogenic μMUX device and a custom SDR-based readout system. With this setup, the noise floor level around the harmonic typically used for phase demodulation of the SQUID signal to recover the detector signal was −104dBc/Hz, and the signal-to-noise ratio of this harmonic was 73dB. These results demonstrate the feasibility of using JAWS-based waveform synthesis for μMUX flux-ramp generation.

  • Development of a Microwave SQUID Multiplexer for Magnetic Microbolometers

    by N. Müller, J. Bonilla-Neira, J. Geria, M. García Redondo, L. Ferreyro, M. Hampel, M. Wegner, A. Almela, S. Kempf

    The search for primordial B-modes in the cosmic microwave background (CMB) requires highly sensitive and scalable detector systems. The magnetic microbolometer (MMB) is an emerging detector concept that exploits the magnetic properties of paramagnetic materials at sub-kelvin temperatures, offering bolometers with a high dynamic range and low intrinsic noise. In recent years, the microwave SQUID multiplexer ($\mu$MUX) has become a key technology to efficiently read large low-temperature detector arrays, enabling the readout of hundreds to thousands of detectors over a single transmission line with low noise and minimal power dissipation while reducing the cryogenic setup complexity. In this work, we report the design, fabrication and characterization of a $\mu$MUX optimized for MMB detectors and share our latest experimental results from a bolometer prototype. These findings provide valuable insight of the $\mu$MUX in advancing next-generation CMB instrumentation and also demonstrate its suitability for novel detector technologies such as the MMB.


  • Open Access

    Optimal demodulation domain for microwave SQUID multiplexers in presence of readout system noise

    by M. E. García Redondo, N. A. Müller, J. M. Salum, L. P. Ferreyro, J. D. Bonilla-Neira, J. M. Geria, J. J. Bonaparte, T. Muscheid, R. Gartmann, A. Almela, et al.

    The Microwave SQUID Multiplexer (μMUX) is the device of choice for the readout of a large number of low-temperature detectors in a wide variety of experiments within the fields of astronomy and particle physics. While it offers large multiplexing factors, the system noise performance is highly dependent on the cold- and warm-readout electronic systems used to read it out, as well as the demodulation domain and parameters chosen. In order to understand the impact of the readout systems in the overall detection system noise performance, first, we extended the available μMUX simulation frameworks, including additive and multiplicative noise sources in the probing tones (i.e., phase and amplitude noise), along with the capability of demodulating the scientific data, either in the resonator’s phase or the scattering amplitude. Then, considering the additive noise as a dominant noise source, the optimum readout parameters to achieve minimum system noise were found for both open-loop and flux-ramp demodulation schemes in the aforementioned domains. Later, we evaluated the system noise sensitivity to multiplicative noise sources under the optimum readout parameters. Finally, as a case study, we evaluated the optimal demodulation domain and the expected system noise level for a typical software-defined radio readout system. This work leads to an improved system performance prediction and noise engineering based on the available readout electronics and the selected demodulation domain.