Testuo Abe
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Testuo Abe has a total of 218 co-authors. Here are the top co-authors by number of shared publications:
- K. Miyabayashi
The Belle II Collaboration)
2 shared publications - Kenta Uno
High Energy Accelerator Research Organization (KEK)
2 shared publications - Shinji Terui
High Energy Accelerator Research Organization (KEK)
2 shared publications T. Iijima
2 shared publications- A. Bondar
Budker Institute of Nuclear Physics
1 shared publication A. Chen
Budker Institute of Nuclear Physics, Novosibirsk, Russia
1 shared publication
Latest Publications
- Open Access
- 15 September 2026
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 29 (9) , 093501
Investigation of sudden beam loss at SuperKEKB
In SuperKEKB, mitigation of sudden beam losses (SBLs) is essential to improve the luminosity. SBL refers to the rapid loss of a substantial portion of the stored beam current within a few revolutions. During SuperKEKB operation from 2019 to 2024, over 200 SBL events were observed, in which a beam abort with 5%–40% beam loss occurred within 2–3 turns, making high beam current operation difficult. The frequency of SBLs was very high, especially in the low-energy ring (LER). The occurrence of SBLs was highly concentrated during beam-current upgrade phases, presenting a severe operational bottleneck. While SBLs were rare during stable operations at lower currents, the frequency escalated to more than five events per day when operating at higher beam currents. These frequent events triggered intense beam losses, resulting in 11 quenches of the final-focus superconducting quadrupole magnets (QCS) within a period of less than three weeks in December 2024. Furthermore, SBL events could damage the collimator heads and the Belle II detector, causing devastating impacts on operation. SBLs occurred under both noncollisional and collisional conditions, but only under circumstances involving a small beam size at the interaction point and a high beam current. Most SBL events were accompanied by vacuum pressure bursts, primarily in the wiggler section of the LER, and an increase in beam size was also observed during these events. To investigate this phenomenon, SBL was artificially reproduced during beam operation and subsequently discharging the clearing electrodes. Inspecting the wiggler beam pipe, we found black stains, and removal of these stains led to a significant reduction in the frequency of SBLs. The black stains we discovered were identified as degraded vacuum sealant through observations using synchrotron radiation. This paper reports the results of an artificial reproduction test of the SBL phenomenon (knocking on the beam pipe, discharge inside the beam pipe), and an investigation of these black stains, including their composition and formation mechanism.
- 15 September 2026
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 29 (9) , 093501
Open AccessInvestigation of sudden beam loss at SuperKEKB
In SuperKEKB, mitigation of sudden beam losses (SBLs) is essential to improve the luminosity. SBL refers to the rapid loss of a substantial portion of the stored beam current within a few revolutions. During SuperKEKB operation from 2019 to 2024, over 200 SBL events were observed, in which a beam abort with 5%–40% beam loss occurred within 2–3 turns, making high beam current operation difficult. The frequency of SBLs was very high, especially in the low-energy ring (LER). The occurrence of SBLs was highly concentrated during beam-current upgrade phases, presenting a severe operational bottleneck. While SBLs were rare during stable operations at lower currents, the frequency escalated to more than five events per day when operating at higher beam currents. These frequent events triggered intense beam losses, resulting in 11 quenches of the final-focus superconducting quadrupole magnets (QCS) within a period of less than three weeks in December 2024. Furthermore, SBL events could damage the collimator heads and the Belle II detector, causing devastating impacts on operation. SBLs occurred under both noncollisional and collisional conditions, but only under circumstances involving a small beam size at the interaction point and a high beam current. Most SBL events were accompanied by vacuum pressure bursts, primarily in the wiggler section of the LER, and an increase in beam size was also observed during these events. To investigate this phenomenon, SBL was artificially reproduced during beam operation and subsequently discharging the clearing electrodes. Inspecting the wiggler beam pipe, we found black stains, and removal of these stains led to a significant reduction in the frequency of SBLs. The black stains we discovered were identified as degraded vacuum sealant through observations using synchrotron radiation. This paper reports the results of an artificial reproduction test of the SBL phenomenon (knocking on the beam pipe, discharge inside the beam pipe), and an investigation of these black stains, including their composition and formation mechanism.
- 25 October 2005
- Published by Elsevier in Physics Letters B
- Vol. 632 (1) , 51-57
Search for lepton and baryon number violating τ− decays into Λ¯π− and Λπ−
- 25 October 2005
- Published by Elsevier in Physics Letters B
- Vol. 632 (1) , 51-57
Search for lepton and baryon number violating τ− decays into Λ¯π− and Λπ−