Mohammad Hamidizirasefi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Mohammad Hamidizirasefi has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
Audrey M. Battiste
The Pennsylvania State University
3 shared publications- Bert D. Chandler
The Pennsylvania State University
3 shared publications Angela Pathickal Abraham
The Pennsylvania State University
2 shared publicationsKelle D. Hart
The Pennsylvania State University
2 shared publicationsTae Yong Yun
The Pennsylvania State University
2 shared publications- Andersen P. Dimon
The Pennsylvania State University
1 shared publication
Latest Publications
- Open Access
- 31 August 2026
- Published by American Chemical Society (ACS) in JACS Au
- Vol. 6 (9) , 5179-5189
Hydrogen Spillover from Pt, Pd, and Au Evaluated with MnO x Temperature-Programmed Reduction
Hydrogen spillover occurs when H2 adsorbs on an active metal and is then transferred to a reducible metal oxide. While spillover is involved in many catalytic reactions, fundamental studies of spillover have been limited by the paucity of experimental methods available to study it. Here, we develop an experimental temperature-programmed reduction (TPR) protocol to rapidly compare spillover from different metals (Pt, Pd, Au ) onto P25 titania, using MnOx reduction probe reaction. X-ray photoelectron and UV–visible spectroscopies indicated reduction to MnO in the presence and absence of active metals, and quantitative H2 consumption measurements were consistent across all samples. Observed MnOx reduction temperatures, which decrease by shifting as much as 150 °C, depend strongly on the metal loading and confirm H2 activation occurs at metal sites. Adding only 300 ppm Au caused the Kissinger apparent activation energy to decrease from 55 to <10 kJ/mol. Comparisons across metals and loadings indicate that MnOx reduction is limited by H2 activation only at very low metal loadings and temperatures. Gold induces the largest shift in MnOx reduction, indicating that it is the most competent spillover metal under these conditions. At moderately higher loadings (≥1 site/100 nm2), Pt and Au become equivalent, signaling that MnOx reduction is no longer limited by H2 activation at higher metal loadings. Palladium is moderately slower, consistent with the generation of a PdHx phase at low temperature. At higher active site loadings, MnOx reduction depends primarily on the surface concentration of spillover H, providing a simple and useful approach for comparing catalysts.
- 31 August 2026
- Published by American Chemical Society (ACS) in JACS Au
- Vol. 6 (9) , 5179-5189
Open AccessHydrogen Spillover from Pt, Pd, and Au Evaluated with MnO x Temperature-Programmed Reduction
Hydrogen spillover occurs when H2 adsorbs on an active metal and is then transferred to a reducible metal oxide. While spillover is involved in many catalytic reactions, fundamental studies of spillover have been limited by the paucity of experimental methods available to study it. Here, we develop an experimental temperature-programmed reduction (TPR) protocol to rapidly compare spillover from different metals (Pt, Pd, Au ) onto P25 titania, using MnOx reduction probe reaction. X-ray photoelectron and UV–visible spectroscopies indicated reduction to MnO in the presence and absence of active metals, and quantitative H2 consumption measurements were consistent across all samples. Observed MnOx reduction temperatures, which decrease by shifting as much as 150 °C, depend strongly on the metal loading and confirm H2 activation occurs at metal sites. Adding only 300 ppm Au caused the Kissinger apparent activation energy to decrease from 55 to <10 kJ/mol. Comparisons across metals and loadings indicate that MnOx reduction is limited by H2 activation only at very low metal loadings and temperatures. Gold induces the largest shift in MnOx reduction, indicating that it is the most competent spillover metal under these conditions. At moderately higher loadings (≥1 site/100 nm2), Pt and Au become equivalent, signaling that MnOx reduction is no longer limited by H2 activation at higher metal loadings. Palladium is moderately slower, consistent with the generation of a PdHx phase at low temperature. At higher active site loadings, MnOx reduction depends primarily on the surface concentration of spillover H, providing a simple and useful approach for comparing catalysts.
- Open Access
- 4 August 2026
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 148 (32) , 34550-34559
A Quantitative Examination of Catalyst Component Impacts on Hydrogen Adsorption and Spillover
Hydrogen spillover is a widely recognized but poorly understood surface phenomenon. We coupled volumetric chemisorption with Fourier transform infrared spectroscopy, thermogravimetric analysis, and acid–base titrations to quantify the roles of metal (Pt, Au) and support chemistry (anatase, rutile, P25 titania) on spillover. We show that metal identity has little to no impact on the amount of spillover hydrogen. Spillover pressure dependence is essentially the same on Au/TiO2 and Pt/TiO2, indicating H2 adsorption is equilibrated across both the metal and support. Conversely, spillover is highly sensitive to support surface chemistry, as rutile TiO2 stabilizes ∼5× more surface hydrogen than anatase TiO2. This change is due to a combination of factors, including the rutile surface’s higher proton affinity, stabilized surface electronic states, and larger surface entropy. This work highlights the utility of Au/MOx catalysts as control materials for spillover, as they enable quantitative evaluation of H2 adsorption on active metals and spillover onto the support.
- 4 August 2026
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 148 (32) , 34550-34559
Open AccessA Quantitative Examination of Catalyst Component Impacts on Hydrogen Adsorption and Spillover
Hydrogen spillover is a widely recognized but poorly understood surface phenomenon. We coupled volumetric chemisorption with Fourier transform infrared spectroscopy, thermogravimetric analysis, and acid–base titrations to quantify the roles of metal (Pt, Au) and support chemistry (anatase, rutile, P25 titania) on spillover. We show that metal identity has little to no impact on the amount of spillover hydrogen. Spillover pressure dependence is essentially the same on Au/TiO2 and Pt/TiO2, indicating H2 adsorption is equilibrated across both the metal and support. Conversely, spillover is highly sensitive to support surface chemistry, as rutile TiO2 stabilizes ∼5× more surface hydrogen than anatase TiO2. This change is due to a combination of factors, including the rutile surface’s higher proton affinity, stabilized surface electronic states, and larger surface entropy. This work highlights the utility of Au/MOx catalysts as control materials for spillover, as they enable quantitative evaluation of H2 adsorption on active metals and spillover onto the support.
- 24 October 2024
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 146 (44) , 30091-30103
Upside-Down Adsorption: The Counterintuitive Influences of Surface Entropy and Surface Hydroxyl Density on Hydrogen Spillover
Although hydrogen spillover is often invoked to explain anomalies in catalysis, spillover remains a poorly understood phenomenon. Hydrogen spillover (H*) is best described as highly mobile H atom equivalents that arise when H2 migrates from a metal nanoparticle to an oxide or carbon support. In the 60 years since its discovery, few methods have become available to quantify or characterize H*-support interactions. We recently showed in situ infrared spectroscopy and volumetric chemisorption can quantify reversible H2 adsorption on Au/TiO2 catalysts, where adsorbed hydrogen exists as H* and interacts with titania surface hydroxyl (TiOH) groups. Here, we report parallel thermogravimetric analysis and Fourier transform infrared spectroscopy methods for systematically manipulating the surface TiOH density. We examine the role of surface hydroxylation on spillover thermodynamics using van't Hoff studies to determine apparent adsorption enthalpies and entropies at constant H* coverage, which is necessary to maintain constant H* translational entropy. Although surface TiOH groups are the likely adsorption sites, the data show removing hydroxyl groups increases spillover. This surprising finding─that adsorption increases as the adsorption site density decreases─is associated with improved thermodynamics on dehydroxylated surfaces. A strong adsorption enthalpy-entropy correlation implicates the changing surface entropy of the titania support itself (i.e., an initial state effect) is deeply intertwined with the H* configurational entropy. These effects are surprising and should apply to all low-coverage adsorbates where entropy terms dominate more traditional enthalpic considerations. Moreover, this study points toward a kinetic test for invoking spillover in a reaction mechanism: namely, in situ dehydroxylation should enhance spillover processes.
- 24 October 2024
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 146 (44) , 30091-30103
Upside-Down Adsorption: The Counterintuitive Influences of Surface Entropy and Surface Hydroxyl Density on Hydrogen Spillover
Although hydrogen spillover is often invoked to explain anomalies in catalysis, spillover remains a poorly understood phenomenon. Hydrogen spillover (H*) is best described as highly mobile H atom equivalents that arise when H2 migrates from a metal nanoparticle to an oxide or carbon support. In the 60 years since its discovery, few methods have become available to quantify or characterize H*-support interactions. We recently showed in situ infrared spectroscopy and volumetric chemisorption can quantify reversible H2 adsorption on Au/TiO2 catalysts, where adsorbed hydrogen exists as H* and interacts with titania surface hydroxyl (TiOH) groups. Here, we report parallel thermogravimetric analysis and Fourier transform infrared spectroscopy methods for systematically manipulating the surface TiOH density. We examine the role of surface hydroxylation on spillover thermodynamics using van't Hoff studies to determine apparent adsorption enthalpies and entropies at constant H* coverage, which is necessary to maintain constant H* translational entropy. Although surface TiOH groups are the likely adsorption sites, the data show removing hydroxyl groups increases spillover. This surprising finding─that adsorption increases as the adsorption site density decreases─is associated with improved thermodynamics on dehydroxylated surfaces. A strong adsorption enthalpy-entropy correlation implicates the changing surface entropy of the titania support itself (i.e., an initial state effect) is deeply intertwined with the H* configurational entropy. These effects are surprising and should apply to all low-coverage adsorbates where entropy terms dominate more traditional enthalpic considerations. Moreover, this study points toward a kinetic test for invoking spillover in a reaction mechanism: namely, in situ dehydroxylation should enhance spillover processes.