Tam Atkins
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Tam Atkins has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
John Beltrame
The University of Adelaide
2 shared publicationsMaziar Arjomandi
The University of Adelaide
2 shared publications- Maziar Arjomandi
School of Electrical and Mechanical Engineering, The University of Adelaide, South Australia 5005, Australia
2 shared publications Navid Freidoonimehr
Queensland University of Technology
2 shared publications- Navid Freidoonimehr
School of Mechanical, Medical and Process Engineering, Queensland University of Technology 1 , Brisbane, QLD 4000
2 shared publications Chris Zeitz
The University of Adelaide
1 shared publication
Latest Publications
- 12 August 2026
- Published by Springer Nature
- p. 56-67
The Effect of Elevated Microvascular Resistance on Resting Indices in Stenosed Arteries
- 12 August 2026
- Published by Springer Nature
- p. 56-67
The Effect of Elevated Microvascular Resistance on Resting Indices in Stenosed Arteries
- Open Access
- 17 April 2025
- Published by Elsevier in Journal of Biomechanics
- Vol. 185, 112707
Evaluating the severity of tandem coronary stenoses: Insights from simulated FFR and iFR techniques
- 17 April 2025
- Published by Elsevier in Journal of Biomechanics
- Vol. 185, 112707
Open AccessEvaluating the severity of tandem coronary stenoses: Insights from simulated FFR and iFR techniques
- Open Access
- 30 September 2024
- Published by Elsevier in Journal of Biomechanics
- Vol. 176, 112353
The impact of the microvascular resistance on the measures of stenosis severity
- 30 September 2024
- Published by Elsevier in Journal of Biomechanics
- Vol. 176, 112353
Open AccessThe impact of the microvascular resistance on the measures of stenosis severity
- Open Access
The impact of the microvascular resistance on the measures of stenosis severity
The relationship between measures of stenosis and microvascular resistance is of importance due to medical decisions being based on these values. This research investigates the impact of varying microvascular resistance on fractional flow reserve (FFR) and hyperaemic stenosis resistance (hSR). Microvascular resistance is classified using hyperaemic microvascular resistance (hMR). Additionally, hMR using the upstream pressure value (hMRPa) has also been calculated and is compared to hMR measured conventionally. Tests were conducted at three different degrees of stenosis (quantified by percent area) in a coronary flow circuit with varying downstream resistance to simulate the microvasculature. Pressure and flow values are recorded across the stenosed section, allowing for calculation of the diagnostic indexes. Results indicate that for a constant degree of stenosis, FFR would increase with increasing microvascular resistance while hSR would remain almost constant. hMRPa was found to approach hMR as the stenosis severity decreased, and the pressure gradient decreased. In the results shown here, with sufficiently high downstream resistance, an 84% stenosis could produce an FFR value over 0.8. This result suggests that there is the potential for misdiagnosis of the severity of stenosis when combined with elevated microvascular resistance. Consequently, decisions on the clinical significance of a stenosis, classified by FFR, need to consider the effect of the microvascular resistance.
Open AccessThe impact of the microvascular resistance on the measures of stenosis severity
The relationship between measures of stenosis and microvascular resistance is of importance due to medical decisions being based on these values. This research investigates the impact of varying microvascular resistance on fractional flow reserve (FFR) and hyperaemic stenosis resistance (hSR). Microvascular resistance is classified using hyperaemic microvascular resistance (hMR). Additionally, hMR using the upstream pressure value (hMRPa) has also been calculated and is compared to hMR measured conventionally. Tests were conducted at three different degrees of stenosis (quantified by percent area) in a coronary flow circuit with varying downstream resistance to simulate the microvasculature. Pressure and flow values are recorded across the stenosed section, allowing for calculation of the diagnostic indexes. Results indicate that for a constant degree of stenosis, FFR would increase with increasing microvascular resistance while hSR would remain almost constant. hMRPa was found to approach hMR as the stenosis severity decreased, and the pressure gradient decreased. In the results shown here, with sufficiently high downstream resistance, an 84% stenosis could produce an FFR value over 0.8. This result suggests that there is the potential for misdiagnosis of the severity of stenosis when combined with elevated microvascular resistance. Consequently, decisions on the clinical significance of a stenosis, classified by FFR, need to consider the effect of the microvascular resistance.