David Plaza Arguello
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
David Plaza Arguello has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Hala El Rammouz
CEA Leti, Univ. Grenoble Alpes , F 38000 Grenoble
5 shared publications - Julien Buckley
CEA Leti, Univ. Grenoble Alpes , F 38000 Grenoble
5 shared publications - Matthew Charles
CEA Leti, Univ. Grenoble Alpes , F 38000 Grenoble
5 shared publications - Mohammed El Amrani
CEA Leti, Univ. Grenoble Alpes , F 38000 Grenoble
5 shared publications - Thomas Kaltsounis
CEA Leti, Univ. Grenoble Alpes , F 38000 Grenoble
5 shared publications Matthieu Lafossas
CEA Leti, Univ. Grenoble Alpes , F 38000 Grenoble
3 shared publications
Latest Publications
- 8 September 2026
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 140 (10)
Effects of oxygen plasma and hydrochloric acid surface preparation on contact formation for pseudo-vertical GaN-on-Si Schottky diodes grown by localized epitaxy
The influence of surface preparation on the metal–semiconductor interface of pseudo-vertical GaN-on-Si Schottky diodes fabricated by selective-area growth on 200 mm silicon wafers is investigated. Devices were subjected to four surface conditions prior to anode metallization: no treatment, O2 plasma, HCl etching, and O2 plasma followed by HCl treatment. Electrical measurements show that HCl treatment yields the most favorable Schottky behavior, with a higher turn-on voltage (1.0 V) and a lower ideality factor (n ≈ 1), while O2 plasma degrades device performance (VTH = 0.2 and n ≈ 1.9). The combined treatment results in the poorest Schottky characteristics despite a thinner oxide layer than with plasma alone (VTH = 0.1 and n ≈ 2.2). X-ray photoelectron spectroscopy performed before and after Ni deposition reveals that these trends correlate with changes in interfacial oxide chemistry, including effective removal of GaOx by HCl, enhanced oxidation following O2 plasma exposure, and increased disorder in the top layers due to the plasma energy. When applied prior to cathode deposition, the combined treatment of O2 plasma and HCl increases forward current density by a factor of 6 without affecting the forward-bias characteristics, underscoring the interface-specific role of surface preparation. These results highlight the need for tailored surface treatments to optimize the performance of both contacts in GaN Schottky diodes.
- 8 September 2026
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 140 (10)
Effects of oxygen plasma and hydrochloric acid surface preparation on contact formation for pseudo-vertical GaN-on-Si Schottky diodes grown by localized epitaxy
The influence of surface preparation on the metal–semiconductor interface of pseudo-vertical GaN-on-Si Schottky diodes fabricated by selective-area growth on 200 mm silicon wafers is investigated. Devices were subjected to four surface conditions prior to anode metallization: no treatment, O2 plasma, HCl etching, and O2 plasma followed by HCl treatment. Electrical measurements show that HCl treatment yields the most favorable Schottky behavior, with a higher turn-on voltage (1.0 V) and a lower ideality factor (n ≈ 1), while O2 plasma degrades device performance (VTH = 0.2 and n ≈ 1.9). The combined treatment results in the poorest Schottky characteristics despite a thinner oxide layer than with plasma alone (VTH = 0.1 and n ≈ 2.2). X-ray photoelectron spectroscopy performed before and after Ni deposition reveals that these trends correlate with changes in interfacial oxide chemistry, including effective removal of GaOx by HCl, enhanced oxidation following O2 plasma exposure, and increased disorder in the top layers due to the plasma energy. When applied prior to cathode deposition, the combined treatment of O2 plasma and HCl increases forward current density by a factor of 6 without affecting the forward-bias characteristics, underscoring the interface-specific role of surface preparation. These results highlight the need for tailored surface treatments to optimize the performance of both contacts in GaN Schottky diodes.
- 17 August 2026
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 140 (7)
Impact of strain-induced cracking on the electrical performance of pseudo-vertical GaN-on-Si p–n diodes grown by selective area epitaxy
Selective-area growth (SAG) of gallium nitride (GaN)-on-silicon enables the growth of thick layers by elastically relaxing tensile stress during cooldown. However, the effects of strain-induced mechanical degradation on the performance of SAG-grown vertical devices remain poorly understood. In this work, pseudo-vertical GaN-on-Si p–n diodes were made by SAG on 200 mm Si (111) wafers to study how mesa geometry and drift-layer thickness affect performance. Devices with 9 μm-thick drift layers showed a strong dependence of specific on-resistance (Ron,sp) on mesa diameter, with 100 μm mesas showing lower Ron,sp than 200 μm ones. Structural analysis revealed greater degradation in mesa performance due to strain-induced cracking and delamination at the mesa base, disrupting conduction between the anode and the n+-GaN layer. Reducing the drift-layer thickness to 4 μm suppressed cracks and improved Ron,sp consistency. Devices without a p-GaN layer had even lower Ron,sp, indicating that the p-GaN layer and contact dominate resistance once cracks are mitigated. These findings highlight mechanical integrity as a key factor in the performance and uniformity of SAG-grown pseudo-vertical GaN-on-Si power devices.
- 17 August 2026
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 140 (7)
Impact of strain-induced cracking on the electrical performance of pseudo-vertical GaN-on-Si p–n diodes grown by selective area epitaxy
Selective-area growth (SAG) of gallium nitride (GaN)-on-silicon enables the growth of thick layers by elastically relaxing tensile stress during cooldown. However, the effects of strain-induced mechanical degradation on the performance of SAG-grown vertical devices remain poorly understood. In this work, pseudo-vertical GaN-on-Si p–n diodes were made by SAG on 200 mm Si (111) wafers to study how mesa geometry and drift-layer thickness affect performance. Devices with 9 μm-thick drift layers showed a strong dependence of specific on-resistance (Ron,sp) on mesa diameter, with 100 μm mesas showing lower Ron,sp than 200 μm ones. Structural analysis revealed greater degradation in mesa performance due to strain-induced cracking and delamination at the mesa base, disrupting conduction between the anode and the n+-GaN layer. Reducing the drift-layer thickness to 4 μm suppressed cracks and improved Ron,sp consistency. Devices without a p-GaN layer had even lower Ron,sp, indicating that the p-GaN layer and contact dominate resistance once cracks are mitigated. These findings highlight mechanical integrity as a key factor in the performance and uniformity of SAG-grown pseudo-vertical GaN-on-Si power devices.
- Open Access
- 8 April 2026
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 139 (14)
Impact of geometric parameters on the electrical performances of pseudo-vertical GaN-on-Si p–n diodes with avalanche capability via selective epitaxy
In this study, we present a GaN-on-Si pseudo-vertical p–n diode fabricated using selective area growth (SAG). The device achieved a high current density of 1.5 kA cm−2 and a low specific on-resistance (Ron,sp) of 3.3 mΩ cm2. A very high on/off current ratio (Ion/Ioff) of 1012 was also recorded. Notably, for the first-time using SAG, uniform avalanche breakdown behavior of 850 V was demonstrated through temperature-dependent reverse bias measurements, corresponding to a Baliga figure of merit of 0.2 GW cm−2. These results emphasize the advantages of localized epitaxy in achieving high-quality p–n junctions on Si substrates, paving the way for scalable, high-performance GaN power devices monolithically integrated with Si technology. To evaluate the influence of geometric parameters on epitaxial quality and device performance, the mesa spacing was systematically varied while keeping the diameter fixed. Optimal results were obtained with 5–15 μm spacing, offering the best trade-off between forward conduction efficiency and reverse blocking robustness. This comprehensive investigation underscores the importance of geometric optimization and localized epitaxy in advancing high-performance GaN-on-Si p–n diodes for next-generation power applications.
- 8 April 2026
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 139 (14)
Open AccessImpact of geometric parameters on the electrical performances of pseudo-vertical GaN-on-Si p–n diodes with avalanche capability via selective epitaxy
In this study, we present a GaN-on-Si pseudo-vertical p–n diode fabricated using selective area growth (SAG). The device achieved a high current density of 1.5 kA cm−2 and a low specific on-resistance (Ron,sp) of 3.3 mΩ cm2. A very high on/off current ratio (Ion/Ioff) of 1012 was also recorded. Notably, for the first-time using SAG, uniform avalanche breakdown behavior of 850 V was demonstrated through temperature-dependent reverse bias measurements, corresponding to a Baliga figure of merit of 0.2 GW cm−2. These results emphasize the advantages of localized epitaxy in achieving high-quality p–n junctions on Si substrates, paving the way for scalable, high-performance GaN power devices monolithically integrated with Si technology. To evaluate the influence of geometric parameters on epitaxial quality and device performance, the mesa spacing was systematically varied while keeping the diameter fixed. Optimal results were obtained with 5–15 μm spacing, offering the best trade-off between forward conduction efficiency and reverse blocking robustness. This comprehensive investigation underscores the importance of geometric optimization and localized epitaxy in advancing high-performance GaN-on-Si p–n diodes for next-generation power applications.
- Open Access
- 1 December 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 138 (21)
720 V quasi-vertical GaN-on-silicon p–n diodes with surge capability fabricated using selective area growth
This work demonstrates, for the first time, avalanche breakdown capability in quasi-vertical gallium nitride (GaN) on silicon (Si) substrates employing localized epitaxial growth. On industry-standard 200 mm wafers, we integrated an 8 μm thick GaN drift layer onto Si, enabling the fabrication of 720 V quasi-vertical p–n diodes. This method yields high-performance power devices in CMOS-compatible cleanrooms at a reduced cost. The GaN p–n junctions exhibit a specific on-resistance of 3.3 mΩ cm2, a current on/off ratio exceeding 1010, and a current density of 1.4 kA/cm2 at 10 V. Robust avalanche behavior was confirmed through temperature-dependent reverse bias measurements from 298 to 373 K, and over 3000 over-voltage surge ruggedness was demonstrated by unclamped inductive switching stress tests. These results underscore the advantages of localized epitaxy for achieving high-quality GaN layers on Si, paving the way for scalable integration of high-voltage GaN power devices with conventional Si technology.
- 1 December 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 138 (21)
Open Access720 V quasi-vertical GaN-on-silicon p–n diodes with surge capability fabricated using selective area growth
This work demonstrates, for the first time, avalanche breakdown capability in quasi-vertical gallium nitride (GaN) on silicon (Si) substrates employing localized epitaxial growth. On industry-standard 200 mm wafers, we integrated an 8 μm thick GaN drift layer onto Si, enabling the fabrication of 720 V quasi-vertical p–n diodes. This method yields high-performance power devices in CMOS-compatible cleanrooms at a reduced cost. The GaN p–n junctions exhibit a specific on-resistance of 3.3 mΩ cm2, a current on/off ratio exceeding 1010, and a current density of 1.4 kA/cm2 at 10 V. Robust avalanche behavior was confirmed through temperature-dependent reverse bias measurements from 298 to 373 K, and over 3000 over-voltage surge ruggedness was demonstrated by unclamped inductive switching stress tests. These results underscore the advantages of localized epitaxy for achieving high-quality GaN layers on Si, paving the way for scalable integration of high-voltage GaN power devices with conventional Si technology.
- Open Access
- 7 November 2024
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 136 (17)
High breakdown voltages on pseudo-vertical p–n diodes by selective area growth of GaN on silicon
Selective area growth (SAG) of gallium nitride (GaN) on silicon (Si) wafers efficiently relaxes the tensile stress that is generated in the GaN layer, when the structure is cooled down to room temperature after the growth. Hence, SAG enables the growth of thicker layers that are capable of operating at higher voltages than those grown in 2D layers. In this study, two GaN layers are grown by SAG on 200 mm-diameter Si(111) wafers by metal organic vapor phase epitaxy for the fabrication of pseudo-vertical p–n diodes. During the growth, the SiH4 precursor flow for the first sample was double than that for the second one. The uniformity of the doping concentration of the layers is investigated by scanning spreading resistance microscopy and the p- and n-type doped regions are examined by scanning capacitance microscopy. A low net doping concentration of 1.4 × 1016 cm−3 is extracted from capacitance–voltage measurements and a destructive breakdown occurs at 700 V for a 90 μm-diameter pseudo-vertical p–n diode. These results show the high potential of the SAG of GaN on Si wafers for vertical power devices.
- 7 November 2024
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 136 (17)
Open AccessHigh breakdown voltages on pseudo-vertical p–n diodes by selective area growth of GaN on silicon
Selective area growth (SAG) of gallium nitride (GaN) on silicon (Si) wafers efficiently relaxes the tensile stress that is generated in the GaN layer, when the structure is cooled down to room temperature after the growth. Hence, SAG enables the growth of thicker layers that are capable of operating at higher voltages than those grown in 2D layers. In this study, two GaN layers are grown by SAG on 200 mm-diameter Si(111) wafers by metal organic vapor phase epitaxy for the fabrication of pseudo-vertical p–n diodes. During the growth, the SiH4 precursor flow for the first sample was double than that for the second one. The uniformity of the doping concentration of the layers is investigated by scanning spreading resistance microscopy and the p- and n-type doped regions are examined by scanning capacitance microscopy. A low net doping concentration of 1.4 × 1016 cm−3 is extracted from capacitance–voltage measurements and a destructive breakdown occurs at 700 V for a 90 μm-diameter pseudo-vertical p–n diode. These results show the high potential of the SAG of GaN on Si wafers for vertical power devices.