Manju Tiwari
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Manju Tiwari has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
- Nameeta Brahme
Department of Physics and Astrophysics, SoS in Physics and Astrophysics Pandit Ravishankar Shukla University Raipur India
5 shared publications - Anil Kumar Choubey
S.O.S in Physics and Astrophysics , Pt. Ravishankar Shukla University , Raipur , India
2 shared publications - Durga Prasad Bisen
School of Studies in Physics and Astrophysics, Pt. Ravishankar Shukla University, Raipur, India
2 shared publications Nitish Tiwari
2 shared publications- Nitish Tiwari
Indira Gandhi Krishi Vishwavidyalaya
2 shared publications Pankaj Kumar
2 shared publications
Latest Publications
- 13 August 2025
- Published by Springer Nature in Journal of the Indian Society of Remote Sensing
- Vol. 54 (12) , 1-12
Weed Detection Using Deep Learning in Rice Crops Under Field Conditions
- 13 August 2025
- Published by Springer Nature in Journal of the Indian Society of Remote Sensing
- Vol. 54 (12) , 1-12
Weed Detection Using Deep Learning in Rice Crops Under Field Conditions
- Open Access
- 8 November 2024
- Published by Elsevier in The Egyptian Journal of Remote Sensing and Space Sciences
- Vol. 27 (4) , 734-742
Potential of temporal satellite data analysis for detection of weed infestation in rice crop
- 8 November 2024
- Published by Elsevier in The Egyptian Journal of Remote Sensing and Space Sciences
- Vol. 27 (4) , 734-742
Open AccessPotential of temporal satellite data analysis for detection of weed infestation in rice crop
- 1 January 2024
- Published by Diva Enterprises Private Limited in Indian Journal of Weed Science
- Vol. 56 (3) , 274-278
Studying effectiveness of post-emergence herbicides in chickpea
Broad spectrum post-emergence herbicides are being popular among the chickpea growers. However, systematic study is required to assess the effectiveness of these in comparison with popular pre-emergence herbicides and hence a field study was conducted at Indira Gandhi Krishi Vishwavidyalaya, Raipur in Alfisols during winter (Rabi) season of 2020-21 and 2021-22 to study the effect of pre-emergence and combination of pre- and post-emergence herbicides in chickpea (Cicer arietinum L.) with mechanical/hand weeding. The experiment was designed in randomized block design with three replications. Major weeds were Chenopodium album and Cichorium intybus. Echinochloa colona, Cynadon dactylon with almost 50% dominance ofMedicago denticulata. Among the chemical weed management treatments, the lowest count of the aforesaid individual and total weeds was registered under the treatment topramezone 25.28 g/ha as POST at 90 DAS. Topramezone 25.28 g/ha as PoE (18 DAS) reduced total weed density by 50% at 90 DAS when compared with weedy check and eventually had higher weed control efficiency in both the years (81.1 in 2020-21 and 83.8% in 2021-22) than the other treatments. Comparable lower weed count was also observed under the hand weeding at 30 DAS/Farmers practice. Although, slight phytotoxicity (3 to 5 out of 10 scale) in terms of yellowing, stunting and scorching was observed upto 14 days in topramezone 25.28 g/ha as PoE, propaquizafop+ imazethapyr 125 g/ha as POST and flauzifop-p-butyl + fomesafen 250 g/ha PoE, but these symptoms were entirely disappeared and chickpea has recovered and regained its growth later. Application of topramezone produced average 275% more seed yield over weedy check and 133% over pendimethalin 678 g/ha PE. It also generated the highest net return (Rs. 53290 and 54630/ha) and B:C ratio (3.35 and 3.33).
- 1 January 2024
- Published by Diva Enterprises Private Limited in Indian Journal of Weed Science
- Vol. 56 (3) , 274-278
Studying effectiveness of post-emergence herbicides in chickpea
Broad spectrum post-emergence herbicides are being popular among the chickpea growers. However, systematic study is required to assess the effectiveness of these in comparison with popular pre-emergence herbicides and hence a field study was conducted at Indira Gandhi Krishi Vishwavidyalaya, Raipur in Alfisols during winter (Rabi) season of 2020-21 and 2021-22 to study the effect of pre-emergence and combination of pre- and post-emergence herbicides in chickpea (Cicer arietinum L.) with mechanical/hand weeding. The experiment was designed in randomized block design with three replications. Major weeds were Chenopodium album and Cichorium intybus. Echinochloa colona, Cynadon dactylon with almost 50% dominance ofMedicago denticulata. Among the chemical weed management treatments, the lowest count of the aforesaid individual and total weeds was registered under the treatment topramezone 25.28 g/ha as POST at 90 DAS. Topramezone 25.28 g/ha as PoE (18 DAS) reduced total weed density by 50% at 90 DAS when compared with weedy check and eventually had higher weed control efficiency in both the years (81.1 in 2020-21 and 83.8% in 2021-22) than the other treatments. Comparable lower weed count was also observed under the hand weeding at 30 DAS/Farmers practice. Although, slight phytotoxicity (3 to 5 out of 10 scale) in terms of yellowing, stunting and scorching was observed upto 14 days in topramezone 25.28 g/ha as PoE, propaquizafop+ imazethapyr 125 g/ha as POST and flauzifop-p-butyl + fomesafen 250 g/ha PoE, but these symptoms were entirely disappeared and chickpea has recovered and regained its growth later. Application of topramezone produced average 275% more seed yield over weedy check and 133% over pendimethalin 678 g/ha PE. It also generated the highest net return (Rs. 53290 and 54630/ha) and B:C ratio (3.35 and 3.33).
- 29 May 2013
- Published by Springer Nature in Journal of Applied Spectroscopy
- Vol. 80 (2) , 305-307
Enhancing effect of hydrazine on chemiluminescence of luminol-H2O2 system
- 29 May 2013
- Published by Springer Nature in Journal of Applied Spectroscopy
- Vol. 80 (2) , 305-307
Enhancing effect of hydrazine on chemiluminescence of luminol-H2O2 system
- 1 February 2013
- Published by Elsevier in Solid-State Electronics
- Vol. 80, 63-66
Spin polarized hole transport in poly(2-methoxy, 5-(2-ethylhexyloxy)-1,4-phenylenevinylene)
- 1 February 2013
- Published by Elsevier in Solid-State Electronics
- Vol. 80, 63-66
Spin polarized hole transport in poly(2-methoxy, 5-(2-ethylhexyloxy)-1,4-phenylenevinylene)
- 26 March 2012
- Published by Taylor & Francis in Radiation Effects and Defects in Solids
- Vol. 167 (5) , 326-332
Mechanoluminescence and thermoluminescence of BaFCl:Sm2+and BaFBr:Sm2+crystals
The alkaline-earth fluorohalide crystals MFX, where M=Ca, Sr, Ba, Pb and X=Cl, Br, I, form an important class of materials crystallizing in the PbFCl-type tetragonal structure which is also called the matlockite structure. These compounds have long been of interest because of the various defect species which can be detected by spin resonance and associated techniques. The crystals were prepared by slow cooling of the melt of a stoichiometric mixture of BaF 2 and the corresponding chloride or bromide under 0.2 bar of ultrapure argon (5N5), often slightly fluorinated. We have studied the mechanoluminescence (ML) of BaFBr:Sm 2+ and BaFCl:Sm 2+ crystals. It is seen that after the impact of a moving piston, initially the ML intensity increases with time, attains a maximum value and then it decreases with time up to a particular minimum value, and then it increases again, attaining a peak value and finally disappears. The first peak lies in the deformation region and the second peak lies in the post-deformation region. The ML intensity of the BaFCl:Sm 2+ crystal is much higher than the ML intensity of the BaFBr:Sm 2+ crystal. For different impact velocities, the ML intensity increases with velocity; and the total ML intensity attains a saturation value for higher impact velocities. The total ML intensity increases with the increase in the applied load. It is suggested that the moving dislocation produced during deformation of crystals captures holes from hole-trapped centers (like H centers), and the subsequent radiative recombination of the dislocation holes with electron gives rise to ML. Thermoluminescence (TL) of BaFBr:Sm 2+ and BaFCl:Sm 2+ crystals was studied after exposure to ultraviolet rays with the help of a TLD reader. The peak of TL for the BaFBr:Sm 2+ crystal is found at ∼247°C and for BaFCl:Sm 2+ crystals at 283°C. The TL intensity initially increases with increase in the UV radiation and then it attains saturation for higher values of UV exposure. The absorption spectrum was recorded with the help of a UV–visible spectrophotometer (Shimadzu). The band found at 275 nm was attributed to H centers.
- 26 March 2012
- Published by Taylor & Francis in Radiation Effects and Defects in Solids
- Vol. 167 (5) , 326-332
Mechanoluminescence and thermoluminescence of BaFCl:Sm2+and BaFBr:Sm2+crystals
The alkaline-earth fluorohalide crystals MFX, where M=Ca, Sr, Ba, Pb and X=Cl, Br, I, form an important class of materials crystallizing in the PbFCl-type tetragonal structure which is also called the matlockite structure. These compounds have long been of interest because of the various defect species which can be detected by spin resonance and associated techniques. The crystals were prepared by slow cooling of the melt of a stoichiometric mixture of BaF 2 and the corresponding chloride or bromide under 0.2 bar of ultrapure argon (5N5), often slightly fluorinated. We have studied the mechanoluminescence (ML) of BaFBr:Sm 2+ and BaFCl:Sm 2+ crystals. It is seen that after the impact of a moving piston, initially the ML intensity increases with time, attains a maximum value and then it decreases with time up to a particular minimum value, and then it increases again, attaining a peak value and finally disappears. The first peak lies in the deformation region and the second peak lies in the post-deformation region. The ML intensity of the BaFCl:Sm 2+ crystal is much higher than the ML intensity of the BaFBr:Sm 2+ crystal. For different impact velocities, the ML intensity increases with velocity; and the total ML intensity attains a saturation value for higher impact velocities. The total ML intensity increases with the increase in the applied load. It is suggested that the moving dislocation produced during deformation of crystals captures holes from hole-trapped centers (like H centers), and the subsequent radiative recombination of the dislocation holes with electron gives rise to ML. Thermoluminescence (TL) of BaFBr:Sm 2+ and BaFCl:Sm 2+ crystals was studied after exposure to ultraviolet rays with the help of a TLD reader. The peak of TL for the BaFBr:Sm 2+ crystal is found at ∼247°C and for BaFCl:Sm 2+ crystals at 283°C. The TL intensity initially increases with increase in the UV radiation and then it attains saturation for higher values of UV exposure. The absorption spectrum was recorded with the help of a UV–visible spectrophotometer (Shimadzu). The band found at 275 nm was attributed to H centers.
- 20 May 2011
- Published by Springer Nature in Polymer Bulletin
- Vol. 67 (4) , 709-718
Improved efficiency of MEH-PPV:PCBM solar cells by the use of ZnS nano-particles
- 20 May 2011
- Published by Springer Nature in Polymer Bulletin
- Vol. 67 (4) , 709-718
Improved efficiency of MEH-PPV:PCBM solar cells by the use of ZnS nano-particles
- 1 May 2011
- Published by Elsevier in Journal of Luminescence
- Vol. 131 (5) , 965-969
Mechanoluminescence by impulsive deformation of γ-irradiated Er-doped CaF2 crystals
- 1 May 2011
- Published by Elsevier in Journal of Luminescence
- Vol. 131 (5) , 965-969
Mechanoluminescence by impulsive deformation of γ-irradiated Er-doped CaF2 crystals