Farhana Khanam Ferdousi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Farhana Khanam Ferdousi has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Ahsan Habib
Department of Chemistry, University of Dhaka, Dhaka 1000, Bangladesh
3 shared publications - Abdul Fatah Larik1 shared publication
- Chandan Halder1 shared publication
- Farhana Jahan
BCSIR Rajshahi Laboratories, Bangladesh Council of Scientific and Industrial Research (BCSIR), Rajshahi - 6206, Bangladesh
1 shared publication - Fuad Mahamud
Department of Chemistry Faculty of Science University of Dhaka Dhaka Bangladesh du.ac.bd
1 shared publication - Masudur Rahman Rahat
James Tarpo Jr. and Margaret Tarpo Department of Chemistry, Purdue University, West Lafayette, Indiana 47907, USA
1 shared publication
Latest Publications
- Open Access
- 1 January 2026
- Published by Wiley in Journal of Chemistry
- Vol. 2026 (1) , 3253574
Synthesis, Spectroscopic Profiles, and Crystallographic Indexing of N , N ’‐Ethylenebis(acetylacetoneimine) Complexes: Deepened DFT Functional Benchmarking, NBO Analysis, and Targeted Antimicrobial Evaluations
In this study, a Schiff base (H 2 L) was synthesized through reaction of acetylacetone with ethylenediamine. The ligand was employed to coordinate complex with Co 2+ , Ni 2+ , Cu 2+ , and Zn 2+ ions. NMR, FTIR, UV–Visible spectroscopy, XRD, and molar conductivity were used to characterize the synthesized compounds. Other physicochemical properties like melting points and solubility were also determined. Significant changes in the maxima of the absorption of UV–Visible spectra were evidence of the formation of the metal complexes. The complexes had low values of molar conductivity ( Λ m < 15 S cm 2 mol −1 ) which shows they are nonelectrolytes. The optimization of the molecular structures of the ligand and the metal complexes was done using DFT calculations with the B3LYP/6‐31 G (d, p ) basis set. Quantum chemical parameters, charge distribution, and molecular orbital analyses were performed in order to get insight into their reactiveness and electronic structure. In aition, the Schiff base and metal complexes were tested against Gram‐positive and Gram‐negative bacteria on antibacterial activity, and the findings were compared with the molecular docking data. The Cu(II) complex had the most antibacterial activity of all the tested compounds which means that it can be used as a bioactive agent.
- 1 January 2026
- Published by Wiley in Journal of Chemistry
- Vol. 2026 (1) , 3253574
Open AccessSynthesis, Spectroscopic Profiles, and Crystallographic Indexing of N , N ’‐Ethylenebis(acetylacetoneimine) Complexes: Deepened DFT Functional Benchmarking, NBO Analysis, and Targeted Antimicrobial Evaluations
In this study, a Schiff base (H 2 L) was synthesized through reaction of acetylacetone with ethylenediamine. The ligand was employed to coordinate complex with Co 2+ , Ni 2+ , Cu 2+ , and Zn 2+ ions. NMR, FTIR, UV–Visible spectroscopy, XRD, and molar conductivity were used to characterize the synthesized compounds. Other physicochemical properties like melting points and solubility were also determined. Significant changes in the maxima of the absorption of UV–Visible spectra were evidence of the formation of the metal complexes. The complexes had low values of molar conductivity ( Λ m < 15 S cm 2 mol −1 ) which shows they are nonelectrolytes. The optimization of the molecular structures of the ligand and the metal complexes was done using DFT calculations with the B3LYP/6‐31 G (d, p ) basis set. Quantum chemical parameters, charge distribution, and molecular orbital analyses were performed in order to get insight into their reactiveness and electronic structure. In aition, the Schiff base and metal complexes were tested against Gram‐positive and Gram‐negative bacteria on antibacterial activity, and the findings were compared with the molecular docking data. The Cu(II) complex had the most antibacterial activity of all the tested compounds which means that it can be used as a bioactive agent.
- Open Access
- 1 January 2024
- Published by Wiley in Journal of Chemistry
- Vol. 2024 (1)
Water‐Soluble Inorganic Anions in Fine Particulate Matter (PM2.5) in Dhaka, Bangladesh: Source Apportionment
Bangladesh is one of the most populated countries in the world. More than 200 air quality index values were recorded in January and February since 2017, indicating that the air quality was unhealthy to very unhealthy. In this work, water‐soluble inorganic anions (WSIAs) in fine particulate matter (PM2.5) in Dhaka, the capital of Bangladesh with a population of around 21 million, were evaluated. Accordingly, PM2.5 was collected using a quartz filter coupled with an active air sampler set in Dhaka University campus, Bangladesh, during February 2023, to analyze WSIAs. The 24‐h average PM2.5 mass, 156 ± 44.8 μg/m3, was almost nine times higher than the WHO limit values of 15.0 μg/m3 and about three times higher than the Bangladesh Department of Environment limits of 65.0 μg/m3. Fluoride, chloride, bromide, nitrite, nitrate, phosphate, and sulfate were among the water‐soluble ions that were determined using ion chromatography. While bromide and nitrite were found to be below the detection limit, the mean concentrations of fluoride, chloride, nitrate, phosphate, and sulfate were determined to be 0.086 ± 0.010, 2.27 ± 0.332, 10.2 ± 1.29, 2.23 ± 0.424, and 11.0 ± 1.45 μg/m3, respectively. The highest levels of PM2.5 and the relevant anions were determined to be present during February 9‐10, 2023. Sulfate accounted for almost 43% of the anions in the overall PM2.5. According to the results of the statistical analysis, the high concentrations of sulfate and nitrate in PM2.5 in Dhaka, Bangladesh, were primarily caused by sulfur‐containing fossil fuels, especially sulfur‐containing diesel, coal, and unfit automobiles, while the main sources of fluoride and chloride were fire retardants, burning of textile, and municipal solid wastes. All of these sources have the ability to produce PM2.5.
- 1 January 2024
- Published by Wiley in Journal of Chemistry
- Vol. 2024 (1)
Open AccessWater‐Soluble Inorganic Anions in Fine Particulate Matter (PM2.5) in Dhaka, Bangladesh: Source Apportionment
Bangladesh is one of the most populated countries in the world. More than 200 air quality index values were recorded in January and February since 2017, indicating that the air quality was unhealthy to very unhealthy. In this work, water‐soluble inorganic anions (WSIAs) in fine particulate matter (PM2.5) in Dhaka, the capital of Bangladesh with a population of around 21 million, were evaluated. Accordingly, PM2.5 was collected using a quartz filter coupled with an active air sampler set in Dhaka University campus, Bangladesh, during February 2023, to analyze WSIAs. The 24‐h average PM2.5 mass, 156 ± 44.8 μg/m3, was almost nine times higher than the WHO limit values of 15.0 μg/m3 and about three times higher than the Bangladesh Department of Environment limits of 65.0 μg/m3. Fluoride, chloride, bromide, nitrite, nitrate, phosphate, and sulfate were among the water‐soluble ions that were determined using ion chromatography. While bromide and nitrite were found to be below the detection limit, the mean concentrations of fluoride, chloride, nitrate, phosphate, and sulfate were determined to be 0.086 ± 0.010, 2.27 ± 0.332, 10.2 ± 1.29, 2.23 ± 0.424, and 11.0 ± 1.45 μg/m3, respectively. The highest levels of PM2.5 and the relevant anions were determined to be present during February 9‐10, 2023. Sulfate accounted for almost 43% of the anions in the overall PM2.5. According to the results of the statistical analysis, the high concentrations of sulfate and nitrate in PM2.5 in Dhaka, Bangladesh, were primarily caused by sulfur‐containing fossil fuels, especially sulfur‐containing diesel, coal, and unfit automobiles, while the main sources of fluoride and chloride were fire retardants, burning of textile, and municipal solid wastes. All of these sources have the ability to produce PM2.5.
- Open Access
- 1 January 2024
- Published by Wiley in Journal of Chemistry
- Vol. 2024 (1)
Preparation of the Binder from Banana Pseudostem Waste and Its Application in Pigment Dyeing
The disposal of banana pseudostem waste creates substantial environmental concerns. To address this issue, it is crucial to explore the potential of converting this abundant waste into valuable industrial products. Therefore, this research was designed to explore the utilization of banana pseudostem fiber waste (BPW) in the development of a textile binder. Solvothermal digestion of pseudostem fibers into ammonia followed by neutralization with sulfuric acid resulted in viscous gel which was tested as a binder (BPW‐binder) for the pigment dying process. Various parameters, including curing, washing fastness, tensile strength, stiffness, and light fastness, were examined to compare the performance of the two binders. The results showed that the BPW‐binder performed similarly to the commercial Halzarin binder in terms of washing fastness and did not leave any stains on the multifibre strip. Both binders demonstrated excellent light fastness, with a rating of 8 on the blue wool scale for both cotton and cotton‐polyester fabrics. However, there were slight variations in elongation and stiffness between the two binders with values ranging from 9.41 to 28.26% and 1.5 to 1.9 CMS across different fabric types, which were dependent on the fabric. Fourier transform infrared analysis revealed lignin amine salt peaks in the banana pseudostem‐based BPW‐binder, while scanning electron microscope images of BPW‐binder treated fabrics confirmed suitable binder properties with a rough and ordered lamellar surface. This study demonstrates the potential of transforming banana pseudostem fiber waste into a sustainable textile binder through an efficient and straightforward process. The BPW‐binder showed comparable performance to the synthetic commercial binder, indicating its potential as a sustainable replacement in the industry.
- 1 January 2024
- Published by Wiley in Journal of Chemistry
- Vol. 2024 (1)
Open AccessPreparation of the Binder from Banana Pseudostem Waste and Its Application in Pigment Dyeing
The disposal of banana pseudostem waste creates substantial environmental concerns. To address this issue, it is crucial to explore the potential of converting this abundant waste into valuable industrial products. Therefore, this research was designed to explore the utilization of banana pseudostem fiber waste (BPW) in the development of a textile binder. Solvothermal digestion of pseudostem fibers into ammonia followed by neutralization with sulfuric acid resulted in viscous gel which was tested as a binder (BPW‐binder) for the pigment dying process. Various parameters, including curing, washing fastness, tensile strength, stiffness, and light fastness, were examined to compare the performance of the two binders. The results showed that the BPW‐binder performed similarly to the commercial Halzarin binder in terms of washing fastness and did not leave any stains on the multifibre strip. Both binders demonstrated excellent light fastness, with a rating of 8 on the blue wool scale for both cotton and cotton‐polyester fabrics. However, there were slight variations in elongation and stiffness between the two binders with values ranging from 9.41 to 28.26% and 1.5 to 1.9 CMS across different fabric types, which were dependent on the fabric. Fourier transform infrared analysis revealed lignin amine salt peaks in the banana pseudostem‐based BPW‐binder, while scanning electron microscope images of BPW‐binder treated fabrics confirmed suitable binder properties with a rough and ordered lamellar surface. This study demonstrates the potential of transforming banana pseudostem fiber waste into a sustainable textile binder through an efficient and straightforward process. The BPW‐binder showed comparable performance to the synthetic commercial binder, indicating its potential as a sustainable replacement in the industry.