Yuhan Sun
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Yuhan Sun has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Chenkai Deng
Shenzhen Polytechnic University
5 shared publications - Yu-Long Jiang
Fudan University
5 shared publications - Kangyao Wen
State Key Laboratory of ASIC and System, College of Integrated Circuits and Micro-Nano Electronics, Fudan University, Shanghai, China
4 shared publications - Wenmao Li
School of Microelectronics, the Engineering Research Center of Integrated Circuits for Next-Generation Communications, Ministry of Education, and the GaN Device Engineering Technology Research Center of Guangdong, Southern University of Science and Technology (SUSTech), Shenzhen, China
4 shared publications - Hongyu Yu
Shenzhen Polytechnic University
3 shared publications - Jiaqi He
School of Microelectronics, Southern University of Science and Technology 1 , Shenzhen 518055, China
3 shared publications
Latest Publications
- 12 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 26 (4) , 5369-5375
A High Sensitivity and Linearity AlGaN/GaN SBD Thermal Sensor With Partially Recessed AlGaN Barrier Layer Near the Pt Anode
An AlGaN/gallium nitride (GaN) Heterostructurebased Schottky barrier diode (SBD) temperature sensor with partially recessed AlGaN barrier layer near the Pt anode and 40-nm SiO2 dielectric under the field plate is proposed for high sensitivity and linearity thermal sensing. The partially thinned AlGaN barrier layer and the 40-nm dielectric with a high work function Pt anode metal collectively result in a lower 2-D electron gas (2DEG) density with a higher Schottky barrier and a wider depletion region, leading to a lower tunneling current with a higher thermal sensitivity and linearity below the turn on voltage. It is experimentally revealed that the SBD with a 3-nm residual AlGaN layer demonstrated the highest sensitivity of 3.75 mV/K with a linearity of 0.997 at 8 $\times$ 10-6 A. The systemic TCAD analysis was conducted to reveal the effects of the anode metal work function and the AlGaN barrier thickness toward the thermal sensing performance of the SBD. This work explores the optimum conditions to reduce the total tunneling current for the AlGaN/GaN-based thermal sensors and shows a great potential for high-performance thermal sensing applications in AlGaN/GaN Heterostructure-based power ICs without the introduction of p-GaN.
- 12 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 26 (4) , 5369-5375
A High Sensitivity and Linearity AlGaN/GaN SBD Thermal Sensor With Partially Recessed AlGaN Barrier Layer Near the Pt Anode
An AlGaN/gallium nitride (GaN) Heterostructurebased Schottky barrier diode (SBD) temperature sensor with partially recessed AlGaN barrier layer near the Pt anode and 40-nm SiO2 dielectric under the field plate is proposed for high sensitivity and linearity thermal sensing. The partially thinned AlGaN barrier layer and the 40-nm dielectric with a high work function Pt anode metal collectively result in a lower 2-D electron gas (2DEG) density with a higher Schottky barrier and a wider depletion region, leading to a lower tunneling current with a higher thermal sensitivity and linearity below the turn on voltage. It is experimentally revealed that the SBD with a 3-nm residual AlGaN layer demonstrated the highest sensitivity of 3.75 mV/K with a linearity of 0.997 at 8 $\times$ 10-6 A. The systemic TCAD analysis was conducted to reveal the effects of the anode metal work function and the AlGaN barrier thickness toward the thermal sensing performance of the SBD. This work explores the optimum conditions to reduce the total tunneling current for the AlGaN/GaN-based thermal sensors and shows a great potential for high-performance thermal sensing applications in AlGaN/GaN Heterostructure-based power ICs without the introduction of p-GaN.
- 15 December 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 127 (24)
Optimization of electric field distribution for AlGaN/GaN MIS-HEMT with thick i-GaN cap layer
The significant optimization of electric field distribution for AlGaN/GaN metal-insulator-semiconductor high electron mobility transistor (MIS-HEMT) with a thick i-GaN cap layer is reported. The thick i-GaN cap layer is introduced to generate two-dimensional hole gas (2DHG), thereby reducing the electron concentration in the two-dimensional electron gas (2DEG) layer under off-state, in contrast to the high electron concentration in the 2DEG layer under off-state for the MIS-HEMT with a p-type or insulating passivation layer. Due to the low electron concentration in the 2DEG layer and the introduction of the thick i-GaN cap layer, a wide depletion region forms in this cap layer just close to the drain electrode under off-state, resulting in a low electric field intensity both in the whole access region and in the region close to the gate. Thus, the adverse effect induced by the high electric field strength under off-state, such as the large dynamic on-resistance (Ron), is significantly mitigated.
- 15 December 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 127 (24)
Optimization of electric field distribution for AlGaN/GaN MIS-HEMT with thick i-GaN cap layer
The significant optimization of electric field distribution for AlGaN/GaN metal-insulator-semiconductor high electron mobility transistor (MIS-HEMT) with a thick i-GaN cap layer is reported. The thick i-GaN cap layer is introduced to generate two-dimensional hole gas (2DHG), thereby reducing the electron concentration in the two-dimensional electron gas (2DEG) layer under off-state, in contrast to the high electron concentration in the 2DEG layer under off-state for the MIS-HEMT with a p-type or insulating passivation layer. Due to the low electron concentration in the 2DEG layer and the introduction of the thick i-GaN cap layer, a wide depletion region forms in this cap layer just close to the drain electrode under off-state, resulting in a low electric field intensity both in the whole access region and in the region close to the gate. Thus, the adverse effect induced by the high electric field strength under off-state, such as the large dynamic on-resistance (Ron), is significantly mitigated.
- 4 September 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 46 (11) , 2130-2133
A Novel Discrete GaN/AlGaN/GaN-Based Schottky Diode Thermal Sensor With a Sensitivity Up to 13.3 mV/K
A novel discrete GaN/AlGaN/GaN heterostructure-based Schottky barrier diode (SBD) thermal sensor is proposed, demonstrating a very high thermal sensitivity of 13.3 mV/K with a linearity of 0.992 at 10-5 A for 45 nm GaN cap over a temperature range of 298 K to 573 K using Pt as the anode. Samples with different GaN cap thickness were fabricated to obtain variable temperature sensitivities with linearity above 0.99. A Schottky diode model with an applied bias (VD) dependent equivalent Schottky barrier height (ΦB) is proposed to explain the much higher temperature sensitivity than the conventional AlGaN/GaN SBD thermal sensor. The TCAD simulation clearly confirms the VD dependent ΦB and reveals its effect on amplifying the thermal sensitivity, and the fitting curves calculated by the equivalent equation fits well with the simulation data. This work demonstrates an area and cost-saving solution for the high performance AlGaN/GaN-based temperature sensor applications.
- 4 September 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 46 (11) , 2130-2133
A Novel Discrete GaN/AlGaN/GaN-Based Schottky Diode Thermal Sensor With a Sensitivity Up to 13.3 mV/K
A novel discrete GaN/AlGaN/GaN heterostructure-based Schottky barrier diode (SBD) thermal sensor is proposed, demonstrating a very high thermal sensitivity of 13.3 mV/K with a linearity of 0.992 at 10-5 A for 45 nm GaN cap over a temperature range of 298 K to 573 K using Pt as the anode. Samples with different GaN cap thickness were fabricated to obtain variable temperature sensitivities with linearity above 0.99. A Schottky diode model with an applied bias (VD) dependent equivalent Schottky barrier height (ΦB) is proposed to explain the much higher temperature sensitivity than the conventional AlGaN/GaN SBD thermal sensor. The TCAD simulation clearly confirms the VD dependent ΦB and reveals its effect on amplifying the thermal sensitivity, and the fitting curves calculated by the equivalent equation fits well with the simulation data. This work demonstrates an area and cost-saving solution for the high performance AlGaN/GaN-based temperature sensor applications.
- 29 January 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 25 (5) , 8024-8031
A Novel AlGaN/GaN SBD Thermal Sensor With Ultralow Power, Excellent Linearity, and High Sensitivity
A novel AlGaN/GaN Schottky barrier diode (SBD) thermal sensor featuring a recessed anode and a thin Al0.25Ga0.75N barrier layer is fabricated, which is demonstrated to have ultralow power, excellent linearity and high sensitivity for thermal sensing. The AlGaN layer thickness is employed to trade off the tunneling current proportion against the two dimensional electron gas (2DEG) density for the thermionic emission (TE) dominated electron transportation with better linearity and high sensitivity of thermal sensing at ultralow power. A sensitivity of 1.39 mV/K with a linearity of 0.995 operating at 0.082 - 0.324 V for a constant current of 10-7 A is revealed. The proposed SBD sensor shows the great potential application for on-chip, low power, and high performance thermal sensing in monolithic AlGaN/GaN heterostructure based power ICs.
- 29 January 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 25 (5) , 8024-8031
A Novel AlGaN/GaN SBD Thermal Sensor With Ultralow Power, Excellent Linearity, and High Sensitivity
A novel AlGaN/GaN Schottky barrier diode (SBD) thermal sensor featuring a recessed anode and a thin Al0.25Ga0.75N barrier layer is fabricated, which is demonstrated to have ultralow power, excellent linearity and high sensitivity for thermal sensing. The AlGaN layer thickness is employed to trade off the tunneling current proportion against the two dimensional electron gas (2DEG) density for the thermionic emission (TE) dominated electron transportation with better linearity and high sensitivity of thermal sensing at ultralow power. A sensitivity of 1.39 mV/K with a linearity of 0.995 operating at 0.082 - 0.324 V for a constant current of 10-7 A is revealed. The proposed SBD sensor shows the great potential application for on-chip, low power, and high performance thermal sensing in monolithic AlGaN/GaN heterostructure based power ICs.
- 30 September 2024
- Published by AIP Publishing in Applied Physics Letters
- Vol. 125 (14)
Charge trapping gate stack enabled non-recessed normally off AlGaN/GaN HEMT with high threshold voltage stability
This paper reports a non-recessed normally off AlGaN/GaN high-electron-mobility transistor (HEMT) with a charge trapping gate dielectric stack. The charge trapping gate dielectric stack featuring a low density of fixed positive charges consists of an O3-based Al2O3 tunneling layer and an O3-based HfO2 blocking layer, both deposited via atomic layer deposition. For HEMT with a 15 nm AlGaN barrier layer, a threshold voltage of 2.57 V and an on-resistance of 8.50 Ω × mm are achieved. For positive bias temperature instability (PBTI) testing, the electric field provided by the 15 nm AlGaN layer serves as a barrier to channel carriers, significantly enhancing the PBTI test stability. The optimized gate dielectric stack enables the fabrication of the non-recessed normally off metal–insulator–semiconductor-HEMT with enhanced threshold voltage (Vth) stability.
- 30 September 2024
- Published by AIP Publishing in Applied Physics Letters
- Vol. 125 (14)
Charge trapping gate stack enabled non-recessed normally off AlGaN/GaN HEMT with high threshold voltage stability
This paper reports a non-recessed normally off AlGaN/GaN high-electron-mobility transistor (HEMT) with a charge trapping gate dielectric stack. The charge trapping gate dielectric stack featuring a low density of fixed positive charges consists of an O3-based Al2O3 tunneling layer and an O3-based HfO2 blocking layer, both deposited via atomic layer deposition. For HEMT with a 15 nm AlGaN barrier layer, a threshold voltage of 2.57 V and an on-resistance of 8.50 Ω × mm are achieved. For positive bias temperature instability (PBTI) testing, the electric field provided by the 15 nm AlGaN layer serves as a barrier to channel carriers, significantly enhancing the PBTI test stability. The optimized gate dielectric stack enables the fabrication of the non-recessed normally off metal–insulator–semiconductor-HEMT with enhanced threshold voltage (Vth) stability.