Denis S. Lutsenko
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Denis S. Lutsenko has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Evgeny V. Antipov
Department of Chemistry, Lomonosov Moscow State University, 119991 Moscow, Russian Federation
3 shared publications - Oleg A. Drozhzhin
Department of Chemistry, Lomonosov Moscow State University, 119991 Moscow, Russian Federation
3 shared publications - Denis Shpalter
Department of Chemical and Structural Biology Weizmann Institute of Science Rehovot Israel
2 shared publications Grigorii P. Lakienko
2 shared publications- Zoya V. Bobyleva
Department of Chemistry, Lomonosov Moscow State University, 119991 Moscow, Russian Federation
2 shared publications Alina R. Safiullina
1 shared publication
Latest Publications
- 17 December 2025
- Published by Elsevier in Electrochimica Acta
- Vol. 549
Insertion, nucleation, deposition: mechanistic insight into sodium-ion/metal storage on hard carbon in anode-less sodium batteries
- 17 December 2025
- Published by Elsevier in Electrochimica Acta
- Vol. 549
Insertion, nucleation, deposition: mechanistic insight into sodium-ion/metal storage on hard carbon in anode-less sodium batteries
- 1 November 2025
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 172 (11) , 110543
Impact of the Cyclic-to-Linear Carbonate Ratio in EC-DEC-DMC Electrolytes on the Low-Temperature Performance of Sodium-Ion Batteries Comprising Metallic Sodium and Intercalation-Type Electrodes
The low-temperature properties of sodium-ion electrolytes based on 1 M NaPF 6 solutions in EC-DEC-DMC (2:1:1 and 1:1:1 by volume) were studied. The data on phase transitions obtained from visual experiments and DSC studies were compared with the results of electrochemical experiments using steel (St), metallic sodium (Na), and NASICON-type active materials (NVP, NTP) electrodes. The specific conductivity of the “2:1:1” electrolyte, although initially slightly higher than that of the “1:1:1,” decreases sharply upon cooling and at −40 °C is ≈0.5 mS cm −1 vs ≈1.5 mS cm −1 for the “1:1:1.” However, the capacities of NVP-Na half-cells in both electrolytes are almost identical down to −40 °C. Studies of symmetrical cells showed that the main contributor to polarization loss is the sodium-electrolyte interface. Both electrolytes behave similarly with respect to metallic sodium. However, in the case of NVP-NVP cells, the charge transfer resistance in case of “1:1:1” electrolyte was lower on cooling than for the “2:1:1.” NVP-NTP full cells additionally demonstrated an advantage of the “1:1:1” system compared to “2:1:1” at low temperatures. At −40 °С, the cell with “1:1:1” electrolyte demonstrated retention of 75% of the room-temperature capacity, while in the case of “2:1:1” this value was slightly more than 50%.
- 1 November 2025
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 172 (11) , 110543
Impact of the Cyclic-to-Linear Carbonate Ratio in EC-DEC-DMC Electrolytes on the Low-Temperature Performance of Sodium-Ion Batteries Comprising Metallic Sodium and Intercalation-Type Electrodes
The low-temperature properties of sodium-ion electrolytes based on 1 M NaPF 6 solutions in EC-DEC-DMC (2:1:1 and 1:1:1 by volume) were studied. The data on phase transitions obtained from visual experiments and DSC studies were compared with the results of electrochemical experiments using steel (St), metallic sodium (Na), and NASICON-type active materials (NVP, NTP) electrodes. The specific conductivity of the “2:1:1” electrolyte, although initially slightly higher than that of the “1:1:1,” decreases sharply upon cooling and at −40 °C is ≈0.5 mS cm −1 vs ≈1.5 mS cm −1 for the “1:1:1.” However, the capacities of NVP-Na half-cells in both electrolytes are almost identical down to −40 °C. Studies of symmetrical cells showed that the main contributor to polarization loss is the sodium-electrolyte interface. Both electrolytes behave similarly with respect to metallic sodium. However, in the case of NVP-NVP cells, the charge transfer resistance in case of “1:1:1” electrolyte was lower on cooling than for the “2:1:1.” NVP-NTP full cells additionally demonstrated an advantage of the “1:1:1” system compared to “2:1:1” at low temperatures. At −40 °С, the cell with “1:1:1” electrolyte demonstrated retention of 75% of the room-temperature capacity, while in the case of “2:1:1” this value was slightly more than 50%.
- 7 October 2024
- Published by Elsevier in Journal of Power Sources
- Vol. 624
Hard carbon anode materials for hybrid sodium-ion/metal batteries with high energy density
- 7 October 2024
- Published by Elsevier in Journal of Power Sources
- Vol. 624
Hard carbon anode materials for hybrid sodium-ion/metal batteries with high energy density