Batuhan Yuruk
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Batuhan Yuruk has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Bedri Karaismailoglu
Department of Anatomy, Institute of Graduate Studies, Istanbul University–Cerrahpasa, 34320 Istanbul, Türkiye
1 shared publication - Cemil Cihad Gedik
Department of Orthopaedics and Traumatology, Koç University School of Medicine, Istanbul, Türkiye
1 shared publication - Emrah Caliskan
Department of Orthopaedics and Traumatology, Faculty of Medicine, Koç University, Istanbul 34450, Turkey
1 shared publication Hakan Özben
Istanbul American Hospital, Istanbul, Türkiye
1 shared publicationIlker Eren
Department of Orthopaedics and Traumatology, Koç University School of Medicine, Istanbul, Türkiye
1 shared publication- Ilker Eren
Department of Orthopaedics and Traumatology, Koç University School of Medicine, Istanbul, Türkiye
1 shared publication
Latest Publications
- Open Access
- 31 December 2025
- Published by AVES YAYINCILIK A.Ş. in Acta Orthopaedica et Traumatologica Turcica
- Vol. 59 (6) , 361-367
In silico assessment of talus osteochondral lesion size and location on biomechanical load distribution using tilted talar dome planes
Objective: This study aimed to computationally evaluate the effects of lesions of varying sizes and locations on stress distribution and ankle stiffness across the nine-zone grid of the talar dome in three different ankle positions. Methods: An adult ankle geometry was modeled with 1 mm of cartilage on both sides of the tibiotalar contact. Lesions with diameters of 4.5, 6.4, and 9 mm were created on the talar dome at each grid partition, ranging from section 1 (anteromedial) to 9 (posterolateral). Thekey innovation of the study was the use of tilted talar planes to account for the dome’s curvature, enabling more accurate lesion model ing and biomechanical analysis. Percent changes in osteochondral von Mises stress distribution and ankle stiffness parameters were investigated using finite element analysis. Based on the designated design parameters, 81 different cases were modeled and simulated. Results: Zones 7 (posteromedial, −33.2% change in stiffness for a 9 mm defect), 3 (anterolateral, −24.2% change in stiffness for a 9 mmdefect), and 8 (mid-posterior, −48.8% change in stiffness for a 9 mm defect) were found to be the most critical zones, showing evidence of decreased ankle stiffness in neutral, dorsiflexion, and plantarflexion positions, respectively. Zone 9 (posterolateral; neutral −4.7%, dorsi f lexion 5.4%, plantarflexion 0.17% stiffness change for a 9 mm defect) was found to be the least critical zone in terms of biomechanical stiffness. Conclusion: From a clinical standpoint, since lesions in zones 8, 7, and 3 significantly impact joint biomechanics compared to other zones, more aggressive cartilage restoration or augmentation could be required while lesions in less problematic zones like zone 9 can be treated withmicrofracture surgery. Cite this article as: Aslan L, Subasi O, Karaismailoglu B, et al. In silico assessment of talus osteochondral lesion size and location on biomechanical load distribution using tilted talar dome planes. Acta Orthop Traumatol Turc., 2025;59(6):361-367.
- 31 December 2025
- Published by AVES YAYINCILIK A.Ş. in Acta Orthopaedica et Traumatologica Turcica
- Vol. 59 (6) , 361-367
Open AccessIn silico assessment of talus osteochondral lesion size and location on biomechanical load distribution using tilted talar dome planes
Objective: This study aimed to computationally evaluate the effects of lesions of varying sizes and locations on stress distribution and ankle stiffness across the nine-zone grid of the talar dome in three different ankle positions. Methods: An adult ankle geometry was modeled with 1 mm of cartilage on both sides of the tibiotalar contact. Lesions with diameters of 4.5, 6.4, and 9 mm were created on the talar dome at each grid partition, ranging from section 1 (anteromedial) to 9 (posterolateral). Thekey innovation of the study was the use of tilted talar planes to account for the dome’s curvature, enabling more accurate lesion model ing and biomechanical analysis. Percent changes in osteochondral von Mises stress distribution and ankle stiffness parameters were investigated using finite element analysis. Based on the designated design parameters, 81 different cases were modeled and simulated. Results: Zones 7 (posteromedial, −33.2% change in stiffness for a 9 mm defect), 3 (anterolateral, −24.2% change in stiffness for a 9 mmdefect), and 8 (mid-posterior, −48.8% change in stiffness for a 9 mm defect) were found to be the most critical zones, showing evidence of decreased ankle stiffness in neutral, dorsiflexion, and plantarflexion positions, respectively. Zone 9 (posterolateral; neutral −4.7%, dorsi f lexion 5.4%, plantarflexion 0.17% stiffness change for a 9 mm defect) was found to be the least critical zone in terms of biomechanical stiffness. Conclusion: From a clinical standpoint, since lesions in zones 8, 7, and 3 significantly impact joint biomechanics compared to other zones, more aggressive cartilage restoration or augmentation could be required while lesions in less problematic zones like zone 9 can be treated withmicrofracture surgery. Cite this article as: Aslan L, Subasi O, Karaismailoglu B, et al. In silico assessment of talus osteochondral lesion size and location on biomechanical load distribution using tilted talar dome planes. Acta Orthop Traumatol Turc., 2025;59(6):361-367.
- Open Access
- 5 January 2024
- Published by AVES YAYINCILIK A.Ş. in Acta Orthopaedica et Traumatologica Turcica
- Vol. 58 (5) , 263-268
The impact of acromial morphology on the localization and size of calcific tendonitis in the rotator cuff
Objective: This study aimed to investigate the association between acromial morphology and the incidence and extent of calcific tendonitis. Methods: Ninety-two patients (33 male, 59 female; mean age: 47 ± 9.7) with calcific tendonitis were included in this retrospective study. Critical shoulder angle (CSA), slope angle, lateral acromial angle (LAA), acromion index (AI), acromial type according to Bigliani, and the morphology of the calcific deposits according to Gartner and Heyer were assessed on x-rays. The localization and volume of the calcific deposits were assessed using magnetic resonance imaging (MRI). Patients were divided into 2 groups: CSA < 33° (group 1) and CSA ≥ 33° (group 2). Results: The median CSA was 33.5° (range=23°-51°), lateral acromial angle (LAA) was 83.6° (range=60°-106°), acromial index (AI) was 0.7 (range=0.4-0.9), and slope angle was 24.1° (range=3°-40°). Lateral acromial angle (P=.000) and AI (P=.000) were statistically different between the 2 groups. Critical shoulder angle was correlated with LAA (P=.000) and AI (P=.000); deposit volumes were correlated with slope angle (P=.001), Bigliani type of the acromion (P=.009), and deposit stage according to Gartner and Heyer (P=.004). There was a correlation between deposit localization and its volume; the size of the deposit increased anteriorly (P=.000). Conclusion: This study has shown that CSA failed to quantify a patient’s predisposition to calcific tendonitis. However, the findings demonstrate a relationship between the morphological parameters in the sagittal plane, such as acromial slope and deposit volume, which deserve further research. Level of Evidence: Level III, Prognostic Study. Cite this article as: Birsel O, Çalışkan E, Eren İ, Yürük B, Özben H, Demirhan M. The impact of acromial morphology on the localization and size of calcific tendonitis in the rotator cuff. Acta Orthop Traumatol Turc., 2024;58(5):263-268.
- 5 January 2024
- Published by AVES YAYINCILIK A.Ş. in Acta Orthopaedica et Traumatologica Turcica
- Vol. 58 (5) , 263-268
Open AccessThe impact of acromial morphology on the localization and size of calcific tendonitis in the rotator cuff
Objective: This study aimed to investigate the association between acromial morphology and the incidence and extent of calcific tendonitis. Methods: Ninety-two patients (33 male, 59 female; mean age: 47 ± 9.7) with calcific tendonitis were included in this retrospective study. Critical shoulder angle (CSA), slope angle, lateral acromial angle (LAA), acromion index (AI), acromial type according to Bigliani, and the morphology of the calcific deposits according to Gartner and Heyer were assessed on x-rays. The localization and volume of the calcific deposits were assessed using magnetic resonance imaging (MRI). Patients were divided into 2 groups: CSA < 33° (group 1) and CSA ≥ 33° (group 2). Results: The median CSA was 33.5° (range=23°-51°), lateral acromial angle (LAA) was 83.6° (range=60°-106°), acromial index (AI) was 0.7 (range=0.4-0.9), and slope angle was 24.1° (range=3°-40°). Lateral acromial angle (P=.000) and AI (P=.000) were statistically different between the 2 groups. Critical shoulder angle was correlated with LAA (P=.000) and AI (P=.000); deposit volumes were correlated with slope angle (P=.001), Bigliani type of the acromion (P=.009), and deposit stage according to Gartner and Heyer (P=.004). There was a correlation between deposit localization and its volume; the size of the deposit increased anteriorly (P=.000). Conclusion: This study has shown that CSA failed to quantify a patient’s predisposition to calcific tendonitis. However, the findings demonstrate a relationship between the morphological parameters in the sagittal plane, such as acromial slope and deposit volume, which deserve further research. Level of Evidence: Level III, Prognostic Study. Cite this article as: Birsel O, Çalışkan E, Eren İ, Yürük B, Özben H, Demirhan M. The impact of acromial morphology on the localization and size of calcific tendonitis in the rotator cuff. Acta Orthop Traumatol Turc., 2024;58(5):263-268.