HMHilda Ayu Marlina
Hilda Ayu Marlina
*This is an algorithmically generated author record based on publicly available information.
Research Subjects
Hilda Ayu Marlina has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
Agung Imaduddin
1 shared publication- Ali Hasimi Pane1 shared publication
An The Pham
1 shared publicationDuc H. Tran
1 shared publicationHendrik
1 shared publication- Intan Zahar
Universitas Asahan
1 shared publication
Latest Publications
- Open Access
- 1 April 2025
- Published by Wydawnictwo Naukowe Gabriel Borowski (WNGB) in Journal of Ecological Engineering
- Vol. 26 (4) , 59-70
Physical, mechanical and thermal properties of composite board based on palm frond fibers and feather clam shells
Research on natural composite boards with polyester has been completed. In this study, composite boards were fabricated using palm frond fiber (PFF) and feather clam shell (FCS) combined with polyester. The mass ratios (%) of PFF:FCS:polyester investigated were 55:20:25, 45:30:25, 35:40:25,...
- 1 April 2025
- Published by Wydawnictwo Naukowe Gabriel Borowski (WNGB) in Journal of Ecological Engineering
- Vol. 26 (4) , 59-70
Open AccessPhysical, mechanical and thermal properties of composite board based on palm frond fibers and feather clam shells
Research on natural composite boards with polyester has been completed. In this study, composite boards were fabricated using palm frond fiber (PFF) and feather clam shell (FCS) combined with polyester. The mass ratios (%) of PFF:FCS:polyester investigated were 55:20:25, 45:30:25, 35:40:25,...
- Open Access
- 3 October 2024
- Published by Elsevier in Case Studies in Chemical and Environmental Engineering
- Vol. 10
A comprehensive analysis of MgB2 superconducting wire development: The effect of initial filling density and thermomechanical treatment
- 3 October 2024
- Published by Elsevier in Case Studies in Chemical and Environmental Engineering
- Vol. 10
Open AccessA comprehensive analysis of MgB2 superconducting wire development: The effect of initial filling density and thermomechanical treatment