Yuhan Yang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Yuhan Yang has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Shaoqiong Yang
Key Laboratory of Mechanism Theory and Equipment Design of Ministry of Education, School of Mechanical Engineering, Tianjin University, Tianjin, China
2 shared publications - Tongshuai Sun
Tianjin University
2 shared publications Danmin Cai
School of Chemistry, South China Normal University, Guangzhou, 510006, China
1 shared publicationHaitong Zhao
Laoshan Laboratory , Qingdao , China
1 shared publication- Licai Zhu
School of Chemistry, South China Normal University, Guangzhou, 510006, China
1 shared publication Meiting Gao
School of Chemistry, South China Normal University, Guangzhou, 510006, China
1 shared publication
Latest Publications
- Open Access
- 1 March 2025
- Published by Walter de Gruyter GmbH in Polish Maritime Research
- Vol. 32 (1) , 121-128
Design, Analysis, and Testing of a Metamaterial Vibration Isolator for Hydrophone Equipped on Autonomous Underwater Vehicles
The acoustic detection performance of hydrophones on the acoustic characteristics of targets is highly sensitive to external vibrations and noise interference. With the limitations of volume within autonomous underwater vehicles (AUVs) and highly corrosive ocean environments, the design of an embedded vibration isolator (VI) is needed so as to protect the hydrophones equipped on AUVs. To effectively isolate the low-frequency vibration produced by actuators on the AUV, such as the thruster, rudder, etc., this paper designs a VI for a hydrophone equipped on the AUV by using a metamaterial with quasi-zero stiffness (QZS) characteristics. This VI contains circumferential vibration-damping units, which improve the overall vibration damping effect through integration with the radial multi-stage damping layers. As a result, by utilising harmonic response analysis, the conformal design of eight circumferential units and two radial layers is optimised across all designs; its maximum vibration transmissibility is 56 dB at 500 Hz. Finally, the effectiveness of the QZS VI is verified through an experiment, which also shows a good match with the trend of the simulation results. This work also provides theoretical guidance for further study on the optimisation of phononic crystal mechanisms for vibration damping.
- 1 March 2025
- Published by Walter de Gruyter GmbH in Polish Maritime Research
- Vol. 32 (1) , 121-128
Open AccessDesign, Analysis, and Testing of a Metamaterial Vibration Isolator for Hydrophone Equipped on Autonomous Underwater Vehicles
The acoustic detection performance of hydrophones on the acoustic characteristics of targets is highly sensitive to external vibrations and noise interference. With the limitations of volume within autonomous underwater vehicles (AUVs) and highly corrosive ocean environments, the design of an embedded vibration isolator (VI) is needed so as to protect the hydrophones equipped on AUVs. To effectively isolate the low-frequency vibration produced by actuators on the AUV, such as the thruster, rudder, etc., this paper designs a VI for a hydrophone equipped on the AUV by using a metamaterial with quasi-zero stiffness (QZS) characteristics. This VI contains circumferential vibration-damping units, which improve the overall vibration damping effect through integration with the radial multi-stage damping layers. As a result, by utilising harmonic response analysis, the conformal design of eight circumferential units and two radial layers is optimised across all designs; its maximum vibration transmissibility is 56 dB at 500 Hz. Finally, the effectiveness of the QZS VI is verified through an experiment, which also shows a good match with the trend of the simulation results. This work also provides theoretical guidance for further study on the optimisation of phononic crystal mechanisms for vibration damping.
- Open Access
- 19 November 2024
- Published by MDPI AG in Journal of Marine Science and Engineering
- Vol. 12 (11) , 2088
Study on the Vibration-Damping Mechanism of a New Phononic Crystal Suspension Equipped on Underwater Gliders
The vibration caused by the movement of internal actuating components within an acoustic underwater glider can interfere with onboard sensors. However, as a new vibration-damping material, phononic crystals can effectively reduce this impact. Using simulation and an underwater test, this work studied the vibration-damping mechanism of the phononic crystal suspension (PCS) designed by Tianjin University, China. The bandgaps and the modes of PCS were calculated first, which offered basic data for the following simulation. Then, the relationship between the modes and attenuation zones (AZs) were broadly considered to reveal the variation law of the AZs with the change in modes, both in the air and under water. Finally, an underwater test was carried out to verify the good vibration-damping effect of the PCS. The results show that the cutoff frequency of the AZs could be predicted by finding the relevant modes. The PCS showed a good vibration-damping effect from 170 Hz to 5000 Hz in the underwater test, with a maximum decrease of 6 dB at 2000 Hz. Finally, the damping of the PCS could suppress the overlap of modes that resulted from Bragg scattering. This work will also provide theoretical guidance for further study on the optimization of phononic crystal mechanisms for vibration damping.
- 19 November 2024
- Published by MDPI AG in Journal of Marine Science and Engineering
- Vol. 12 (11) , 2088
Open AccessStudy on the Vibration-Damping Mechanism of a New Phononic Crystal Suspension Equipped on Underwater Gliders
The vibration caused by the movement of internal actuating components within an acoustic underwater glider can interfere with onboard sensors. However, as a new vibration-damping material, phononic crystals can effectively reduce this impact. Using simulation and an underwater test, this work studied the vibration-damping mechanism of the phononic crystal suspension (PCS) designed by Tianjin University, China. The bandgaps and the modes of PCS were calculated first, which offered basic data for the following simulation. Then, the relationship between the modes and attenuation zones (AZs) were broadly considered to reveal the variation law of the AZs with the change in modes, both in the air and under water. Finally, an underwater test was carried out to verify the good vibration-damping effect of the PCS. The results show that the cutoff frequency of the AZs could be predicted by finding the relevant modes. The PCS showed a good vibration-damping effect from 170 Hz to 5000 Hz in the underwater test, with a maximum decrease of 6 dB at 2000 Hz. Finally, the damping of the PCS could suppress the overlap of modes that resulted from Bragg scattering. This work will also provide theoretical guidance for further study on the optimization of phononic crystal mechanisms for vibration damping.
- 12 March 2024
- Published by Elsevier in Journal of Power Sources
- Vol. 602, 234276
Scalable thick Ni-rich layered oxide cathode design for high energy/power balanced lithium-ion battery
- 12 March 2024
- Published by Elsevier in Journal of Power Sources
- Vol. 602, 234276
Scalable thick Ni-rich layered oxide cathode design for high energy/power balanced lithium-ion battery