Dhritti Tanprayoon
Dhritti Tanprayoon has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
- Bralee Chayasombat
National Metal and Materials Technology Center, National Science and Technology Development Agency, Khlong Luang, Pathum Thani, Thailand
2 shared publications Masahiro Tsukamoto
2 shared publications- Patcharapit Promoppatum
Affiliation Department of Mechanical Engineering, Faculty of Engineering, King Mongkut’s University of Technology Thonburi, Bangkok, Thailand
2 shared publications - Sasitorn Srisawadi
Department of Materials Science, and the Specialized Center of Rubber and Polymer Materials for Agriculture and Industry, CBLAST, Faculty of Science, Kasetsart University, Bangkok, Thailand
2 shared publications Boonyakorn Tummake
1 shared publicationBralee Chayasombat
1 shared publication
Latest Publications
- 5 December 2025
- Published by Elsevier in Optics & Laser Technology
- Vol. 194
Powder-based numerical study of melt pool behaviors for Inconel 718 with TiC reinforcement using laser powder bed fusion process
- 5 December 2025
- Published by Elsevier in Optics & Laser Technology
- Vol. 194
Powder-based numerical study of melt pool behaviors for Inconel 718 with TiC reinforcement using laser powder bed fusion process
- 23 October 2025
- Published by Elsevier in Composites Communications
- Vol. 60
Tailoring strain sensor performance via filler content in acetylene black/natural rubber composites
- 23 October 2025
- Published by Elsevier in Composites Communications
- Vol. 60
Tailoring strain sensor performance via filler content in acetylene black/natural rubber composites
- 1 November 2024
- Published by Laser Institute of America in Journal of Laser Applications
- Vol. 36 (4)
3D fabrication of nickel based alloys by powder bed fusion with blue diode laser
Nickel based alloy was fabricated by a laser powder bed fusion using the blue laser with the wavelength of 450 nm and maximum output power of 200 W, and the effect of volumetric energy density (VED), on the porosity was evaluated for fabricated samples. A fabricated sample using the blue diode laser, recorded a porosity of 0.012% at the VED of 33 J/mm3, indicating that it can be fabricated more efficiently than the sample fabricated using the near-infrared fiber laser. Furthermore, it was revealed that when the surface roughness of the fabricated sample reached 37.5 μm, large voids were generated, indicating a high likelihood of void formation at a surface roughness of approximately 40 μm or more during the layer-by-layer fabrication of nickel-based alloys using the blue diode laser in powder bed fusion.
- 1 November 2024
- Published by Laser Institute of America in Journal of Laser Applications
- Vol. 36 (4)
3D fabrication of nickel based alloys by powder bed fusion with blue diode laser
Nickel based alloy was fabricated by a laser powder bed fusion using the blue laser with the wavelength of 450 nm and maximum output power of 200 W, and the effect of volumetric energy density (VED), on the porosity was evaluated for fabricated samples. A fabricated sample using the blue diode laser, recorded a porosity of 0.012% at the VED of 33 J/mm3, indicating that it can be fabricated more efficiently than the sample fabricated using the near-infrared fiber laser. Furthermore, it was revealed that when the surface roughness of the fabricated sample reached 37.5 μm, large voids were generated, indicating a high likelihood of void formation at a surface roughness of approximately 40 μm or more during the layer-by-layer fabrication of nickel-based alloys using the blue diode laser in powder bed fusion.