Klaudia Całus-Makowska
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Klaudia Całus-Makowska has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
- Anna Grobelak
Faculty of Infrastructure and Environment, Czestochowa University of Technology, 42-201 Czestochowa, Poland
6 shared publications Anna Grobelak
3 shared publicationsAnna Grosser
3 shared publications- Aneta Kowalska
Department of Science and Technology, Jan Dlugosz University in Czestochowa
2 shared publications - Daria Sławczyk
Faculty of Infrastructure and Environment, Czestochowa University of Technology, 42-201 Czestochowa, Poland
2 shared publications - Abhilasha Shourie
Manav Rachna International Institute of Research and Studies
1 shared publication
Latest Publications
- Open Access
Digestate Recirculation in Agricultural Biogas Plants: Effects on Process Stability, Methane Production, Water Demand, and Inhibitor Accumulation
Digestate recirculation is increasingly considered a strategy for improving resource efficiency in agricultural biogas plants by reducing process-water demand, retaining active biomass, and enhancing the internal reuse of nutrients and residual organic matter. This review critically examines the effects of digestate recirculation on anaerobic digestion stability, methane production, water balance, inhibitor accumulation, and microbial community dynamics. Previous reviews have largely addressed digestate management, nutrient recovery, fertilizer use, and broader anaerobic digestion optimization, while digestate recirculation itself has received less attention as an operational process-management strategy in agricultural biogas plants. This review addresses this gap by integrating technological, physicochemical, microbiological, and operational evidence and by emphasizing that the effects of recirculation are system-specific rather than governed by a single universal optimum recirculation ratio. Particular attention is given to the influence of recirculation ratio, digestate fraction, solids content, reactor configuration, and feedstock characteristics. Available studies show that recirculation can increase volumetric methane production, support buffering capacity, improve microbial retention, and reduce the need for external dilution water. However, the response is generally non-linear, and excessive recirculation may promote the accumulation of total ammonia nitrogen, volatile fatty acids, soluble salts, sulphides, recalcitrant compounds, and suspended solids. These changes can increase viscosity, impair mass transfer and mixing, and shift methanogenic pathways toward more stress-tolerant microbial consortia. Effective implementation requires integrated control of chemical, physical, and microbiological parameters. Digestate recirculation should therefore be treated as a flexible process-management tool whose benefits depend on system-specific operating conditions and long-term mass-balance control. Future research should define robust monitoring indicators for full-scale operation.
Open AccessDigestate Recirculation in Agricultural Biogas Plants: Effects on Process Stability, Methane Production, Water Demand, and Inhibitor Accumulation
Digestate recirculation is increasingly considered a strategy for improving resource efficiency in agricultural biogas plants by reducing process-water demand, retaining active biomass, and enhancing the internal reuse of nutrients and residual organic matter. This review critically examines the effects of digestate recirculation on anaerobic digestion stability, methane production, water balance, inhibitor accumulation, and microbial community dynamics. Previous reviews have largely addressed digestate management, nutrient recovery, fertilizer use, and broader anaerobic digestion optimization, while digestate recirculation itself has received less attention as an operational process-management strategy in agricultural biogas plants. This review addresses this gap by integrating technological, physicochemical, microbiological, and operational evidence and by emphasizing that the effects of recirculation are system-specific rather than governed by a single universal optimum recirculation ratio. Particular attention is given to the influence of recirculation ratio, digestate fraction, solids content, reactor configuration, and feedstock characteristics. Available studies show that recirculation can increase volumetric methane production, support buffering capacity, improve microbial retention, and reduce the need for external dilution water. However, the response is generally non-linear, and excessive recirculation may promote the accumulation of total ammonia nitrogen, volatile fatty acids, soluble salts, sulphides, recalcitrant compounds, and suspended solids. These changes can increase viscosity, impair mass transfer and mixing, and shift methanogenic pathways toward more stress-tolerant microbial consortia. Effective implementation requires integrated control of chemical, physical, and microbiological parameters. Digestate recirculation should therefore be treated as a flexible process-management tool whose benefits depend on system-specific operating conditions and long-term mass-balance control. Future research should define robust monitoring indicators for full-scale operation.
- 31 July 2026
- Published by Elsevier
- p. 719-737
Strategies for the removal of emerging nanoparticles from contaminated environments
- 31 July 2026
- Published by Elsevier
- p. 719-737
Strategies for the removal of emerging nanoparticles from contaminated environments
- Open Access
Enhanced Photocatalytic Removal of Selected Pharmaceuticals from MBR-Treated Wastewater Using a g-C3N4/rGO Nanocomposite Under UV Irradiation
The presence of pharmaceuticals in treated wastewater has become an environmental concern due to their persistence, biological activity, and incomplete removal in conventional wastewater treatment systems. In this study, a g-C3N4/rGO nanocomposite was synthesized via thermal polycondensation of melamine in the presence of reduced graphene oxide and evaluated as a photocatalyst for the degradation of selected pharmaceuticals in membrane bioreactor (MBR)-treated wastewater. The obtained materials were characterized using Fourier-transform infrared spectroscopy (FTIR–ATR), X-ray diffraction (XRD), nitrogen adsorption–desorption measurements (BET), Raman spectroscopy, scanning electron microscopy (SEM), and UV–Vis spectroscopy to evaluate their chemical structure, crystallinity, textural properties, morphology, and optical characteristics. Photocatalytic experiments were performed under UV irradiation using real wastewater spiked with carbamazepine, diclofenac, ibuprofen, and sulfamethoxazole at an initial concentration of 50 mg/L, selected to ensure reliable quantification under laboratory conditions. The complete removal of diclofenac and sulfamethoxazole was achieved within 30 min of treatment, while the presence of the nanocomposite enhanced the degradation efficiency of ibuprofen and carbamazepine by approximately 19% and 13%, respectively, compared to UV irradiation alone. The obtained results demonstrate the applicability of the investigated g-C3N4/rGO system for pharmaceutical degradation in real wastewater matrices and indicate its potential as a preliminary photocatalytic post-treatment approach.
Open AccessEnhanced Photocatalytic Removal of Selected Pharmaceuticals from MBR-Treated Wastewater Using a g-C3N4/rGO Nanocomposite Under UV Irradiation
The presence of pharmaceuticals in treated wastewater has become an environmental concern due to their persistence, biological activity, and incomplete removal in conventional wastewater treatment systems. In this study, a g-C3N4/rGO nanocomposite was synthesized via thermal polycondensation of melamine in the presence of reduced graphene oxide and evaluated as a photocatalyst for the degradation of selected pharmaceuticals in membrane bioreactor (MBR)-treated wastewater. The obtained materials were characterized using Fourier-transform infrared spectroscopy (FTIR–ATR), X-ray diffraction (XRD), nitrogen adsorption–desorption measurements (BET), Raman spectroscopy, scanning electron microscopy (SEM), and UV–Vis spectroscopy to evaluate their chemical structure, crystallinity, textural properties, morphology, and optical characteristics. Photocatalytic experiments were performed under UV irradiation using real wastewater spiked with carbamazepine, diclofenac, ibuprofen, and sulfamethoxazole at an initial concentration of 50 mg/L, selected to ensure reliable quantification under laboratory conditions. The complete removal of diclofenac and sulfamethoxazole was achieved within 30 min of treatment, while the presence of the nanocomposite enhanced the degradation efficiency of ibuprofen and carbamazepine by approximately 19% and 13%, respectively, compared to UV irradiation alone. The obtained results demonstrate the applicability of the investigated g-C3N4/rGO system for pharmaceutical degradation in real wastewater matrices and indicate its potential as a preliminary photocatalytic post-treatment approach.
- Open Access
Photo-Ozonation of Multiclass Pharmaceuticals in Model Water: Kinetic Comparison of UV-C, O3 and UV/O3 Under Selected pH Conditions
The removal of four representative pharmaceuticals—sulfamethoxazole (SMX), carbamazepine (CBZ), diclofenac (DCF) and ibuprofen (IBU)—was investigated in a model aqueous solution using UV-C photolysis, ozonation and a hybrid UV/O3 process. UV-C and UV/O3 experiments were conducted at initial pH 3, ~6 and 8, whereas single ozonation was applied at pH ~6 as a near-neutral reference. The processes were compared in terms of removal efficiency, apparent pseudo-first-order kinetics and kinetic enhancement. UV-C photolysis showed pronounced compound selectivity, with efficient removal of DCF and SMX but limited transformation of CBZ and IBU. Ozonation markedly improved the removal of ozone-reactive compounds, particularly CBZ and DCF. Under near-neutral conditions, UV/O3 provided high removal efficiencies for all target compounds after 30 min. Kinetic analysis showed that UV/O3 enhancement was compound-specific: apparent synergy was observed for CBZ and IBU, with SF values of 1.43 and 1.24, respectively, whereas SMX showed a subadditive response. DCF was rapidly removed under UV/O3 but was excluded from the main SF comparison because its concentration approached the lowest calibrated concentration level. These results indicate that UV/O3 is especially useful for poorly UV-susceptible pharmaceuticals.
Open AccessPhoto-Ozonation of Multiclass Pharmaceuticals in Model Water: Kinetic Comparison of UV-C, O3 and UV/O3 Under Selected pH Conditions
The removal of four representative pharmaceuticals—sulfamethoxazole (SMX), carbamazepine (CBZ), diclofenac (DCF) and ibuprofen (IBU)—was investigated in a model aqueous solution using UV-C photolysis, ozonation and a hybrid UV/O3 process. UV-C and UV/O3 experiments were conducted at initial pH 3, ~6 and 8, whereas single ozonation was applied at pH ~6 as a near-neutral reference. The processes were compared in terms of removal efficiency, apparent pseudo-first-order kinetics and kinetic enhancement. UV-C photolysis showed pronounced compound selectivity, with efficient removal of DCF and SMX but limited transformation of CBZ and IBU. Ozonation markedly improved the removal of ozone-reactive compounds, particularly CBZ and DCF. Under near-neutral conditions, UV/O3 provided high removal efficiencies for all target compounds after 30 min. Kinetic analysis showed that UV/O3 enhancement was compound-specific: apparent synergy was observed for CBZ and IBU, with SF values of 1.43 and 1.24, respectively, whereas SMX showed a subadditive response. DCF was rapidly removed under UV/O3 but was excluded from the main SF comparison because its concentration approached the lowest calibrated concentration level. These results indicate that UV/O3 is especially useful for poorly UV-susceptible pharmaceuticals.
- 4 October 2025
- Published by Elsevier in Journal of Environmental Management
- Vol. 394, 127480
Pharmaceutical residues in wastewater treatment plants in Poland: Removal efficiency and risk assessment
- 4 October 2025
- Published by Elsevier in Journal of Environmental Management
- Vol. 394, 127480
Pharmaceutical residues in wastewater treatment plants in Poland: Removal efficiency and risk assessment
- Open Access
- 10 December 2024
- Published by Elsevier in Desalination and Water Treatment
- Vol. 321
Application of the Fenton and photo-Fenton processes in pharmaceutical removal: New perspectives in environmental protection
- 10 December 2024
- Published by Elsevier in Desalination and Water Treatment
- Vol. 321
Open AccessApplication of the Fenton and photo-Fenton processes in pharmaceutical removal: New perspectives in environmental protection
- Open Access
Environmental Impacts and Contaminants Management in Sewage Sludge-to-Energy and Fertilizer Technologies: Current Trends and Future Directions
The increasing focus on sustainability and the circular economy has brought waste-to-energy technologies to the forefront of renewable energy research. However, the environmental impacts and management of contaminants associated with these technologies remain critical issues. This article comprehensively reviews the environmental impacts of converting sewage sludge into energy and fertilizers, focusing on managing potential contaminants and assessing the implications and ecological risks. It also highlights the latest trends in waste-to-energy technologies, waste-to-soil amendment, and their integration into circular economy frameworks. The discussion encompasses challenges and opportunities in optimizing these processes in wastewater treatment plants to minimize pollutants and enhance sustainability. Addressing these challenges is essential for ensuring the long-term viability and acceptance of waste-to-energy solutions, making this topic highly relevant and timely.
Open AccessEnvironmental Impacts and Contaminants Management in Sewage Sludge-to-Energy and Fertilizer Technologies: Current Trends and Future Directions
The increasing focus on sustainability and the circular economy has brought waste-to-energy technologies to the forefront of renewable energy research. However, the environmental impacts and management of contaminants associated with these technologies remain critical issues. This article comprehensively reviews the environmental impacts of converting sewage sludge into energy and fertilizers, focusing on managing potential contaminants and assessing the implications and ecological risks. It also highlights the latest trends in waste-to-energy technologies, waste-to-soil amendment, and their integration into circular economy frameworks. The discussion encompasses challenges and opportunities in optimizing these processes in wastewater treatment plants to minimize pollutants and enhance sustainability. Addressing these challenges is essential for ensuring the long-term viability and acceptance of waste-to-energy solutions, making this topic highly relevant and timely.
- Open Access
- 16 December 2023
- Published by Elsevier in Desalination and Water Treatment
- Vol. 305, 129-154
Pharmaceutical contamination in wastewater treatment plants: occurrence, challenges in detection and insights on high-performance liquid chromatography as an effective analytical tool in environmental matrices — a review
- 16 December 2023
- Published by Elsevier in Desalination and Water Treatment
- Vol. 305, 129-154
Open AccessPharmaceutical contamination in wastewater treatment plants: occurrence, challenges in detection and insights on high-performance liquid chromatography as an effective analytical tool in environmental matrices — a review